GETTING TO KNOW YOUR TELSTRA PRE-PAID 3G USB + WI-FI

FOR MORE INFORMATION CALL 125 8880 or FROM A NON-TELSTRA PHONE, CALL 13 2200 AND SAY “PRE-PAID” VISIT telstra.com/ppmbb VISIT A TELSTRA STORE OR PARTNER LET’S GET THIS SHOW WHAT’S ON THE ROAD INSIDE

You must be excited about your brand new Telstra Pre-Paid 03 Safety first 3G USB + Wi-Fi. 06 Let’s get started This guide will help you get connected as quickly and as 09 Your Telstra Pre-Paid 3G USB + Wi-Fi easily as possible. It’ll guide you through installation and 11 Getting connected run through all the handy extra features that are included. 16 Extra features If all goes to plan you’ll be up and running in no time, 18 Wi-Fi home page so you can get connected whilst on the move. 20 Problem solving 23 Extra bits you should know

2 SAFETY FIRST

Please read all the safety notices before using this device. reduces when there is good quality reception. Maximum power is only used at the edge of network coverage so under This device is designed to be used at least 20 cm from most circumstances the power output is very low. Under poor your body. Do not use the device near fuel or chemicals or network conditions the device transmits at a higher power, in any prescribed area such as service stations, refineries, may get hot and have a significantly shorter battery life. hospitals and aircraft. Obey all warning signs where posted. DECLARATION OF CONFORMITY – RADIO FREQUENCY SAFETY INFORMATION SPECIFIC ABSORPTION RATE (SAR) The device has an internal antenna. For optimum The wireless device is designed to be used at least 20 cm performance with minimum power consumption do not shield from the body. We declare that the product detailed in the device or cover with any object. Covering the antenna this manual, and in combination with our accessories, affects signal quality, may cause the router to operate at a conform with the essential requirements of The Radio higher power level than needed, and may shorten battery life. Communications Standard (Electro-magnetic IC Radiation RADIO FREQUENCY ENERGY Human Exposure) 2003 and the Australian Communications and Media Authority Section 376 of the Telecommunications Your wireless device is a low-power radio transmitter and Act 1997 when used at a distance of not less than 20 cm receiver. When switched on it intermittently transmits radio from the body. The worst case SAR result is 1.57 W/Kg frequency (RF) energy (radio waves). The transmit power at WCDMA 2100Mhz. level is optimised for best performance and automatically N14945

3 4 LET’S GET STARTED

ROHS DECLARATION YOUR PACKAGE CONTAINS THE FOLLOWING: (RESTRICTION OF HAZARDOUS SUBSTANCES) • Telstra Pre-Paid 3G USB + Wi-Fi device ZTE declares that the Wireless device is free from • Telstra Pre-Paid Next G® SIM card hazardous materials and complies with EU directive 2002/95/EC (commonly known as the RoHS Directive) • AC charger and the amendments. • USB extension cable • This Getting Started Guide • Telstra Pre-Paid Welcome Guide • Manufacturer’s warranty card • Wireless security card

5 6 IMPORTANT: SECURITY SETTINGS SSID QUICK REFERENCE SECTION AND WI-FI SECURITY KEY (WPA2 KEY) • The default security settings are unique for your device and Wi-Fi home page http://m.home are provided on the Wi-Fi security card. Please keep this card Wi-Fi home password in a safe place. page password

• The security key is case sensitive and should be entered Default SSID TEWM_xxxxxx exactly as it is written on the card. Your Wi-Fi security card key (WPA2 key) is also on the device. Default Security Key 10 characters which are case sensitive. Supplied on your security card. • You can change the SSID and Security Key to your Restore Defaults Press Reset button located under the back own preferences. cover, between SIM card and SD card. Press • You need this information to log on and use the device. gently with pen tip or pin to reset your device.

7 8 YOUR TELSTRA PRE-PAID 3G USB + WI-FI

Thumb catch LED Indicators The LED lights indicate your network connectivity and Wi-Fi status. Both LED’s will flash when you are transferring data.

Network Indicator Modem Status

Red Offline state, Power on, not registered Wi-Fi indicator Network indicator Green solid Registered on the 2G network

External antenna port Green blinking Data active on the 2G network

Blue solid Registered on the 3G network

Blue blinking Data active on the 3G network

Wi-Fi Indicator Modem Status

No LED Wi-Fi is off

Blue solid WPS is active

Blue blinking Wi-Fi is active

9 10 GETTING CONNECTED

1. INSERT SIM CARD 2. CONNECT TO INTERNET VIA USB • Your SIM card should already be inside the device. • Insert USB into USB port on your PC or other device. Check to make sure. To remove front cover use thumb catch on the top of the device and gently lift off.  Important: The USB must be plugged into a power source such as a PC or AC charger included in the box to operate.

• After a couple of minutes a new desktop icon called Telstra USB+WiFi will be installed. Your device will automatically open a new browser with the Wi-Fi home page where you can manage your connection settings. If not then select Computer from your Desktop or Start • To Insert the SIM card, slide in as shown Menu. Select the file AutoRun.exe. The desktop icon will with the gold chip facing down. then be installed. Double click on the icon to load the Wi-Fi home page.

