Shell Angels (shellItems body) needed (quantity per creation) • 1 shell • Felt or card • 1 large bead • Glue • Wire • Thread • Permament marker

Optional • Embellishments Instructions

1. Start by gluing the large bead to the shell. Ensure the hole of the bead is pointing up. You will need it for the halo. 01

2. Next draw two wings onto a piece of card or felt and cut them out. Glue them onto the back of the .

3. Draw two eyes and a mouth onto the bead. Use a small piece of wire bent into a circle shape around a stick to make the halo and glue it into place. Hanging the angel

If you want to hang your angel you will need to add a thread 02 loop to the top of the angel

03

Something to do oscn.nz/activities page 1 Shell Angels (shellItems wings) needed (quantity per creation) • 2 shells • Felt or card • 1 large bead • Glue • Wire • Thread • Permament marker

Optional • Embellishments Instructions

1. Start by gluing the large bead onto the two shells, these will become the wings. Ensure the hole of the bead is pointing up as you will need it for the halo. 01

2. Next cut a quarter of a circle out of your felt or card and roll into a cone. This will become the body.

3. Cut off the top of the cone and glue to the base of the bead.

4. Draw two eyes and a mouth onto the bead. Use a small piece of wire bent into a circle shape around a stick to make the halo and glue it into place. Hanging the angel 02

If you want to hang your angel you will need to add a thread loop to the top of the angel however this angel should stand on its own.

03 04

Something to do oscn.nz/activities page 2