Intercom 2018 Booth # C768
Total Page:16
File Type:pdf, Size:1020Kb
m oM InfoC INTERCOM 2018 Booth # C768 DiNET DAN-TX2 + DAN-RX2 2-Channel Dante Interfaces The Radial DiNET™ DAN-TX2™ transmit- ter and DAN-RX2™ receiver are expanded versions of the DAN-TX and DAN-RX Dante interfaces. Featuring Neutrik Ethercon con- nectors demanded by professional touring clients, both boxes deliver 24bit/96kHz res- olution across any network using the Dante protocol. Read More pg. 3 Radial Presenter Compact mixer for presentations Read More pg. 3 Catapult Mini Analog Audio Over Cat 5 The Radial Catapult Mini™ is the latest ad- dition to the Catapult modular snake sys- tem, which allows you to drive four analog audio channels over a single shielded Cat 5 cable. This eliminates the need for bulky and expensive multi-pair audio cable runs, and allows contractors to take advantage of pre- wired networks to connect from one room to another. Read More pg.2 New ISO-MAX Isolators Jensen quality for any application Read More pg.4 Hafler CI-1255e Multi-Channel Power Amp Hafler CI-1255e™ multi-channel amplifier is designed to sound good, save money, last a long time and be simple to use. These are the cornerstones of what make Hafler such a compelling choice for today’s most demanding system integrator. Read More pg.5 New! Hercules Impact-resistant panels Read More pg. 6 Backtrack Stereo Backing Track Switcher The Backtrack™ is a stereo audio switcher designed for bands using redundant playback de- vices on stage. The primary and backup playback devices are both connected to the Back- track using dual ¼” TRS connectors or stereo 3.5mm inputs, with XLR outputs feeding the PA system. Should the primary playback device fail, an input select switch on the front of the Backtrack allows you to quickly switch to your backup devices to ensure your live per- formance is unaffected. A JR-2™ remote footswitch can be connected, giving you the ability to switch inputs or mute from anywhere on stage. The Backtrack also includes a headphone section with a dedicated level control and a cue select switch, so you can check each playback device silently without affecting the send to the PA. With the Backtrack in your setup, the show will always go on. Mains MAIN OUT RIGHT LIFT LEFT/ MONO 15 VDC (A) RIGHT LEFT MONITOR OUT INPUT B INPUT A TM BACKTRACK STEREO BACKING TRACK SWITCHER (B) HEADPHONES B INPUT SELECT MUTE SELECT PHONES A A B MIN MAX REMOTE IN 3.5mm A B LEVEL INPUT Part# R800 8102 00 MAP $349.99 USD Monitors Now Shipping Catapult Mini Analog Audio Over Cat 5 The Radial Catapult Mini™ is the latest addition to the Catapult modular snake system, which allows you to drive four analog audio channels over a single shielded CAT 5 cable. This eliminates the need for bulky and expensive multi-pair audio cable runs, and allows contrac- tors to take advantage of pre-wired networks to connect from one room to another. The Catapult Mini TX™ and the Mini RX™ can be used together as a pair, or they can be individu- ally matched with any other Catapult stage box. For instance, you can use a Catapult TX4M™ on stage to split four mic lines to feed the monitor console, while utilizing a Catapult Mini RX to receive the signal at the FOH console. Catapult Mini TX Catapult Mini RX 1. Mini TX to Mini RX Part# R800 8028 00 Part# R800 8029 00 Simply send four channels over MAP TBA MAP TBA Shipping Summer 2018 Shipping Summer 2018 Cat 5 with the Catapult Mini TX Cat 5 and RX. CATAPULT MINI CATAPULT MINI 2. TX4M to Mini RX The isolated outputs of the TX4M allow you to feed a monitor con- sole while also splitting the signal to a Mini RX for FOH Catapult TX4M™ isolated outputs to monitor console Catapult Mini RX™ outputs The full size Catapult Cat 5 to FOH console is available in six dif- ferent configurations CATAPULT TX4M CATAPULT MINI with choice of direct or isolated outputs. ® Radial Engineering Ltd. © Copyright 2018 all rights reserved Specifications, appearance and price subject to change without notice. pg.2 Artist Update Presenter USB Mixer and Mic Preamp The Presenter™ combines a microphone preamp and a USB program input to create Vivek Maddala the ultimate interface for any presentation, Composer/Producer from school lectures to corporate audio. An XLR mic input allows you to connect a podi- um microphone and provide it with phantom “My go-to DI these days is the Radial JDV- power. The mic signal can then be adjusted Pre™. It sounds great and fits nicely with the using low and high EQ controls to tailor the rest of the gear in my WR8™ chassis.” frequency response. A program input level controls the volume of the USB input or the 3.5mm jack on the front of the unit, so you can connect