The Toast & Melt™ Sandwich Press

the Toast & Melt™ Sandwich Press Instruction Book - BSG520/BSG540 save for future reference. Contents • Remove and safely discard any packaging material and promotional stickers before 2 Breville Recommends Safety First using the sandwich press for 6 Components the first time. 7 Functions 8 Tips • To eliminate a choking 9 Care & Cleaning hazard for young children, remove and safely discard the protective cover fitted BREVILLE to the power plug of this RECOMMENDS appliance. SAFETY FIRST • Do not place the sandwich press near the edge of At Breville we are very safety a bench or table during conscious. We design and manufacture consumer operation. Ensure that the products with the safety of you, surface is level, clean and our valued customer, foremost free of water. in mind. In addition we ask • Keep the sandwich press that you exercise a degree of clear of walls, curtains and care when using any electrical other heat or steam sensitive appliance and adhere to the following precautions. materials. • The sandwich press must be IMPORTANT used on a properly grounded SAFEGUARDS outlet. If you are not sure if the power outlets are READ ALL properly grounded, please INSTRUCTIONS BEFORE consult your electricians. USE AND SAVE FOR • Do not, under any FUTURE REFERENCE circumstances, modify • Carefully read all the power plug or use an instructions before adapter. operating the sandwich • Do not place the sandwich press for the first time and press on or near a hot gas or 2 electric burner, or where it clear from the housing. could touch a heated oven. • The sandwich press is Use the sandwich press well not suitable to be used away from walls. in a small appliance • Provide adequate space enclosure. Ensure to above and on all sides for leave adequate space all air circulation around the around the sandwich press. sandwich press. Minimum space of 10cm is • Do not place the sandwich recommended. press on any surface that • Do not place anything on may be affected by heat. top of the sandwich press The use of a heat resistant when the lid is closed, when matt is recommended on in use and when stored. these surfaces. • Always switch the sandwich • Do not use on a sink press off at the power outlet, drain board. then unplug the power • Always use the sandwich cord and to allow to cool, press on a dry, level surface. if appliance is not in use, • Do not touch hot surfaces. before cleaning, before Use the handles to lift attempting to move the and open the top plate. appliance, disassembling, Take care when using the assembling and when Adjustable Grilling Height storing the appliance. Control. • Do not use harsh abrasives, • Do not leave the sandwich caustic cleaners or oven press unattended when cleaners when cleaning the in use. sandwich press. • The outer housing of the • Keep the exterior housing sandwich press may be hot and the non-stick cooking during and after use. Please plates clean. Follow the do not touch hot surfaces. cleaning instructions Always keep the power cord provided in this book. Refer of this products, and those to Care, Cleaning and of other appliances nearby, Storage (Page 9). 3 • This appliance is not appliance. To avoid a intended to be operated by hazard do not use the means of an external timer appliance if power cord, or separate remote control power plug or appliance system. becomes damaged in any way. Return the entire IMPORTANT appliance to the nearest SAFEGUARDS FOR authorised Breville Service ALL ELECTRICAL Centre for examination and/or repair. APPLIANCES • The appliance is not • Fully unwind the power intended for use by persons cord before use. (including children) with • Connect only to a 230V or reduced physical, sensory 240V power outlet. or mental capabilities, • Do not let the power cord or lack of experience hang over the edge of a and knowledge, unless bench or table, touch hot they have been given surfaces or become knotted. supervision or instruction concerning use of the • To protect against electric appliance by a person shock, do not immerse the responsible for their safety. power cord, power plug or appliance in water or • Any maintenance other any other liquid or allow than cleaning should be moisture to come in contact performed at an authorised with the part, unless it Breville Service Centre. is recommended in the • This appliance is for cleaning instructions. household use only. Do • Children should be not use this appliance supervised to ensure that for anything other than they do not play with the its intended use. Do not appliance. use in moving vehicles or • It is recommended to boats. Do not use outdoors. regularly inspect the Misuse may cause injury. 4 IMPORTANT • Always turn the appliance to the off position, switch Fully unwind the power off at the power outlet and cord from the cord storage unplug at the power outlet facility before use. when the appliance is not • The installation of a in use. residual current device • Before cleaning, always (safety switch) is turn the appliance to the recommended to provide off position, switch off at additional safety protection the power outlet, unplug when using electrical at the power outlet and appliances. It is advisable remove the power cord, that a safety switch with a if detachable, from the rated residual operating appliance and allow all current not exceeding parts to cool. 30mA be installed in the • Do not place this appliance electrical circuit supplying on or near a heat source, the appliance. See your such as hot plate, oven or electrician for professional heaters. advice. • Position the appliance at • During electrical storms, a minimum distance of the appliance should be 20cm away from walls, disconnected from the curtains and other heat or power source at the wall steam sensitive materials socket to prevent any and provide adequate space electrical surges that may above and on all sides for arise during the storm and air circulation. which may inadvertently cause damage to the appliance and its electronic componentry. FOR HOUSEHOLD USE ONLY SAVE THESE INSTRUCTIONS 5 Components

B

E A

F

C

G

D H I

A. 2200W of power (BSG540) E. ‘Power’ and ‘Ready’ lights 2000W of power (BSG520) Indicate when the sandwich press is For fast heat up and quick toasting. heating or ready to use. B. Heavy duty die-cast arms F. Adjustable height control clip For durability and strength. With 4 settings for making open sandwich C. Floating top plate melts, toasted sandwiches and everything Automatically adjusts to thick or in between. thin sandwiches. G. Safety locking storage clip D. Flat non-stick cooking plates To lock plates closed for upright storage. For extra crispy toasted results. H. Non-slip feet I. Convenient cord wrap in base

