Gamecube XENO - Installation
..:: http://www.modchip-network.com ::.. GameCube XENO - installation In order to begin your ModChip modification you will need the following: • Low watt soldering iron (15-30 watt) with a fine tip • Solder • GameCube Security BIT Installation: • Remove with the Security BIT the 4 screws on the GameCube bottom side • Open the GameCube cover • Remove the GameCube drive • Put the XENO chip on the drive unit bottom side. Solder the red points to the drive unit board (for more information look at the following picture). ..:: http://www.modchip-network.com ::.. "PSX, PSone, PlayStation, PStwo, PlayStation 2, PS2, PlayStation3, PS3, PSP, PlayStation Portable" is a trademark of Sony Computer Entertainment Inc. "Xbox, Xbox 360, Xbox360, Xbox LIVE" is a Trademark of the Microsoft Corporation. "GameCube, GameBoy, wii, NDS, Nintendo DS" is a trademark of Nintendo Inc. This website is not affiliated with any of the console-producing companies such as Sony Computer Entertainment Inc., Microsoft Corporation or the Nintendo Inc. All other trademarks and registered trademarks are the properties of their respective owners. Copyright © MODCHIP-NETWORK.com - All rights reserved ..:: http://www.modchip-network.com ::.. ..:: http://www.modchip-network.com ::.. "PSX, PSone, PlayStation, PStwo, PlayStation 2, PS2, PlayStation3, PS3, PSP, PlayStation Portable" is a trademark of Sony Computer Entertainment Inc. "Xbox, Xbox 360, Xbox360, Xbox LIVE" is a Trademark of the Microsoft Corporation. "GameCube, GameBoy, wii, NDS, Nintendo DS" is a trademark of Nintendo Inc. This website is not affiliated with any of the console-producing companies such as Sony Computer Entertainment Inc., Microsoft Corporation or the Nintendo Inc. All other trademarks and registered trademarks are the properties of their respective owners.
[Show full text]