Dell Axim X51(Windows Mobile 5) Bluetooth Connection Instructions
Total Page:16
File Type:pdf, Size:1020Kb
Dell Axim X51(Windows Mobile 5) Bluetooth Connection Instructions The first time you acquaint an ENERAC analyzer with your PocketPC you must perform the following steps: Tap the Bluetooth icon to open On the Mode tab, make sure On the Device tab, tap New Your device will detect any the Bluetooth Settings screen. Bluetooth is ON. Partenership. Bluetooth devices nearby. Select the ENERAC you wish Tap Next. You will be Select Serial Port and Tap An entry for this ENERAC will to communicate with. prompted to add a Bluetooth Finish. now appear on the Devices The analyzer must be turned on to device. Tap Yes. tab. appear! Enter any number for the Passkey and then Next. On the COM Ports tab, Select Select the ENERAC you wish Unselect Secure Connection. The Bluetooth Commport is New Outgoing Port. to connect with. Port must be COM7. now mapped to this particular If you want to switch to another ENERAC, Tap Finish. Bluetooth ENERAC. you must first delete any COM7 connection that appears here (Tap-and-Hold). To Run Enercom Enercom will now connect to EnercomCE continues to run If Enercom stops responding, Tap Start, Programs, your ENERAC analyzer. on your PocketPC even after you can kill it by selecting, EnercomCE. you dismiss the program. Start, Settings, System tab, Memory, Running Programs When the Bluetooth connection tab, Enercom, Stop, OK. has been severed, due to: 1) Your PDA has powered Resetting the PDA is also an down, or effiective means of starting 2) Your ENERAC has fresh. Use the stylus to press been powered down, or the reset switch, located on the 3) You have gone back side. sufficiently out-of-range, Reinstate the connection, by tapping Connection, Reconnect. .