INSTRUCTIONS FOR: THE The Maltby GOLFWORKS® Economy Bounce Gauge Code: GW1020

The Economy Bounce Gauge is a great tool for measuring the bounce angle of any Using the GolfWorks Golf Club Protractor (included as a kit (GW1011) or sold iron quickly and accurately. There is no clamping down of the head required. Simply separately (GWPRO)), you can accurately calculate the bounce angle of any iron. The place the iron head face down on the gauge surface, position the adjustable sole arm Economy Bounce Gauge can also be used to measure the loft of putter and wood so that it contacts the center of the sole and your set up is done. heads.

1 Measuring the 1 Measuring Loft Bounce Angle on Angle Of Irons; Woods; Place the iron head to be Place the wood head to measured on the left side of be measured on the the gauge surface. The iron left side of the gauge should be positioned so that surface (shown in the scoring lines are square photo 1). Loosen the or parallel across the gauge sole arm knob to allow surface (see photo 1). placement of the sole arm to the center of the face.

2 Loosen the sole arm knob to 2 The contact point allow placement of the sole should be in the center arm to the center of the sole. of face (shown in photo The center of the sole is the 2). The sole arm will intersection of 1/2 the sole usually not contact the width measurement from entire face surface of front to back and 1/2 the the wood due to the sole length measurement vertical roll. Once the from toe to heel. Once the sole arm is in place, bar is touching the center tighten the knob to of the sole, tighten the knob prevent the sole arm to prevent the sole arm from moving. It will be from moving. necessary to hold the NOTE: To get an accurate bounce measurement, the loft of the iron being measured wood head in place must be known. with one hand and measure with the other.

3 Once the iron head is in Once the wood head is place and the sole arm is 3 secure, slide the Golf positioned properly, slide the Club Protractor into Golf Club Protractor into position as shown. position as shown in photo Be sure the bottom of 3, make certain the bottom the protractor is flush of the Golf Club Protractor is with the gauge surface flush with the gauge surface and the measurement and the measurement side side of the Golf Club of the Golf Club Protractor is Protractor is flush with flush with the sole arm the sole bar (shown in (shown in photo 3). Record photo 3). Take the read- the degree reading on the ing. The reading will be Golf Club Protractor. To calculate the bounce angle, subtract the reading on the Golf Club the loft reading of the Protractor from the known loft of the iron head. club being measured. EXAMPLE: 56° sand wedge, Golf Club Protractor reading 45°. 56° - 45° = 11° No calculation is of bounce. necessary.

4820 Jacksontown Road | P.O. Box 3008 • Newark, Ohio 43058-3008 | Toll Free: 800-848-8358 • FAX: 800-800-3290 | Canada Toll Free: 800-387-5331 e-mail: [email protected] • website: www.golfworks.com