Owner's Manual
Total Page:16
File Type:pdf, Size:1020Kb
VQT4G28_ENG_SPA.book 1 ページ 2012年5月16日 水曜日 午前11時43分 Owner’s Manual INTERCHANGEABLE LENS FOR DIGITAL CAMERA Model No. H-HS12035 Before connecting, operating or adjusting this product, please read the instructions completely. For USA and Puerto Rico assistance, please call: 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo For Canadian assistance, please call: 1-800-99-LUMIX (1-800-995-8649) or send e-mail to: [email protected] VQT4G28 PP F0512SM0 until 2012/6/6 VQT4G28_ENG_SPA.book 2 ページ 2012年5月16日 水曜日 午前11時43分 Contents THE FOLLOWING APPLIES ONLY IN CANADA. Information for Your Safety..................................... 2 This Class B digital apparatus complies with Precautions........................................................... 4 Canadian ICES-003. Supplied Accessories ............................................. 5 Attaching/Detaching the Lens................................. 6 Names and Functions of Components ................... 8 Cautions for Use..................................................... 9 Information for Your Safety Troubleshooting .................................................... 9 Specifications........................................................ 10 Keep the unit as far away as possible from Limited Warranty................................................... 11 electromagnetic equipment (such as microwave ovens, TVs, video games, radio transmitters, -If you see this symbol- high-voltage lines etc.). ≥ Do not use the camera near cell phones because Information on Disposal in other Countries doing so may result in noise adversely affecting outside the European Union the pictures and sound. This symbol is only valid in the If the camera is adversely affected by European Union. ≥ If you wish to discard this electromagnetic equipment and stops functioning product, please contact your properly, turn the camera off and remove the local authorities or dealer and battery and/or the connected AC adaptor. Then ask for the correct method of reinsert the battery and/or reconnect the AC disposal. adaptor and turn the camera on. 2 VQT4G28 VQT4G28_ENG_SPA.book 3 ページ 2012年5月16日 水曜日 午前11時43分 ENGLISH The lens can be used with a digital camera THE FOLLOWING APPLIES ONLY IN THE U.S.A. compatible with the lens mount standard for the TM FCC Note: “Micro Four Thirds System”. This equipment has been tested and found to comply with the limits ≥ It cannot be mounted on the Four ThirdsTM mount for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection specification camera. against harmful interference in a residential installation. This ≥ The digital camera illustrations in this owner’s equipment generates, uses and can radiate radio frequency manual show DMC-GH2 as an example. energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio ≥ The appearance and specifications of products communications. However, there is no guarantee that described in this manual may differ from the actual interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or products you have purchased due to later television reception, which can be determined by turning the enhancements. equipment off and on, the user is encouraged to try to correct ≥ Micro Four ThirdsTM and Micro Four Thirds Logo the interference by one or more of the following measures: ● Reorient or relocate the receiving antenna. marks are trademarks or registered trademarks of ● Increase the separation between the equipment and receiver. Olympus Imaging Corporation, in Japan, the United ● Connect the equipment into an outlet on a circuit different States, the European Union and other countries. from that to which the receiver is connected. ● Consult the dealer or an experienced radio/TV technician ≥ Four ThirdsTM and Four Thirds Logo marks are for help. trademarks or registered trademarks of Olympus Any unauthorized changes or modifications to this equipment Imaging Corporation, in Japan, the United States, would void the user’s authority to operate this device. This device complies with Part 15 of the FCC Rules. Operation is the European Union and other countries. subject to the following two conditions: (1) This device may not ≥ G MICRO SYSTEM is an interchangeable lens cause harmful interference, and (2) this device must accept any type digital camera system of LUMIX based on a interference received, including interference that may cause undesired operation. Micro Four Thirds System standard. Responsible Party: ≥ Other names of systems and products mentioned Panasonic Corporation of North America in these instructions are usually the registered One Panasonic Way, Secaucus, NJ 07094 trademarks or trademarks of the manufacturers Support Contact: Panasonic Consumer Marketing Company of North America who developed the system or product concerned. Telephone No.: 1-800-211-PANA (7262) 3 VQT4G28 VQT4G28_ENG_SPA.book 4 ページ 2012年5月16日 水曜日 午前11時43分 ≥ Do not press the lens with excessive force. Precautions ≥ When there is dirt (water, oil, and fingerprints, etc.) ∫Lens Care on the surface of the lens, the picture may be ≥ This lens has a dust-proof and splash-proof affected. Lightly wipe the surface of the lens with a construction. When using it, please be careful of soft, dry cloth before and after taking pictures. the following. ≥ Do not place the lens mount If the lens is not working properly, consult the facing downwards. Do not dealer or your nearest Service Center. allow the lens contact points – Please attach the lens to a dust-proof and to become dirty. splash-proof digital camera. 