sign in sign up
<<
Home , Fixture (tool)

NAIL-IN PIN ANCHORS

Mushroom Description Anchor sizes and styles Head GrabMac Dive Pin Anchors are Determine the proper minimum anchor depth for the load excellent for light-duty, tamperproof requirements of your application and choose the appropriate Nail applications in concrete, block, head style (flat- or mushroom-head). brick or stone (not recommended for overhead applications). These The correct anchor length is the depth of the anchor plus the thickness of the fixture, including any spacers or shims. Anchor anchors are very quick and easy to Body install—just in the drive Mushroom-head GrabMac anchors are sized from below the pin until it is fully seated. head whereas flat-head anchors are measured end to end.

GrabMac anchors are made of a tough, corrosion-resistant alloy Mushroom Head - Carbon Steel Nail body with stainless or carbon steel Size Dia. Box Std Ctn Wt/100 Alloy with carbon pins. They are available in either a or G2802 3/16" X 7/8" 3/16" 100 500 3/4 drive pin. flat- or mushroom-head style. G2806 1/4" X 3/4" 1/4" 100 500 1-1/2 *This anchor is not recommended for overhead applications. G2808 1/4" X 1" 1/4" 100 500 1-3/4 G2814 1/4” X 1-1/4" 1/4" 100 500 2-1/4 G2820 1/4" X 1-1/2" 1/4" 100 500 2-1/2 G2826 1/4" X 2" 1/4" 100 500 3 Installation

1 Using the proper size , drill a hole at least ¼" deeper than the Inatallation Specifications length of the anchor. Blow the Anchor Size 3/16"MH 1/4"MH 1/4"FH hole clean of dust and debris. ANSI Drill Bit Size 3/16" 1/4" 1/4" Fixture Clearance Hole 1/4" 5/16" 5/16" 2 Insert the GrabMac anchor Head Height 7/64" 9/64" 3/16" through the fixture and into the Head Width 13/32" 35/64" 35/64" pre-drilled hole. Be sure the head is seated firmly against the fixture.

3 Hammer the pin into the anchor Material Specifications body until the pin is fully seated. Head Component CS Nail Flat Head Mushroom Head This expands the alloy body and CS Nail CS Nail tightens the anchor. Drive Nail AISI 1018 AISI 1018 Type 304 SS Anchor Body Zamac Alloy Zamac Alloy Zamac Alloy Nail Plating ASTM B 633, sc1, Type III (Fe/Zn 5) N/A

Form gb-135-04-07-04 "If it's worth building, it's worth GRABBER®" www.grabberman.com