How to Render Lard (Pork Fat) and Tallow (Beef Fat) By Tiffany

Supplies 1-2 lbs pork fat (leaf fat is preferred, runner up is back fat), or Beef Suet ½-1 cup water heavy stock pot or cast iron skillet canning funnel (optional, but handy) fine mesh sieve lined with cheesecloth or a coffee filter wide-mouth glass jars for storage

Trim excess meat and blood from the fat. (Leaf fat will be mostly white; back fat will have a pinkish tint.)

Place the fat and water into the pot and turn the heat on medium low.

Cook the fat on a solid simmer, stirring often and adjusting heat as necessary. Remember that hot fat will sputter as it cooks and in water, so try to keep the heat on the lower end for your own safety. After 30 minutes or so, the fat will begin to melt. You will see spots where the fat is floating in the water. (My water had seemed to have completely evaporated at this point, a bit too early. So I covered the fat with a clear lid and add more water.)

After 45 minutes, the fat will begin to brown and continue to cook down. When you have anywhere from ½” to 1” of liquid fat, begin to strain some out (see note below). This will help keep the fat cooking and reduce any sputtering you may have. The lid is also helpful for keeping the sputters headed away from you. The fat will have a tint of yellow but should turn white as it cools.

Continue cooking the fat and ladling out the liquid as the fat cooks down. When the remaining fat becomes dark golden brown, you are done. These solids are called cracklings and can be toasted in the oven before adding to salads or snacking.

My straining contraption: This is my basic set-up for all my straining needs… kefir, yogurt, chicken stock… it’s so easy and all I had to do was add a coffee filter for today!

1. Use a wide-mouth jar (the jar in the picture is a pint, but I use quart-sized for yogurt and broth). 2. Place a canning funnel in the jar (I use the one from this kit). 3. Lay a fine mesh sieve inside the funnel. 4. Line the sieve with a coffee filter.

Other Helpful Hints and Observations:

• I started the project with just over one pound of fat (1lb and 3oz, to be exact) and I now have just over ¾ of a pint jar of lard, or 12oz or so. • The whole process took about one hour. I imagine it going a bit faster the next time though now that I Allow the jar of lard to cool to room temperature. Lard can be know where the heat needs to be for the fat to stored at room temperature for awhile, but the fridge should be properly cook (I actually started out with my heat too used if you’re not sure when you plan to use it next. Lard can be low). stored in the freezer indefinitely. • Know that your house will smell like either pork or beef, depending on the fat you are rendering. Opening the windows certainly helps, as does the quality of fat (ex: leaf lard will smell less “porky” than back fat).