Owner's Manual Blu-Ray Disctm Home Theater Sound System
Total Page:16
File Type:pdf, Size:1020Kb
SC-BTT770_370_270P_eng.book 1 ページ 2011年2月28日 月曜日 午後1時25分 Owner’s Manual Blu-ray DiscTM Home Theater Sound System Model No. SC-BTT770 SC-BTT370 SC-BTT270 SC-BTT273 The illustration shows the image of the unit SC-BTT770. Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. Before connecting, operating or adjusting this product, please read the instructions completely. Please keep this manual for future reference. If you have any questions contact U.S.A. and Puerto Rico : 1-800-211-PANA(7262) Canada : 1-800-561-5505 P PC PX VQT3D27-4 until 2011/04/04 SC-BTT770_370_270P_eng.book 2 ページ 2011年2月28日 月曜日 午後1時25分 THE FOLLOWING APPLIES ONLY IN THE U.S.A. [BTT770] FCC Note: THE FOLLOWING APPLIES ONLY IN THE U.S.A. This equipment has been tested and found to comply with the limits for a FCC Note: Class B digital device, pursuant to Part 15 of the FCC Rules. This equipment has been tested and found to comply with the limits for a These limits are designed to provide reasonable protection against Class B digital device, pursuant to Part 15 of the FCC Rules. harmful interference in a residential installation. This equipment These limits are designed to provide reasonable protection against generates, uses, and can radiate radio frequency energy and, if not harmful interference in a residential installation. This equipment installed and used in accordance with the instructions, may cause harmful generates, uses and can radiate radio frequency energy and, if not interference to radio communications. installed and used in accordance with the instructions, may cause harmful However, there is no guarantee that interference will not occur in a interference to radio communications. particular installation. If this equipment does cause harmful interference to However, there is no guarantee that interference will not occur in a radio or television reception, which can be determined by turning the particular installation. If this equipment does cause harmful interference to equipment off and on, the user is encouraged to try to correct the radio or television reception, which can be determined by turning the interference by one or more of the following measures: equipment off and on, the user is encouraged to try to correct the ≥ Reorient or relocate the receiving antenna. interference by one or more of the following measures: ≥ Increase the separation between the equipment and receiver. ≥ Reorient or relocate the receiving antenna. ≥ Connect the equipment into an outlet on a circuit different from that to ≥ Increase the separation between the equipment and receiver. which the receiver is connected. ≥ Connect the equipment into an outlet on a circuit different from that to ≥ Consult the dealer or an experienced radio/TV technician for help. which the receiver is connected. ≥ Consult the dealer or an experienced radio/TV technician for help. FCC Caution:To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when FCC caution: To maintain compliance with FCC regulations, shielded connecting to peripheral devices. Any changes or modifications not interface cables must be used with this equipment. Operation with expressly approved by the party responsible for compliance could void the non-approved equipment or unshielded cables may result in interference user’s authority to operate this equipment. to radio and TV reception. Any changes or modifications not approved by the party responsible for compliance could void the user’s authority to This device complies with Part 15 of the FCC Rules. operate this equipment. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and This device complies with Part 15 of the FCC Rules. (2) this device must accept any interference received, including Operation is subject to the following two conditions: interference that may cause undesired operation. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including Responsible Party: interference that may cause undesired operation. Panasonic Corporation of North America One Panasonic Way Responsible Party: Secaucus, NJ 07094 Panasonic Corporation of North America One Panasonic Way, Secaucus, NJ 07094 Support Contact: Panasonic Consumer Electronics Company Support Contact: Telephone No.: 1-800-211-PANA (7262) Panasonic Consumer Electronics Company Telephone No.: 1-800-211-PANA (7262) THE FOLLOWING APPLIES IN THE U.S.A. AND CANADA This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation WARNING: of this device. To satisfy FCC RF exposure requirements for mobile transmitting devices, Contains FCC ID: RYYWYPAEBUX4 a separation distance of 20 cm or more should be maintained between the Contains IC:4389B-WYPAEBUX4 antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. recommended. The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter. This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range. FCC and IC require this product to be used indoors for the frequency range [BTT770] 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems. High power radars are allocated as THE FOLLOWING APPLIES ONLY IN CANADA. primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These This Class B digital apparatus complies with Canadian ICES-003. radar stations can cause interference with and/or damage this product. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) [BTT770] [BTT370] Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC For Canada, for units with PX printed on the packaging radio frequency (RF) Exposure rules. This equipment has very low levels of For main unit RF energy that it deemed to comply without maximum permissive exposure Product Identification Marking is located on the bottom of the unit. evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles). [BTT770] For wireless system Product Identification Marking is located on the bottom of wireless system. For units with PX printed on the packaging For main unit This unit is intended for use in moderate climates. VQT3D27 2 SC-BTT770_370_270P_eng.book 3 ページ 2011年2月28日 月曜日 午後1時25分 THE FOLLOWING APPLIES ONLY IN THE U.S.A. AND IMPORTANT SAFETY CANADA. INSTRUCTIONS CAUTION Read these operating instructions carefully before using the unit. Follow the RISK OF ELECTRIC SHOCK safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference. DO NOT OPEN 1 Read these instructions. CAUTION: TO REDUCE THE RISK OF ELECTRIC 2 Keep these instructions. 3 Heed all warnings. SHOCK, DO NOT REMOVE SCREWS. 4 Follow all instructions. NO USER-SERVICEABLE PARTS 5 Do not use this apparatus near water. INSIDE. 6 Clean only with dry cloth. REFER SERVICING TO QUALIFIED 7 Do not block any ventilation openings. Install in accordance with the SERVICE PERSONNEL. manufacturer’s instructions. The lightning flash with arrowhead symbol, within 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. an equilateral triangle, is intended to alert the user 9 Do not defeat the safety purpose of the polarized or grounding-type plug. to the presence of uninsulated “dangerous A polarized plug has two blades with one wider than the other. voltage” within the product’s enclosure that may be A grounding-type plug has two blades and a third grounding prong. The of sufficient magnitude to constitute a risk of wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of electric shock to persons. the obsolete outlet. 10 Protect the power cord from being walked on or pinched particularly at The exclamation point within an equilateral triangle plugs, convenience receptacles, and the point where they exit from the is intended to alert the user to the presence of apparatus. important operating and maintenance (servicing) 11 Only use attachments/accessories specified by the manufacturer. instructions in the literature accompanying the 12 Use only with the cart, stand, tripod, bracket, or table appliance. specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 13 Unplug this apparatus during lightning storms or when unused for long periods of time. 14 Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. WARNING Unit To reduce the risk of fire, electric shock or product damage, – Do not expose this unit to rain, moisture, dripping or splashing. – Do not place objects filled with liquids, such as vases, on this unit. – Use only the recommended accessories. (Inside of product) – Do not remove covers.