What You Need to Know About Discus Throw

ATHLETICS OMNIBUS - DISCUS THROW From the Athletics Omnibus of Richard Stander, South Africa DISCUS THROW Discus Throw is regarded as a strength event. The Discus Thrower is required to throw a saucer shaped implement called a discus as far as possible. Depending on the age and gender of the athlete the weight of the implement will vary between 1kg and 2kg. 1. THE COMPETITION AREA IMPLEMENT - The body of the Discus is made of wood or other suitable material, with a metal rim, the edge of which forms a true circle. Each side of the Discus must be identical and it must be made without indentations, projections or sharp edges. The diameter is 219mm for men and 180 to 182mm for women. THROWING CIRCLE - The inside diameter of the circle measures 2,50m. It is made of iron, steel or other suitable material and the top of it must be flush with the ground outside. The surface of the interior of the circle must be level and 20mm lower than the upper edge of the rim of the circle. The inside of the circle is made of concrete, asphalt or some other firm but not slippery material. THE DISCUS THROWING CAGE: The discus circle is surrounded by a cage to ensure the safety of officials, participants and spectators. On the ground it is shaped liked a letter C, with the diameter of its curved part being 7m and an opening of 6m, through which the throw is carried out. The height of the cage should be at least 3.35m THROWING SECTOR: The throwing sector is limited by the inner edges of lines from an angle of 400 at the centre of the circle. 2. THE 1½ TURN TECHNIQUE There is only one basic discus throw technique with individual variations within the technique, but the aim is always to deliver the discus with optimum speed and balance. The right-handed technique will be explained in all examples used in this book. The discus technique comprises of three phases: Swings turn and throw. A right-hand thrower performs 1½ turns to the left. The left leg is in front when the discus is thrown. 2.1. THE DISCUS THROWER SHOULD AVOID: 2.1.1. Falling backwards at the beginning of the turn. 2.1.2. Rotating on the spot (like a spinning top). 2.1.3. Bending the trunk forward (breaking at the hips). 2.1.4. Jumping high in the air. 2.1.5. Over tension in the legs. 2.1.6. A faulty foot placement in relation to the throwing line. 2.1.7. Carrying the body weight on the front leg and allowing it to collapse. 2.1.8. Anticipating the throw with the arm. This may include breaking at the hips and bending the trunk forwards or over balancing to the left). 2.2. THE DISCUS THROWER SHOULD AIM TO: 2.2.1. Get a good pivot. 2.2.2. Drive across the circle. 2.2.3. Get a good amount of torsion between the lower body and upper body. 2.2.4. Cover a good distance in the flight across the circle. 2.2.5. Land high up on the toes of the right foot and rotate actively on it. 2.2.6. Land with the right foot in the centre of the circle and the left one a little to the left of the throwing line. 2.2.7. When both feet are on the ground have the centre of gravity between both legs and resist with the front leg. 2.2.8. Time the arm pull with the moment that the shoulders are aligned with the hips. 2.3. THE GRIP The grip determines the position of the discus in flight. Held incorrectly, will lead to a poor flight, no matter how efficient the technique. Hold the discus only with the end finger joints (1) so that the finger pads are turned over the rim. The fingers should be comfortably and evenly spaced, as relaxed as possible. The discus rests against the base of the throwing hand (2). The hand will flex slightly inwards at the wrist, but the athlete must not pinch the discus with the wrist (2). The thumb rests on the discus (3) to give stability on release. It must not be lifted. The discus leaves the hand at the pointing finger turning clockwise. 2.4. THE SWING The athlete takes up position at the back of the ring with the toes almost touching it. Swing the discus as far behind to the right as possible, rotating the trunk at the same time (1). Do not force the hand to far back otherwise the centre of gravity will be outside the body stance, causing it to be off balance. The legs are in a straddle position, shoulder-width apart and the back is in the direction of the throw. Both knees are bending slightly (2). The right foot is flat on the ground, pointing in the opposite direction of the throw, and the left foot is on its toe. The weight is balanced over the right heel. The head is kept upright throughout the entire movement. Focus on the horizon to keep it upright. 2.5. PRELIMINARY SWINGS Preliminary swings can be taken to help the body relax and to feel the rhythm. The body-weight is being transferred rhythmically from the right foot to the left and back. The left knee must not bend too much towards the right knee. The right arm travel from back to front and back. Do not force the hand too far back to avoid a loss of balance. 2.6. THE TURN Push of forwards with the left leg, in a running action, in the direction of the throw when the left foot and face is pointing towards the direction of the throw (1). Keep the throwing arm as high as possible above hip height and behind the body (2). The free arm is in a relaxed position in front of the chest in line with the right arm behind the chess. The right leg is swung forward in a rotational motion, almost stretched, and close to the ground. The right foot is placed in the centre of the circle and the body weight is now supported by the right leg (3). The left leg takes the shortest possible route around the right leg to the front to develop the rotational speed of the delivery arm. Place left leg quickly and actively just in front of the edge of the circle (4) to land in the power position. The right knee is in front of the foot and the leg is leading the body. When the shoulders are facing the delivery area, the leverage of the right leg is shortened to enable it to be brought forward faster. The left foot must land very soon after the right foot. A late left foot will always result in a loss of range. The left arm is bent to facilitate the faster rotation. 2.7. THE POWER POSITION The weight is supported on the right leg in the throwing position. The right foot is in the centre of the circle and the left foot slightly of centre, to allow for room for the hips to drive through. (The right toe is in line with the left heel) The body is in the chin-knee-toe position leaning away from the direction of throw. The right heel must never touch the ground until the throw is completed. The hips are still leading the shoulders and the trunk is in a torque position. The throwing arm is dragging behind the body. The left arm is slightly bent. The eyes are looking away from the direction of throw. 2.8. THE THROW Only when both feet are on the ground, the throwing action can begin. From the power position the thrower should rotate on the ball of both feet. Turn the right foot in the direction of the throw. The foot will cause the knee to turn the hip to turn; the shoulder to turn and eventually the throwing arm to come through fast and relaxed. When the right hip turns towards the front (1), the right leg must be extended simultaneously. With the front foot now firmly grounded, extend the front leg (2) to gain maximum height, and bring the discus through at shoulder height. Keep the front foot on the ground as long as possible. As long as the front foot is on the ground, the right side will continue driving forward. Therefore it is important to time the extension of the front leg correctly. The shoulders must be kept level throughout the throw, especially during the final action. This can be achieved by maintaining the chin-knee- toe position. Keep the trunk upright. The left arm is dragging behind to delay the rotation of the shoulders, and then remain firm (blocked) during the final thrust of the right side of the body. It must not be allowed to sweep too far backwards. Finally the left leg is swung backwards and the feet interchange in order to maintain balance within the circle. Bend the right leg to lower the centre of gravity. The shorter the body, the easier it will regain balance. Given the correct sequence of movements, the reverse will automatically take care of itself and on no account should a reverse be conscientiously practised. 2.9. DELIVERY ANGLE Once the discus technique is mastered, the Angle Wind direction delivery angle needs attention. The discus is highly affected by the wind’s +/- 27º head wind speed and direction.

Load more