6 5. Toasting should take approximately 5–8 minutes. Exact toasting time will be a Functions matter of taste. It will also depend on the type of bread and type of filling used. 6. When the sandwich is cooked, use the BEFORE FIRST USE handle to open the sandwich press and raise the top cooking plate. Remove sandwich Remove any promotional materials and with the help of a plastic or wooden spatula. packaging materials before use. Check that the Never use metal tongs or a knife as these cooking plates are clean and free of dust. can cause damage to the non-stick coating. If necessary, wipe over with a damp cloth. When using the sandwich press for the first time you may notice a fine smoke haze. NOTE This is caused by the heating of some of the • Always allow the sandwich press to pre-heat components. There is no need for concern. until the green ‘READY’ light illuminates. • The safety locking storage clip should not be TOASTED SANDWICH used to clamp down the top cooking plate 1. Insert the power plug into a 230V or 240V when the sandwiches are in the sandwich power outlet and then turn the power ON. press. The weight of the top cooking plate The red ‘POWER’ light will illuminate. will gradually press down the sandwich 2. Allow the sandwich press to pre-heat with during the cooking process. the top cooking plate in the closed position • When using the sandwich press for the until the green ‘READY’ light illuminates. first time you may notice a fine smoke haze. 3. During this time, prepare the sandwich. This is caused by the heating of some of the When the sandwich press has pre-heated, components. There is no need for concern. place the sandwich onto the bottom cooking plate. Always place sandwiches towards the rear of the bottom cooking plate. CAUTION 4. Close the top cooking plate. The top HOT SURFACE - The temperature of cooking plate has a floating hinge that accessible surfaces may be high when the is designed to evenly press down on the appliance is operating and for some time sandwich (see Fig 1). after use.

Fully unwind the cord from the cord storage facility before use.

Your sandwich press features an Adjustable Height Control feature which allows you to fix the top plate to a range of positions above the bottom plate. This allows your sandwich press to be used as an open toaster ideal for toasting open sandwich melts. It can also be used for toasting sandwiches where you don’t need to apply the weight of the top plate.

Fig. 1

7 OPEN SANDWICH MELTS NOTE 1. Allow the sandwich press to pre-heat until the green ‘READY’ light illuminates. The Adjustable Height Control can be moved to accommodate thick or thin melts by sliding 2. Place sandwich to be melted on the clip forwards or backwards along the arm. bottom plate. 3. Move the Adjustable Height Control clip on the right hand side of the sandwich press to the desired height (see Fig 2). Tips 4. Slowly lower the top plate until it rests on the Adjustable Height Control clip. 5. The top plate will radiate the desired heat to BREAD melt ingredients such as cheese. 6. Toasting melts should take approximately Most types of bread can be used; white, 3–4 minutes. However exact toasting time wholemeal, kibbled wheat, wholegrain, raisin will be a matter of taste. It will also depend loaf and so on. The sandwich press is ideal for on the height of the top plate. toasting foccacia, Turkish bread, baguettes as well as bread rolls. Raisin bread, brioche or other sweet breads which contain a high sugar Adjustable Height Control content will tend to brown quicker. Toasts or melts any bread thickness in minutes. FILLINGS Try to use canned or pre-cooked fruit as fresh fruit may give off excessive juices when heated. Be careful when biting into sandwiches containing fillings such as cheese and tomato or jam as they retain heat and can burn if eaten too quickly.

TOASTING BREAD The unique flat plate design makes the sandwich press ideal for toasting plain breads, Fig. 2 and Turkish bread, without any fillings or spreads. Try toasting Turkish Bread with jams for a great alternative to standard breads at breakfast.

FAT FREE SNACKS Due to the non-stick flat plate design, it is not necessary to use any butter or margarine on the outside of your toasted snacks.

Fig. 3

8 4. Wrap the power cord in the cord storage area below the appliance (see Fig 5). Care & Cleaning

Before cleaning, switch the power off at the power outlet and then remove the power plug. Allow your sandwich press to cool before cleaning. The appliance is easier to clean when slightly warm. Always clean your sandwich press after each use to prevent a build up of baked-on foods. Wipe cooking plates with a soft cloth. If cooked on food is not removed by this method reheat the unit for 1–2 minutes, then brush with a little oil or melted butter. Allow to stand for five Fig.5 minutes then wipe with a damp cloth. 5. Store on a flat, dry, level surface. NOTE • The cooking plates are coated with a NOTE non-stick surface, do not use abrasives. The storage clip should not be used to clamp • Do not use spray-on non-stick coatings as down the top plate when sandwiches are in this will affect the performance of the the sandwich press. non-stick surface on the cooking plates.

STORAGE WARNING To store your sandwich press: Do not immerse any part of the sandwich press 1. Switch off at power outlet and unplug power in water or any other liquid. cord from the wall. 2. Allow the sandwich press to fully cool. 3. Slide the Adjustable Height Control towards the front handle to the ‘LOCK’ position so that the top and bottom cooking plates are locked together (see Fig 4).

Fig. 4

9 Notes

10 Notes

11 Breville Customer Service Centre

Australian Customers New Zealand Customers Phone: 1300 139 798 Phone: 0800 273 845 Web: www.breville.com Web: www.breville.com

Breville, the Breville logo, Master Every Moment and the Toast & Melt are registered trademarks of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2019. Due to continued product improvement, the products illustrated/photographed in this brochure may vary slightly from the actual product.

BSG520/BSG540 ANZ – G19