User Preferences

User Preferences

Set Default Parameter Scanning this bar code returns all parameters to the default values listed in Table A-1 on page A-1.

Set All Defaults

4-5 Symbologies

Transmit UPC-A/UPC-E/UPC-E1 Check Digit (Continued)

*Transmit UPC-E Check Digit

Do Not Transmit UPC-E Check Digit

*Transmit UPC-E1 Check Digit

11-17 LS 9208 Product Reference Guide

Keyboard Wedge Host Types

Keyboard Wedge Host Types Select your keyboard wedge host by scanning one of the bar codes below.

IBM PC/AT & IBM PC Compatibles1

IBM PS/2 (Model 30)

IBM AT NOTEBOOK

5-4 Symbologies

UPC-A Preamble (Continued)

System Character & Country Code (< COUNTRY CODE> ) UPC-E Preamble Preamble characters are part of the UPC symbol consisting of Country Code and System Character. Three options are given for transmitting UPC-E preamble to the host device: transmit System Character only, transmit System Character and Country Code (“0” for USA), and no preamble transmitted. Select the appropriate option to match your host system.

No Preamble ()

*System Character ( )

11-19 Miscellaneous Scanner Options

Transmit Code ID Character (Continued)

*None Prefix/Suffix Values A prefix/suffix may be appended to scan data for use in data editing. These values are set by scanning a four-digit number (i.e., four bar codes) that corresponds to key codes for various terminals. Code 39 Full ASCII to Full ASCII Coorelation is host-dependent, and therefore described in the “ASCII Character Set” Table for the appropriate interface. Numeric bar codes begin on page D-1 in Appendix D. If you make an error or wish to change your selection, scan Cancel on page D-5.

Scan Prefix

Scan Suffix

12-5 Numeric Bar Codes

5, 6, 7

5

6

7

D-3 Appendix D Numeric Bar Codes

0, 1

For parameters requiring specific numeric values, scan the appropriately numbered bar code(s).

0

1

D-1 Appendix D Numeric Bar Codes

0, 1

For parameters requiring specific numeric values, scan the appropriately numbered bar code(s).

0

1

D-1 LS 9208 Product Reference Guide

2, 3, 4

2

3

4

D-2 Miscellaneous Scanner Options

Scan Data Options To change the Scan Data Transmission Format, scan the Scan Options bar code below. Then select one of four options:

•Data As Is • • •

When you have made your selection, scan the Enter bar code on page 12-9. If you make a mistake, scan the Data Format Cancel bar code on page 12-9.

If you need to have a carriage return/enter after each bar code scanned, scan the following bar codes in order:

1. 2. 3. Enter (on page 12-9)

Scan Options

12-7 LS 9208 Product Reference Guide

Scan Data Transmission Format (Continued)

*Data As Is

12-8 Miscellaneous Scanner Options

Scan Data Transmission Format (Continued)

Enter

Data Format Cancel

12-9