BASIC TULIKIVI REQUIREMENTS

Class “A” pipe through attic space These minimum conditions, if provided, supported by terminal box. will assure a smooth installation.Your Tulikivi installation may have more complicated conditions – Tulikivi can find a solution for almost any situation.

Your Tulikivi can be connected to existing flues – talk with your Tulikivi installer to verify size and slope of the flue for adaptation.

Note! You only need one of these flues per Tulikivi!

Heat shield for units near combustible walls. See TTM-1 for clearances and shield details.

Class “A” flue pipe for bottom vented unit.

Smooth, level structural surface to match unit dimensions. See TTM-1 for clearances and shield details.

Outside air supply for combustion.

Fire resistive floor covering – refer to local building codes.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. SCOPE OF WORK

Terminal cap spark arrester. Roof jack.

Flue Pipe.

Weather shield.

Terminal Box.

Ceiling

Internal flue pipe cladding.

Tulikivi.

Pad.

Support Structure.

Footing.

TOP VENT UNIT BOTTOM VENT UNIT

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. STEEL SUPPORT 1 (REMODEL)

Engineered steel angle iron frame New Tulikivi with Foamglas® fill, lag bolt to freestanding unit. existing joists.

Verify position of floor joists, plumbing, electrical, etc. before cutting holes.

See TTM-1 for clearances.

EXISTING FLOOR.

EXISTING BASEMENT OR CRAWL SPACE.

Engineered new concrete pad or existing basement slab. Steel columns with steel pads.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. STEEL SUPPORT 2 (NEW CONSTRUCTION)

Freestanding Tulikivi unit.

Frame opening to provide clearance to combustibles. See TTM-1 for Engineered clearances. angle iron frame with Foamglas® fill, lag bolt to floor joists.

Steel columns with steel pads.

Basement slab or crawl space pad.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. CONCRETE / MASONRY 3 SUPPORT

Freestanding Tulikivi unit.

Engineered concrete pad. Use floor frame to form and place concrete.

Engineered concrete or masonry support.

Optional ash dump door. Engineered reinforced concrete footing.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. OVER GARAGE 4 (REMODEL)

New Tulikivi unit.

Verify position of floor joists, plumbing, electrical, etc. before cutting holes. Engineered steel frame with Foamglas® fill.

See TTM-1 for Steel columns clearances. supported by beams.

Existing floor joists.

Engineered steel beams to span over parking spaces.

GARAGE SPACE.

Provide fireproofing integrity per building codes.

Steel columns clear of parking spaces.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. CORNER UNIT 5 (REMODEL)

See TTM-1 for clearances and shield details. New Tulikivi corner unit.

Verify position of floor joists, plumbing, electrical, etc. before cutting holes. Engineered steel angle iron frame with Foamglas® fill.

See TTM-1 for clearances.

EXISTING CRAWL SPACE.

Steel columns with steel pads.

Existing footing.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. STEEL PLATE SUPPORT 6 (REMODEL)

New Tulikivi unit.

Verify position of floor joists, plumbing, electrical, etc. before cutting holes.

See TTM-1 for clearances.

Engineered steel plate support. EXISTING FLOOR.

Foamglas® insulation.

Steel columns with steel pads.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. TIMBER SUPPORT 7

Freestanding Tulikivi unit.

Mineral board.

Foamglas® support pad.

Engineered wood floor joists.

Engineered wood columns.

Engineered wood girders.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. SECOND APPLIANCE

8 Chimneys continue through to roof.

Tulikivi flue connection Engineered either top or bottom. concrete pad.

Woodstove by others in alcove formed by support. Flue connection from woodstove.

Engineered masonry or concrete Tulikivi support.

Engineered masonry double chimney.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. CEILING CONNECTION 9

Class “A” flue pipe.

ATTIC SPACE. Terminal box by flue supplier.

Ceiling joist framed opening.

Ceiling.

See TTM-1 for clearances.

Class “A” pipe connector.

Stainless steel flue liner by Tulikivi installer.

Soapstone flue by Tulikivi.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. CORNER UNIT 10 (NEW CONSTRUCTION)

See TTM-1 for clearances and shield details.

Engineered steel angle iron frame with concrete fill.

Subfloor.

Wood floor beam.

Engineered steel beam.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. CORNER UNIT 11 (REMODEL)

See TTM-1 for clearances and shield details.

Verify position of floor joists, plumbing, electrical, etc. before cutting holes.

Foamglas® pad over steel plate.

Engineered new footings Engineered steel columns. in crawl space.

Foamglas® is a registered trademark of Pittsburgh Corning.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove. SLAB ON GRADE 12

Freestanding Tulikivi unit.

Engineered thickened slab – certain soil types may support the unit without added thickness.

©1999 Tulikivi U.S., Inc. Tulikivi provides these drawings as a conceptual aid for the North American market.They illustrate some common conditions installers have encountered and general methods which might be considered for addressing such conditions. Please note that this material is not tailored to any particular condition; is not intended to be a substitute for or supplant the technical manual TTM-1; and is not a warranty with respect to the merchantability, suitability, or fitness for a particular purpose regarding Tulikivi products or the methods illustrated. It is not designed to replace good engineering practice, local building codes or the formal and practical training and advice of a qualified builder.The material only suggests ways architects, engineers, builders, installers and owners can enhance their projects by including a Tulikivi fireplace, bakeoven or cookstove.