1 – When detaching the lens from the digital camera, take care to ensure that sand, dust, splashes of ∫About Condensation water etc., do not get into the lens or the (Fogging of the Lens) terminals. ≥ Condensation occurs when there are differences – This lens is not waterproof and cannot be used to in temperature and humidity as described below. record underwater. For splash-proofing, the lens Condensation can cause the lens to become dirty is constructed to resist the entry of water. If splashes of water etc. do adhere to the lens, wipe and lead to mold and malfunctioning, so exercise after use with a soft dry cloth. caution in the following situations: ≥ To improve the dust-proofing and splash-proofing – When the camera is brought indoors from outside of this lens, a lens mount rubber is used in the during cold weather mounting portion. After changing the lens a – When the camera is brought into an air- number of times, you may find that the lens mount conditioned car rubber has marked the mount portion of the digital – When cold air from an air conditioner is directly camera body, which does not affect its blown onto the lens performance. – In humid places For information on changing the lens mount rubber, contact your nearest Service Center. 4 VQT4G28 VQT4G28_ENG_SPA.book 5 ページ 2012年5月16日 水曜日 午前11時43分 ≥ Put the camera into a plastic bag to allow it to Supplied Accessories acclimatize to the surrounding temperature in order to prevent condensation. If condensation [Inspection to be performed when you unpack occurs, turn the power off and leave it for about the unit] two hours. Once the camera acclimatizes to the When removing the unit from its packing box, check surrounding temperature the condensation will go that the main unit and the supplied accessories are away naturally. there and also check their external appearance and functions to verify that they have not sustained any damage during distribution and transportation. If you discover any trouble, contact your vendor before using the product. Product numbers correct as of May 2012. These may be subject to change. 123 4 VFC4456 VYC1084 VYF3480 VFC4605 1 Lens Storage Bag 2 Lens Hood 3 Lens Cap 4 Lens Rear Cap (The lens rear cap and lens cap are attached to the interchangeable lens at the time of purchase.) 5 VQT4G28 VQT4G28_ENG_SPA.book 6 ページ 2012年5月16日 水曜日 午前11時43分 Attaching/Detaching the Lens ∫Detaching the Lens ≥ Check that the camera is turned off. ≥ Refer also to the camera’s owner’s manual for While pressing on the attaching and detaching the lens. lens release button D, ∫Attaching the Lens rotate the lens toward ≥ Check that the camera is turned off. the arrow until it stops 1 Turn the lens rear cap and then remove. to detach it. • Attach the lens rear cap so A: Lens Rear Cap that the lens contact point does not get scratched. • Attach the body cap to the camera so no dirt or dust will get inside the main unit. 2 Align the lens fitting ∫Attaching and Detaching the Lens Cap marks B (red marks) on the camera body and the Pinch the lens cap lens and then rotate the as shown in the lens in the direction of figure to attach or the arrow until it clicks. detach. • Do not press the lens release • Be careful not to lose button C when you attach a lens. the lens cap. • Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. 6 VQT4G28 VQT4G28_ENG_SPA.book 7 ページ 2012年5月16日 水曜日 午前11時43分 ∫Attaching the Lens Hood • Hold the short sides of the flower shape lens (Supplied Accessory) hood when attaching or detaching it. • When taking pictures with the flash with the lens Insert the lens hood into hood attached, the lower portion of the screen the lens with the short may turn dark (vignetting effect) and the control sides at the top and of the flash may be disabled because the photo bottom, and turn in the flash may be obscured by the lens hood. We direction of the arrow recommend detaching the lens hood. until it stops. • When using the AF assist lamp in the dark, E: Fit to the mark detach the lens hood. ∫Temporarily Storing the Lens Hood ∫Attaching Filters Vignetting may occur if using 2 or more 1 Turn the lens hood in the ≥ MC protectors (optional: DMW-LMCH58), direction of the arrow to PL filters (optional: DMW-LPL58) or ND filters detach it.