Description Purpose and application The TOUCH DIM LS LI sensor regulates the brightness at the workplace and in office areas to increase the working comfort and to save energy. TOUCH DIM LS LI The sensor can be installed in luminaires (e.g. floor standing luminaires) or in false ceilings.
Function The sensor measures the brightness in the area to be regulated and keeps this to an adjustable set value by introducing artificial light according to the amount of daylight available. A B As the amount of daylight increases, artificial lighting is reduced.
Design The sensor is made up of the following components: • Light sensor (A) • Housing (B) • Connections (C) for signal line, neutral conductor and phase
Light sensor Operating instructions C
Operation Symbols Pushbutton on Luminaire on the luminaire
Switch on Luminaire off
Luminaire Switch off flashes Short press Brightness with (< 0.5 s) automat. control Long press Confirmation of (0.5 – 4 s) the setting
Double-click Manual dimming
2x
1 < 30 s 2 3
Switching luminaire on and off 2x Via short press. 1 < 30 s 2 3 A Note: The luminaire is first switched on with minimum bright- max ness. If a setpoint is predefined for brightness control, the brightness is controlled automatically. 1 2 3 B ...
A
max Changing the brightness manually Via long press. 1 2 3 B ... Note: The brightness control is deactivated until the next time > 30 s 1 2 3 the luminaire is switched on. Each repeated long key button press causes a toggle between increased brightness and decreased brightness.
1 > 30 s 2 3 Specifying set value for brightness control Specifying the set value activates the brightness control. Set the desired brightness. 2x Double-click 1 < 30 s 2 3 Confirmation: luminaire flashes.
VI 2010 2x TouchDIM-LS-LI_ba1006en_we1.02.indd 1 < 30 s 2 3 OSRAM GmbH Kunden Service Center Customer-Service-Center (CSC) A Steinerne Furt 62 max Deactivating brightness control 86167 Augsburg Switch off if necessary. Germany 1 2 3 A B Double-click ... Tel : +49 (0) 1803 677 - 200 max (kostenpflichtig / charges apply) Confirmation: maximum brightness. Fax.: +49 (0) 1803 677 - 202 1 2 3 www.osram.com B ... www.osram.de 40083210230250 1 > 30 s 2 3 4008321023025 Page 1 of 2 1 > 30 s 2 3 Operation (cont.) Troubleshooting If you cannot remedy the fault, please contact the Customer Service department of the luminaire manufacturer.
Luminaire does not function No mains voltage. à Use a voltage tester to check for mains voltage. Illuminant is faulty. à Replace the illuminant. The luminaire was switched off via the pushbutton. à Switch on the luminaire. The sensor is exposed to excessive amounts of ambient light. à Hold the sensor closed and observe the behaviour of the luminaire.
Brightness is not adjusted to the selected set value The pushbutton was not pressed within 30 seconds after the setpoint was adjusted à Double-click within 30 seconds after dimming manually. Brightness control was not started until 5 seconds after the setpoint was adjusted. à Wait for the delay period to elapse. Brightness control was deactivated by a manual operation. à Switch the luminaire off and on again. No setpoint was saved. à Save a new setpoint.
Luminaire does not react as expected to the press of a button The pushbutton was pressed too long or too short. à See Changing the brightness manually.
Appendix The EMC requirements to EN 61547 are fulfilled. Conformity with the relevant EU directives is confirmed by the CE symbol.
Page 2 of 2