789834 446604 9 Isbn 978-983-44466-0-4
Total Page:16
File Type:pdf, Size:1020Kb
ISBN 978-983-44466-0-4 9 78983 4 44660 4 TECHNICAL STANDARDS AND INFRASTRUCTURE REQUIREMENTS Part 1 FIXED NETWORK INFRASTRUCTURE MTSFB 008 : 2005 (Revision 1) The Malaysian Technical Standards Forum Bhd (MTSFB) (655368-P) is designated and registered by the Malaysian Communications and Multimedia Commission (SKMM) under the Communications and Multimedia Act 1998 (Act 588), Part V, Chapter 9, Voluntary Industry Codes, Section 94 and Part VII, Chapter 3, Technical Standards, Section 184 on 27 October 2004 The Technical Standards and Infrastructure Requirements - Part 1 – Fixed Network Infrastructure (TSIR - FNI) is registered by the Malaysian Communications and Multimedia Commission (SKMM) under the Communications and Multimedia Act 1998 (Act 588), Part VII - Technical Regulation, Chapter 3, Technical Standards, Section 185 on 13 August 2008 ©Malaysian Technical Standards Forum Bhd (MTSFB), 2009 The information or material in this publication is protected under copyright and, save where otherwise stated, may be reproduced for non-commercial use provided it is reproduced accurately and not used in a misleading context. Where any material is reproduced, MTSFB as the source of the material must be identified and the copyright status acknowledged. The permission to reproduce does not extend to any information or material the copyright of which belongs to any other person, organization or third party. Authorization or permission to reproduce such information or material must be obtained from the copyright holders concerned. This work is based on sources believed to be reliable, but MTSFB does not warrant the accuracy or completeness of any information for any purpose and cannot accept responsibility for any error or omission Published by: Malaysian Technical Standards Forum Bhd (MTSFB) Lot 3-4C, Incubator 3, Technology Park Malaysia, Lebuhraya Puchong-Sungai Besi, 57000 Bukit Jalil Kuala Lumpur. Tel: +603 8996 5505 Fax: +603 8996 5507 Website: www.mtsfb.org.my ISBN 978-983-44466-0-4 FOREWORD MALAYSIAN COMMUNICATIONS AND MULTIMEDIA COMMISSION (SKMM) The publication of the Technical Standards for Infrastructure Requirements (TSIR) is intended to set standards for the overall improvement of network infrastructure in both fixed and broadcast services by service providers to consumers. The Code was successfully drafted by the Multimedia Network Infrastructure Working Group (MNI WG) members, representing their respective organizations who work together in a forum voluntarily formed by the industry players. This forum which is known as Malaysian Technical Standards Forum Bhd (MTSFB) was set up in April 2004 and is one of four self-regulated industry forums formed under the requirements of the Communications and Multimedia Acts 1998 (CMA ’98). The Code also sets out the requirement for network installation by relevant authorities such as SKMM and Local Councils. In line with the vision of SKMM’s MyICMS 886, this Code will emphasize the importance of TSIR and best work practices in the multimedia network. This is expected to improve the overall system performance and delivery method of various services. Proper techniques, deployment and management of multimedia network infrastructure with reference to the technical codes and guidelines will be instilled. I am confident that MTSFB will continue to strive towards promoting understanding of the Code among members of the industry and the public. Through awareness programs and nationwide road shows, they have the full support from industry and regulators. I wish to congratulate MTSFB for making the establishment of this Code possible. I hope the commitment that has been shown by MTSFB will continue as they take on bigger tasks and challenges in the communications and multimedia industry. DATUK DR. HALIM SHAFIE CHAIRMAN OF MALAYSIAN COMMUNICATIONS AND MULTIMEDIA COMMISSION FOREWORD MALAYSIAN TECHNICAL STANDARDS FORUM BHD (MTSFB) The Technical Standards and Infrastructure Requirements (TSIR) code was established to serve as guidelines and standards for the purpose of supporting the Uniform Building By-Laws (UBBL). Such formation of codes is provided for in the Communications and Multimedia Act, CMA 1998 (CMA) and the relevant provisions on technical regulation in Part VII of the CMA The TSIR on Fixed Network Infrastructure Code was prepared by the Fixed Network Infrastructure Sub-Working Group (FNI SWG) with the common understanding and agreement among the communications and service providers’ representatives in Malaysia. The formation of FNI SWG under the Multimedia Network Infrastructure Work Group (MNI WG) had been approved by the Malaysian Technical Standards Forum Bhd (MTSFB) for the sole purpose of developing the TSIR Code. MTSFB is one of