the outputs of your laptop, Jim Heath Singer/Guitarist smartphone, or MP3 player and blend it with The Reverend Horton Heat the signal from the microphone. XLR outputs provide balanced feeds for a set of powered “The Elevator™ pedal is an integral part of speakers, making it an all-in-one portable so- R800 8011 00 lution for any speaking engagement. MAP $299.99 USD my fly rig. I can’t take my amps on those gigs Now Shipping but at least I can get a little familiar dirt with the Elevator.” XLR USB Troy McLawhorn Guitarist Evanescence, Dark New Day, Seether 3.5mm “The JX-44™ switcher is completely trans- parent. I can adjust my levels with trim con- trol on each input, and the signal going to each component is clean, no buzz or noise at all. Thanks Radial.” DAN-TX2 + DAN-RX2 2-Channel Dante Interfaces The DAN-TX2™ features XLR combo, RCA, DAN-TX2 Leland Sklar and 3.5mm analog inputs, with separate trim Bass Player controls for both channels. The DAN-RX2 is Phil Collins, Warren Zevon, James Taylor, Jackson a 2-channel endpoint device, with Ethercon Browne, Toto network input and XLR outputs. It also in- cludes a powerful headphone amplifier with “The Radial Firefly™ is a wonderful addition both ¼” and 3.5mm outputs and local vol- to my studio and touring rig.” ume control. The chassis design of the DAN- TX2 and DAN-RX2™ is perfectly suited to be used anywhere, whether it be on a stage DAN-RX2 floor or a meter bridge, and one or two units Carl Harvey can be rack mounted in a single space using Guitarist Radials optional SA series rack adaptor. Toots & the Maytals, Messenger, The Aggrovators “The Texas-Pro™ is a great overdrive pedal DAN-TX2 DAN-RX2 and built like a tank. The clean boost func- Dante Network tion is great, as I don’t want to change my tone but need just a little extra push to peek out of the mix. Tonebone, you’ve got anoth- er winner.” Part # R800 1064 00 Part # R800 1065 00 MAP 449.99 USD MAP 449.99 USD Shipping Summer 2018 Shipping Summer 2018 ® Radial Engineering Ltd. © Copyright 2018 all rights reserved Specifications, appearance and price subject to change without notice. pg.3 ISO-MAX PI-RJ2X + CI-RJ2R Jensen Quality Audio Over Ethernet Sending line level audio over Cat 5 / Cat 6 ethernet cables is a com- mon and widely used practice in A/V industry today. Up to now, sys- tem installers have been using products based upon low cost and low performing baluns, or inexpensive audio transformers. Baluns offer no high frequency isolation, and miniature, low cost audio trans- PI-RJ2X formers can seriously degrade the signal quality. Jensen Transform- MAP 269.99 Shipping Summer 2018 ers solved this problem with a transmitter/receiver combination that maintains true high-performance signal quality throughout the con- version process. There are two versions available in Jensen’s award winning ISO- MAX® product line: the PI-RJ2X for balanced XLR connections, and the CI-RJ2R for unbalanced RCA connections. The Jensen audio transformers inside each version provide complete galvanic isola- tion and immunity from hum, buzz and noise caused by ground loops, while maintaining the highest audio quality demanded by the install- CI-RJ2R er’s customer. MAP 209.99 Now Shipping ISO-MAX DIN-LI-SUM New DIN Rail Interface Modules DIN-LI-SUM-U Jensen transformers is announcing two new models in their ISO- MAP 139.99 Shipping Summer 2018 MAX line of 35mm DIN rail interface modules: the DIN-LI-SUM-B and the DIN-LI-SUM-U. Both modules are designed to take a ste- reo L-R signal (either balanced or unbalanced), sum it into mono, and output the signal through one of Jensen’s world famous audio transformers. These provide complete isolation and immunity from hum and buzz caused by ground loops, while maintaining the highest audio quality demanded by the installer’s customer. These modules can be easily installed by A/V system contractors into rack or wall mountable 35mm DIN Rail systems. Both have gold plated, screw terminal, pluggable connectors for ease of installation and service. DIN-LI-SUM-B MAP 139.99 Shipping Summer 2018 A schematic diagram showing the actual internal circuitry is printed on the side of each module; no need to hunt for manuals in the middle of a wiring job. ® Radial Engineering Ltd. © Copyright 2018 all rights reserved Specifications, appearance and price subject to change without notice. pg.4 12-Channel Multi-Zone Power Amp New Multi-channel Amp for Custom Installations The Hafler CI-1255e™ is an innovative 12-channel amplifier designed for multi-zone custom homes as well as numerous demanding commercial sound installations such as restaurants and social houses, where high performance audio and reliability is required .