Etap 30 Te Koop (2021-08-14)
Total Page:16
File Type:pdf, Size:1020Kb
Etap 30 £29,950 • Poole United Kingdom (UK) • Used • 1989 Presented by Details Nick Ward Make: Etap Phone: +44 7730331024 Clipper Marine Ltd Model: 30 Swanwick Marina Year: 1989 SO31 1ZL Southampton Condition: Used United Kingdom (UK) Hull: Fiberglass Engine: Volvo Penta 1989 Engine type: Inboard engine Fuel type: Diesel Length: 29.83 ft (9.09 m) Beam: 10.3 ft (3.14 m) Cabins: 2 Berths: 2 Clipper Marine 7zea.com Ltd 1/7 Powered by 7zea.com Description Etap 30 1989 railings. Etap style tubular anodised alloy toerail rubbing the length of The Etap 30 is regarded as the best yacht Etap produced, she the deck edge. was far ahead of her time in many respects including Stainless steel double stemhead roller. her easily-driven hull which was designed by Jac de Ridder, it Tubular anodised alloy cleats forward, midships and aft. was far and away ahead of most other 30ft cruisers when she Opening deck hatch providing access to anchor locker aft of was first launched in 1983,she handles delightfully on all windlass. points of sail and is still a fairly fast cruiser for her length. Deck stepped mast with all lines lead aft to cockpit on port and starboard sides. Down below she has five sea-berths, including a quarterberth, Genoa track and car mounted on inboard edge of side deck and a heads compartment amidships. The galley is spacious with control lines lead aft to cockpit. and useable. Banks of Spinlock rope clutches on port and starboard sided of companionway. This Etap 30 is on her berth here in Poole and is ready for Halyard winches mounted port and starboard sides of viewing, for any further information or to arrange a viewing companionway. please contact Clipper Marine Poole on 01202 916424 or email Moulded cockpit coamings with primary winches mounted [email protected] outboard. Bench seating on port and starboard sides of cockpit with CONSTRUCTION seating across transom, aft of tiller. Large cockpit locker below port cockpit seat with twin lids for access fore and aft. HULL Self-draining gas locker beneath seating, aft to starboard. Single piece GRP moulded hull. Lifting sole panel provides access to gearbox and fuel tank. GRP sandwich laminate construction with foam core. Moulded internal structural matrix and headlining. Tek Dek perma teak to decks. Plywood bulkheads located in internal moulded matrix. Bolt-on iron ballast keel with stainless steel keel bolts. Teak decking to cockpit. Spade rudder. Blue gelcoat finish to hull, cream gelcoat to decks MACHINERY Hull below waterline treated with Copper coat anti-foul. DECK Volvo Penta 18hp marine diesel. Single piece GRP moulded deck with integrated self-draining 2 cylinder, naturally aspirated, directly cooled. cockpit. Volvo Penta sail drive. Deck finished in cream coloured gelcoat. Engine serviced May 2019. Full bonded Perspex portlights. Stainless steel diesel tank. Perspex contoured deck hatches. Primary fuel filter with water separator. Moulded non-slip finished to coach roof. Non-slip panel finish to side decks and foredeck. Teak laid panels on plywood cockpit locker hatches port and starboard. 2 x batteries SAILS and RIGGING ACCOMODATIONS SPARS AND RIGGING Below deck the Etap has a distinctive modern finish. The interior joinery work being built of sappelle veneered marine Deck stepped, single spreader anodised alloy mast. plywood with stainless steel and alloy fittings and trims. A GRP Anodised alloy boom with single line reefing. moulding finishes the headlining throughout the interior. All standing rigging of 1x19 stainless steel. Soleboards are of the traditional teak and holly veneered Roller reefing system fitted on forestay for Genoa. plywood, all lifting to provide full access to the bilge. Block and tackle adjustable back stay. Rod kicker FOREPEAK – All lines lead aft to cockpit. Spinlock rope clutches. Accessed through the heads compartment. Two single berths Genoa track and car system, control lines lead aft to cockpit. in the traditional V-berth configuration. Infill section to create Easy Block double purchase mainsheet system with adjustable large double bunk when required. Shelves running the length track and car. of the bunk overhead, outboard, port and starboard. Lined bin type lockers beneath bunks aft. Opening Perspex deck hatch WINCHES to provide light and ventilation. Primary Winches – 2x Lewmar 16, two-speed. Secondary Winches – 2x Lewmar 16, two-speed. HEADS SAILS Compartment spanning full width of the boat immediately aft Mainsail – Lucas 7/8 fractional Rig reefing x 3 of forepeak. Jabsco manual marine toilet to starboard, inboard Genoa – White Dacron, Roller reefing. facing. Wash hand basin and vanity unit outboard to port. A hanging and shelved locker is provided outboard of the heads. ON DECK SALOON Tubular anodised alloy pulpit and pushpit rails. Deck mounted alloy stanchions supporting stainless steel Centrally located, double dropleaf table. Bench settee on port guard wires, guard wire gate on transom between pushpit side, converting to single bunk when required. L-shaped settee 2/7 Powered by 7zea.com to starboard, converting to compact double. Storage lockers General information provided behind seat backs with shelves outboard of seating. Overhead lockers provided outboard port and starboard, running the length of the settees, upholstery re- upholstered 1 Make: Etap year ago Model: 30 GALLEY Year: 1989 U-shaped galley. Gimbal mounted Nelson gas cooker fitted Condition: Used 2017. Stainless steel sink forward with top loading fridge Hull: Fiberglass outboard of sink. Selection of lockers provided outboard of worktop and below sink unit. Engine CHART TABLE AND QUARTER BERTH Forward facing chart table with navigator using forward Engine: Volvo Penta 1989 section of quarter berth as a seat. Chart storage provided Engine type: Inboard engine within table, selection of drawers beneath. Ships switch panel and navigation instruments mounted outboard. Quarter berth Fuel type: Diesel extending aft from chart table along starboard side. INVENTORY Measurements NAVIGATION INSTRUMENTATION Length: 29.83 ft (9.09 m) Beam: 10.3 ft (3.14 m) Depth – Nasa Clipper Log – depth and Speed Nasa Clipper Deep: 4.8 ft (1.46 m) Plotter – Garmin 415 (mounted at chart table) Raymarine - AutoPilot Navtex – Target Navtex Pro Plus Accommodation VHF – Silva S15 VHF Cabins: 2 Spray Hood Berths: 2 Sail Cover Hot water Calorifier (new) Rutland Wind generator Shore Power Battery charger Nikkai 600W inverter Anchor x 2 with galvanised chain Fire extinguisher (saloon) Disclaimer The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice. 3/7 Powered by 7zea.com Images Etap 30 Etap 30 Etap 30 Etap 30 Etap 30 Etap 30 4/7 Powered by 7zea.com Etap 30 Etap 30 Etap 30 Etap 30 Etap 30 Etap 30 5/7 Powered by 7zea.com Etap 30 Etap 30 Etap 30 6/7 Powered by 7zea.com Clipper Marine Ltd Swanwick Marina SO31 1ZL Southampton United Kingdom (UK) Phone: +44 7730331024 https://www.clippermarine.co.uk 2021-10-02 Powered by TCPDF (www.tcpdf.org).