the four self-regulation industry forums which was formed under the CMA and was officially designated by SKMM on 27th October 2004. MTFSB is responsible for the establishment and maintenance of the standards, technical codes, networks interoperability and operation issues, as well as to develop, recommend, modify, update and seek the registration of technical codes from SKMM. The Code was registered by SKMM as the respective technical code and took effect on 13 August 2008. The Code is intended as a reference for technical codes and standards for architects, consulting engineers, owners, developers and others who are responsible for planning and erecting buildings. This is inline with the objective to meet the requirement of end users on fixed services with minimum disruptions to all services offered by service providers. For the purpose of meeting the needs of users, this Code addresses the technical system and infrastructure requirements which impose that building shall be equipped with fixed broadband distribution system. This is important as fixed services are used as a medium for delivery of public information to the masses, particularly during crisis and emergency situations. I would like to congratulate the working group on their success of establishing this TSIR Code. I also would like to stress that the strength of the working group lies in the diversity of the members’ specialised knowledge and expertise which are deemed indispensable and valuable to MTFSB. I believe that the valuable knowledge and skills of the members will continue to contribute to this wave of technology development of which MTFSB is seen as one of the integral part towards the realization of the national objectives in communications and multimedia. Finally, I would like to offer my gratitude to the working group chairman, vice chairman, secretary and all members who had given their full commitment and worked diligently in preparing the document. DATO’ ISMAIL OSMAN CHAIRMAN OF MALAYSIAN TECHNICAL STANDARDS FORUM BHD CONTENTS Committee representation 11 1 Introduction 13 1.1 Document Objective 13 1.2 Document Scope 13 1.3 Representation 13 2 Building Requirements for Fixed Network Infrastructure 14 2.1 Outdoor Requirements 14 2.1.1 Manhole at Roadside 14 2.1.2 Duct-Way Into Building 14 2.2 Telecommunications Room 14 2.2.1 Space Requirement 14 2.2.2 Electrical Requirement 15 2.2.3 Temperature/Ventilation 16 2.2.4 Accessibility 16 2.2.5 Security 16 2.2.6 Floor Loading 17 2.2.7 Room Height 17 2.3 Riser 17 2.3.1 Riser Requirement 17 2.3.2 Riser Sie/Working Space 17 2.3.3 Riser Arrangement 18 2.3.4 Accessibility 19 2.3.5 Electrical Requirement 19 2.4 Home Unit 19 2.4.1 Telecommunications Outlet 19 2.4.2 Location of The Telecommunications Outlet 20 3 Technical Information 21 3.1 Service/Network Provider 21 TECHNICAL STANDARDS AND INFRASTRUCTURE REQUIREMENTS FIXED NETWORK INFRASTRUCTURE 3.2 Service/Network Provider Infrastructure 21 3.3 Design of Customer Building Infrastructure Requirement 22 3.4 Design of Cable Distribution Requirement 22 3.5 Cable Specifications 23 3.6 Telecommunications Outlet (Wall Sockets) 23 4 Technical Specifications 24 4.1 Manhole and Duct-ways 24 4.2 Structured Cabling 24 4.2.1 General 24 4.2.2 Generic Structured Cabling System 24 4.2.3 Cabling Sub-systems 25 4.2.4 Distributors 26 4.2.5 Interfaces to the Generic/Structured Cabling System 26 4.2.6 Overall Structure 26 4.2.7 Design Consideration For Generic/Structured Cabling Systems 28 4.2.8 Grounding and Fire-Stopping 28 4.2.9 Work Area 32 4.2.10 Horizontal Cabling Subsystem 34 4.2.11 Colour Coding 36 4.2.12 Cable Testing 37 4.2.13 Fiber Optic Testing 38 5 Abbreviations and Definitions 41 TABLES 1 Telecommunications Room Floor Space 14 2 Riser size 17 3 Horizontal trunking 19 4 Number of Telecommunications Outlet Socket for Home Unit 19 5 Location of Telecommunications Outlet Socket 20 6 Cable Types and Related Services Supported 23 TECHNICAL STANDARDS AND INFRASTRUCTURE REQUIREMENTS FIXED NETWORK INFRASTRUCTURE 7 Recommended Media For Pre-Cabling 28 8 Separation of Data Cables from Power Cables 29 9 Fire Rating Classifications 30 10 Work Area Components 32 11 Maximum Length of Horizontal and Work Area Cables 36 12 Colour Coding 36 D1 Typical Manhole Specifications 62 E1 Bending Radius for Conduit 65 E2 Conduit Fill Table 65 E3 Outlet Box Sizes for Different Conduit Sizes 66 E4 Floor Distributor Sizing 70 E5 Backbone Media selection 74 E6 Conduit Fill for Backbone Cabling 76 E7 Pull Box Sizing 76 E8 Splice Box Sizing 77 E9 Sleeve Requirements Based on Floor Area 78 E10 Slot Requirements Based on Floor Area 78 E11 Technology Selection for Campus Cabling 81 E12 Minimum Equipment and Termination Wall Space 81 E13 Minimum Equipment and Termination Room Space 82 E14 TR Floor Space For Normal Office Building