FMA Uniform Pattern
Total Page:16
File Type:pdf, Size:1020Kb
Fullmetal Alchemist Arrows show grain direction. Dotted lines show fold line. Roy Mustang Military Uniform Manga version made by pandamajik animeinsights.com Butt cape - you will need 4 of these - this is for the belt, you will need just one of these as you will be folding it in half (interface only half of it) 14 “ 40 “ 4 “ All pieces for the butt cape should be interfaced using medium weight interfacing. I had the two halves connect at a length going down 9 “ from the top. That is also where the triangle should be positioned. The square in the front should also be lined up with this point (approx. 9 ” from the top). The 9 “ that I’m referencing is before adding the belt. 29 “ 21 “ Jacket - make 2 of each of the front pieces, 4 of the back Sleeve - use medium interfacing for the front - make 4 of these, 2 for each arm - these measurements are for me, you might have to alter some numbers - again, these measurements are for MY arm - pay careful attention when making the collar - not everyone has the same neck - double check your own measurements - the sleeve area could also cause some problems although the way it’s made should give plenty of room 16 “ 3 “ Front Right Panel 4 “ 6 “ center line center 2 “ 5 “ 1 “ 2 “ 3.5 “ 1 “ 2 “ 9 “ 16“ 17 “ 10 “ 7 “ 10 “ 9 “ 6 “ Front Left Panel line center 3.5 “ Collar - make 2 of these - use heavy interfacing 16 “ 13 “ 9 “ 6 “ 3.25 “ 7 “ 3.5 “ Epaulet - need 2 (one for each side) - I made them just one layer thick 9 “ - extra fabric on the side, sew under 4.5 “ 6 “ 1/8 “ 1/4 “ Back Panel 2 “ 6 “ line center Cu 3.5 “ - need 4 of these, 2 for each arm - use heavy interfacing 8.5 “ 9 “ 2 “ 18“ 1 “ 10 “ 10 “ 7 “ 9 “ Project: Roy Mustang Military Uniform Author: pandamajik Date: 2/7/2011 Scale: 1/1.