Brigham Young University BYU ScholarsArchive Theses and Dissertations 2008-12-04 The Effect of Liquid Hot Filling Temperature on Blow-Molded HDPE Bottle Properties Benjamin S. Hudson Brigham Young University - Provo Follow this and additional works at: https://scholarsarchive.byu.edu/etd Part of the Manufacturing Commons BYU ScholarsArchive Citation Hudson, Benjamin S., "The Effect of Liquid Hot Filling Temperature on Blow-Molded HDPE Bottle Properties" (2008). Theses and Dissertations. 1624. https://scholarsarchive.byu.edu/etd/1624 This Thesis is brought to you for free and open access by BYU ScholarsArchive. It has been accepted for inclusion in Theses and Dissertations by an authorized administrator of BYU ScholarsArchive. For more information, please contact
[email protected],
[email protected]. THE EFFECT OF LIQUID HOT FILLING TEMPERATURE ON BLOW-MOLDED HDPE BOTTLE PROPERTIES by Benjamin S. Hudson A thesis submitted to the faculty of Brigham Young University in partial fulfillment of the requirements for the degree of Master of Science School of Technology Brigham Young University December 2008 BRIGHAM YOUNG UNIVERSITY GRADUATE COMMITTEE APPROVAL of a thesis submitted by Benjamin S. Hudson This thesis has been read by each member of the following graduate committee and by majority vote has been found to be satisfactory. Date Mike P. Miles, Chair Date A. Brent Strong Date Scott D. Grimshaw BRIGHAM YOUNG UNIVERSITY As chair of the candidate’s graduate committee, I have read the thesis of Benjamin S. Hudson in its final form and have found that (1) its format, citations, and bibliographical style are consistent and acceptable and fulfill university and department style requirements; (2) its illustrative materials including figures, tables, and charts are in place; and (3) the final manuscript is satisfactory to the graduate committee and is ready for submission to the university library.