Amendment C1 List of Changes to the Mornington Peninsula
Total Page：16
File Type：pdf, Size：1020Kb
Amendment C1 List of changes to the Mornington Peninsula Planning Scheme Clause Change Comment No(s) OVERLAYS 43.02 In Schedule 1 to the Design and Development Overlay under the Amends the schedule by reducing heading 2.0 Buildings and works, within the first paragraph, the area where a permit is schedules replace the words “in the area between Kangerong Avenue, required for a single dwelling. Domana and Boneo Road, Rosebud.” with “where land adjoins Point Nepean Road.” In Schedule 2 to the Design and Development Overlay under the Amends the schedule by heading 2.0 Buildings and works, replace the first paragraph with correcting an inadvertent error the following: created when approving the new Mornington Peninsula Planning “No permit is required to construct a building or construct or carry Scheme. out works associated with a single dwelling, dwelling extensions, an outbuilding or a fence provided the following requirements are met:” In Schedules 2, 3 and 4 to the Design and Development Overlay under the heading 2.0 Buildings and works, replace the words Amends the schedules by “New development must have a maximum building height of no correcting inadvertent errors more than 8 metres and must contain no more than 2 storeys above created when approving the new natural ground level, unless specifically stated in a plan approved Mornington Peninsula Planning under a schedule to the Development Plan Overlay. This Scheme and removes the absolute requirement cannot be varied with a permit.” with the following: building height for new development. “New development must have a maximum building height of no more than 8 metres, except in the area located to the north of a boundary defined by Ellerina Road West, Ellerina Road, the Nepean Highway, Bittern Dromana Road and Disney Street, and must contain no more than 2 storeys above natural ground level, unless specifically stated in a plan approved under a schedule to the Development Plan Overlay.” In Schedule 4 to the Design and Development Overlay under the Amends the schedule by heading 2.0 Buildings and works, in the first paragraph replace correcting inadvertent errors the words: created when approving the new Mornington Peninsula Planning “All buildings and works including a single dwelling, dwelling Scheme. extensions, an outbuilding or a fence must meet the following requirements: All buildings have a maximum wall height of 5.5 metres.” with the following: “No permit is required to construct a building or construct or carry out works associated with a single dwelling, dwelling extensions, an outbuilding or a fence provided the following requirements are met: All buildings have a maximum height of: 5 metres in the area west of Truemans Road and south of a boundary defined by the proposed Mornington Peninsula Freeway, Old Melbourne Road and Hotham Road. 8 metres in the area bounded by the Nepean Highway, Canadian Bay Road, The Moorooduc Highway and Humpheries Road. 6 metres in all other areas. No buildings and works are located on a ridge top.” In Schedule 4 to the Design and Development Overlay under the heading 2.0 Buildings and works, in the newly created fifth dot Amends the schedule by point in the first paragraph, replace the numbers “7.5” and “3” with correcting inadvertent errors the numbers “15” and “5” respectively. created when approving the new Mornington Peninsula Planning In Schedule 5 to the Design and Development Overlay under the Scheme. heading 2.0 Buildings and works, in the first paragraph after the first dot point insert the following: Amends the schedule by correcting an inadvertent error “No buildings and works are located on a ridge top.” created when approving the new Mornington Peninsula Planning In Schedule 5 to the Design and Development Overlay under the Scheme. heading 2.0 Buildings and works, replace the words “New development must have a maximum building height of no more Amends the schedule by than 8 metres and must contain no more than 2 storeys above removing the absolute building natural ground level, unless specifically stated in a plan approved height for new development. under a schedule to the Development Plan Overlay. This requirement cannot be varied with a permit.” with the following: “New development must have a maximum building height of no more than 8 metres and must contain no more than 2 storeys above natural ground level, unless specifically stated in a plan approved under a schedule to the Development Plan Overlay.” In Schedule 6 to the Design and Development Overlay under the Amends the schedule by heading 1.0 Design objectives, replace the seventh dot point with correcting an inadvertent error the following: created when approving the new Mornington Peninsula Planning Scheme. “To maintain lots of sufficient area to provide for racehorse training establishments in association with residential use in the vicinity of the Mornington racecourse and to provide additional protection to the Balcombe Creek.” In Schedule 6 to the Design and Development Overlay under the Amends the schedule by heading 2.0 Buildings and works replace the first paragraph with correcting an inadvertent error the following: created when approving the new Mornington Peninsula Planning “No permit is required to construct a building or construct or carry Scheme. out works associated with a single dwelling, dwelling extensions, an outbuilding or fence provided the following requirements are met:” In Schedule 7 to the Design and Development Overlay under the heading 1.0 Design objectives, replace the last two dot points with Amends the schedule by the following respectively: correcting inadvertent errors created when approving the new “To maintain lots of sufficient area to provide for racehorse Mornington Peninsula Planning training establishments in association with residential use and to Scheme. provide additional protection to the Balcombe Creek. To maintain the existing open landscape, which defines the Bittern township boundaries.” In Schedule 7 to the Design and Development Overlay under the Amends the schedule by heading 2.0 Buildings and works replace the first paragraph with correcting an inadvertent error the following: created when approving the new Mornington Peninsula Planning “No permit is required to construct a building or construct or carry Scheme. out works associated with a single dwelling, dwelling extensions, an outbuilding or a fence provided the following requirements are met:” LIST OF AMENDMENTS List of Insert: Updates list of amendments to the Amendmen Amendment number, “C1”, in operation from, DATE with the planning scheme. ts brief description: “Corrects anomalies in Schedules 1, 2, 3, 4, 5, 6,and 7 to the Design and Development Overlay and deletes reference to a maximum building height in Schedules 2, 3, 4 and 5 to the Design and Development Overlay.”.