Lumber Pattern Data Sheet Log Cabin Lumber Patterns | V1.0
Total Page:16
File Type:pdf, Size:1020Kb
LUMBER PATTERN DATA SHEET LOG CABIN LUMBER PATTERNS | V1.0 LUMBER PROFILE LOG CABIN SIDING (1” x 8”) FIND THIS PATTERN IN OUR LUMBER PATTERN BOOK ON PAGE 18 » NOTE: Dimensioned pattern drawings are drawn to scale and presented at 100% unless otherwise indicated. 7-3/16” 1-3/16” 7/32” 11/32” 1/8” 23/32” 3/8” 3/8” SCAN HERE Get a digital copy of our 6-11/16” 1/2” Lumber Pattern Book by PATTERN scanning the QR Code or by visiting our website at: 1X8 LOG CABIN SIDING westernwoodsinc.com PROFILE VIEW INSTALLED VIEW SIZE OPTIONS NOMINAL SIZE PATTERN NO. A B CONVERSION FACTOR -- SEE DOCUMENTED SIZE DATA ABOVE -- - - - - - - - - - - 1X8 LOG CABIN SIDING - - - - - PATTERN DISCLAIMER: The dimensions of the delivered product is subject to change due moisture variations experienced by the product during the drying process, storage, or transportation. Site environmental conditions also apply. See page 36 for additional information. Milling variations apply. Consult your local building code for tolerances and specifics. VISIT US ONLINE www.westernwoodsinc.com | CALL US (800) 824-4100 LUMBER PATTERN PRODUCT DATA SHEET v1.0 | WESTERN WOODS 01 LUMBER PATTERN DATA SHEET LOG CABIN LUMBER PATTERNS | V1.0 ALIGNMENTS DESCRIPTION FIND THIS PATTERN IN OUR LUMBER PATTERN BOOK STARTING ON PAGE 18 Horizontal Log Cabin Patterns are 1 1/2” thick at the thickest point. These patterns are ideally suited to informal building in a rustic settings. Vertical Log Cabin may be milled from appearance grades (‘Commons’) or dimension grades (2x material). Allow for a 1/2” overlap (rabbet, C), including an approximate 1/8” gap (B). NAILING PATTERNS NAILING PATTERNS NAILING PATTERNS NOMINAL SIZES 6” AND NARROWER 8” AND WIDER 1 1/2 x 6 LEGEND 21 1 1 1/2 x 8 NAILS MUST PENETRATE 1 1/2” 1 A HOUSE WRAP 1 1/2 x 10 INTO SOLID WOOD. 1 1/2 x 12 USE TWO SIDING OR BOX B SHEATHING A A 2 NAILS PER BEARING 3 - 4” B B APART. C STUD C C A USE ONE SIDING OR BOX NAILS PER BEARING. SIDING NAIL TYPES B 1/8” = GAP FOR EXPANSION NAIL DEPTH C 1/2” = LENGTH OF RABBET 1/2” (OVERLAP). NAIL 1 ½” C 1 POSITION LOWER NAIL 1 1/2” BOX NAIL FROM THE BOTTOM. SIDING NAIL 1 PROFILE VIEW B Wide head flat, BOX NAIL - 3” » 4” smooth shaft. 2 A profile view of the pattern BETWEEN B S S SIDING NAIL - Wide flat before installation. head, ribbed shaft. A B S 1/8” ! WARNING: Do not nail through B any of the over-lapping pieces. « EXTERIOR CONTENT SOURCE INSTALLATION RECOMMENDATIONS & NAILING « EXTERIOR PATTERNS PROVIDED BY WWPA. VISIT US ONLINE www.westernwoodsinc.com | CALL US (800) 824-4100 LUMBER PATTERN PRODUCT DATA SHEET v1.0 | WESTERN WOODS 02 « EXTERIOR « EXTERIOR.