SVSI N-Series Wall Controller Cut-Out Template

Use this cut-out template to begin installation of your N-Series Wall Controller (SC-WPC-D/SC-TC-D). 1. When printing this document, please double-check all print settings: • Print to an 8.5x11 page. • Set Page Scaling to None. DO NOT SHRINK to fit to the page. 2. Use scissors to cut out the gray area from the template. 4.00” 3. Tape the cut-out to the mounting surface on your wall (101.6 mm) where the N-Series Wall Controller is to be installed. 4. Mark the position on the mounting surface. 5. Double-check all dimensions, positions, and measurements. 6. Cut the opening in the wall. 7. Continue installation by following the instructions given in the unit’s Quick Start Guide (included in shipment and/or available on-line at www.amx.com/svsi/).

805-0001 REV: A

4.00” (101.6 mm)

SVSI N-Series Wall Controller Cut-Out Template

Use this cut-out template to begin installation of your N-Series Wall Controller (SC-WPC-D/SC-TC-D). 1. When printing this document, please double-check all print settings: • Print to an 8.5x11 page. • Set Page Scaling to None. DO NOT SHRINK to fit to the page. 4.00” 2. Use scissors to cut out the gray area from the template. (101.6 mm) 3. Tape the cut-out to the mounting surface on your wall where the N-Series Wall Controller is to be installed. 4. Mark the position on the mounting surface. 5. Double-check all dimensions, positions, and measurements. 6. Cut the opening in the wall. 7. Continue installation by following the instructions given in the unit’s Quick Start Guide (included in shipment and/or available on-line at www.amx.com/svsi/).

805-0001 REV: A

4.00” (101.6 mm)