Tusk Beadlock Wheels Thanks for your purchase of the Tusk Beadlock Wheel. Please take note of the information and instructions below to get the most out of your Tusk Product. If you don’t feel comfortable with this install, please have a qualified mechanic install for you.
For instructional videos, refer to www.rockymountainatvmc.com/videos Attention: Use proper ATV tire mounting practice and equipment.
Beadlock Instructions:
1. Remove the beadlock ring from the wheel using a 1/2” socket.
2. Apply tire lube to the inside tire bead only. Do not lube the outside tire bead area.
3. Pay close attention to the tires direction before installing on to the wheel. Mount the inner bead onto the wheel starting from the beadlock side.
4. Seat the outer bead in the shoulder of the inner beadlock ring. Carefully check to see that the tire is centered on correctly on the wheel. Take note of any valve stem location markings on your tire.
5. Replace the beadlock ring on to the tire and in- ner bead ring. Align the bolt holes from the out- er ring with the inner ring.
6. Apply anti-seize or another lubricant to the threads of each bolt before threading into the inner ring.
INSTALLATION INSTRUCTIONS AND INFORMATION
7. Depending on the width of your tire you may have to push the outer bead down towards the wheel in order to properly thread the bolts. A second set of hands might be needed if the tire is too wide.
8. Make sure all bolts are started by hand and are
threaded in a couple threads before using tools
to ensure no cross threading is happening.
Page:2 -
SAPM20141105JL INSTALLATION INSTRUCTIONS AND INFORMATION Tusk Wheels Beadlock cases: following notwarranty the Tusk will purchaser. retail original for the intended only is warranty This wheels. a 1 Tusk holds use applications. normal failure under a structural in wheels your protects that warranty limited a carry Tusk wheels Warranty Limited wheels. of the thefinish hurt and friction more cause can as machines only wax Hand fromelements. the finish protect wheels the will waxing Periodic wheels. on the or materials chemicals abrasive use Do not dull thefinish. will time in and of wheels your spotting cancause buildup soap Water and cleaning. after dry sure to Make use a non drying water. When clean and soap, sponge, a mild wheels with Clean use. each after cleaned not if wheel the corrode can dust and mud, Dirt, solution. cleaning proper the follow please wheels of your or corrosion pitting To prevent Care: warranty. all void and damage wheel in result could so to do Failure maintenance. stud and specs for torque manual service to your Attention: thewheels. on reached miles 200 is Note: 12. 11. 10. 9.
Tusk is not responsible for damage caused by improper assembly/installation. by improper caused for damage responsible not Tusk is conditions. road or an accident in occurring Damage environment. a racing/competition failure in structural or Damage instructions complete follow to failure due to wheel the to Damage on wheels. maintenance care to above Refer damages. glected ne- or cleaning/maintenance, improper corrosion, chemical corrosion, weather cover Does not seating. for pressure mum maxi- recommended manufacturer’s ceed thetire bead. theinner seat to thetire Inflate tothem 20ft/lbs. torque and star pattern a in through go back at10ft/lbs, are thebolts Once 10ft/lbs. reach bolts all until thestar in pattern again 10ft/lbs. thebolts to torqueing begin snug is bolt each After See ring beadlock outer the on pressure even of sure to make time a turns at a few a starin pattern thebolts Tighten warranty is limited to the wheel structure only. only. structure to thewheel limited is warranty This bolts. beadlock stripped/broken or rings beadlock or bent cracked, cover broke, Does not
Re - torque the ring bolts every 50 miles until until 50miles every bolts ring the torque When mounting Tusk wheels to your ATV or UTV, always use tapered lug nuts and refer and nuts lug tapered use always UTV, or ATV your wheels Tusk to mounting When
Fig. 1 Fig.
- year warranty against manufacture defects in the finish of the of the thefinish in defects manufacture against year warranty
DO NOT NOT DO
ex-
- abrasive towel. towel. abrasive