11 12 3. CONNECT TO INTERNET VIA WI-FI 4. ACTIVATE YOUR SIM CARD • Ensure the USB is plugged into a power source such as a There are 2 ways to activate your service: PC or AC charger. • Activate online via telstra.com.au/activate. You can also • Check your computer or other device has Wi-Fi enabled access this link via the Wi-Fi homepage. and search for wireless networks. Refer to your Wi-Fi or enabled device manual for further details on searching • Call 125 8887 and follow prompts (from a Non Telstra for wireless networks. phone call 13 2200 and say “Pre-Paid”). • Select the SSID (Wi-Fi network name) displayed on your Refer to the Telstra Pre-Paid Welcome Guide for security card. This is also printed on the device under the further details. top cover. Then click connect. • Your Telstra Pre-Paid 3G USB + Wi-Fi is now connected and • Enter default security key exactly as shown on the included ready to use. security card. Note your security key is case sensitive. You can modify your settings via the Wi-Fi home page at http://m.home. For more information on the Wi-Fi home page see pages 18-19.

13 14 EXTRA FEATURES

5. ENDING YOUR SESSION CONNECTING AN EXTERNAL ANTENNA • Switch your router off, or disconnect via Using an external antenna may be recommended in your Wi-Fi network icon status bar. areas of lower coverage to improve your device performance. TS9 termination antennas are available from your retailer. 6. RECHARGING YOUR SIM Insert the connector carefully to avoid damage to your device. • Go to telstra.com/myaccount and follow the prompts. USING A MEMORY CARD (OPTIONAL ACCESSORY) 7. INTERNATIONAL ROAMING You can also use your device as an external storage drive when connected via USB or in Shared Access Mode via your • International Roaming is automatically available, web browser. however different charges apply. For a full list of countries and charges go to telstra.com/ppmbb. You will need a microSDHC card up to 32GB. Open the top cover of the device and insert the memory card as shown. • You can change between USB mode and Share Mode via the Wi-Fi homepage at http://m.home. • Select the Settings tab, then select SD card from the menu on the left. • Choose preferred mode from the SD Card Settings drop down box. Then click Apply.

15 16 WI-FI HOME PAGE

You can activate, check data usage and change the settings of your Telstra Pre-Paid 3G USB + Wi-Fi through your Wi-Fi home page. LOGIN TO YOUR WI-FI HOME PAGE • Open a web browser and enter http://m.home in the address bar. • Enter the password shown below in the Admin login USING EXTERNAL STORAGE VIA USB MODE field and click OK. In this mode only the user connected via USB can access the Password: password SD card by the removable drive mapping. Shared access via For full details on using your Wi-Fi home page click on Help. the web browser will be disabled in this mode.

USING EXTERNAL STORAGE VIA SHARE MODE This mode allows you to share the SD card with all connected users via the Web browser. USB Access to the SD card will be disabled in this mode.

17 18 PROBLEM SOLVING

CHECK DATA USAGE 1. Install and test the USB device in another computer •  To check your data usage click on ‘My Data Usage’ link on 2. Check your SIM card is working in another device - e.g. top right hand corner of your Wi-Fi home page. mobile phone 3. Insert a known working SIM card into your USB device HOW TO CHANGE WI-FI HOME PAGE PASSWORD 4. Confirm your account is active - contact Telstra • Go to Settings Tab. 5. Uninstall the USB device and re-install using Windows 'Safe Mode' - consult a PC technician for help if required • Select Advanced then select Admin Settings. (PC only) HOW TO CHANGE SECURITY KEY (WI-FI PASSWORD) • Go to Settings Tab. • Select Wi-Fi Settings, then select Security. If changing your password or security key please ensure you keep a record of it and store in a safe place.

19 20 WARRANTY AND SUPPORT TECHNICAL SPECIFICATIONS

• All calls and support for PIN numbers, SIM card Network AND UMTS/HSPA+, Tri Band 3G registration, account and billing information, network Frequency Band 850/1900/2100MHz, GSM/GPRS/EDGE, services and other general enquiries should be directed Quad Band 850/900/1800/1900 MHz. to Telstra. Wi-Fi working range approx 25m radius • See your warranty card for warranty and in free space service information. Wi-Fi Connections supports up to 5 users • View Frequently Asked Questions online at http://www.zte.com.au/telstra. Dimensions (W×H×D) 94.1 x 28.6 x12.5mm • For additional information you can access the full user Weight 29g manual by clicking Help from your Wi-Fi home page or via microSD™ or Up to 32GB http://www.zte.com.au. microSDHC™ card

External Antenna Port TS9

Operating Systems Microsoft Windows® 7, Windows ® 8 (Windows RT not supported), Vista & XP. 32 and 64 bit. Mac OS 10.4.11 and above.

21 22 EXTRA BITS NOTES YOU SHOULD KNOW

COVERAGE Coverage depends on your location, device and whether your device has an external antenna attached. Visit telstra.com/mobilebbcoverage to check if you are covered. NETWORK LOCK • Your wireless device is locked to the Telstra network. • When you insert a non-Telstra SIM card you are presented with unlock instructions. • Contact Telstra to obtain your 16 digit unlock code. • An unlocking fee may apply. • 5 incorrect attempts will block the unlock process and the device will then only work with a Telstra SIM card. • Contact Telstra for more information.

23 24 NOTES

Windows is a trade mark of the Microsoft group of companies. ™ and ® are trade marks and registered trade marks of Telstra Corporation Limited, ABN 33 051 775 556.

25 26