DOMINFO) Data Sheet
Total Page:16
File Type:pdf, Size:1020Kb
vR.i98-9_ Ol ~ Tasmania Department of Mines-Unpublished Report 1989/07 A Guide to the Department of Mines Publications (DOMINFO) Data Sheet. by P K. Wrigley Abstract CFRFOF The DOMINFO data sheet is designed to summarise all basic This indicates the confidentiality status of the report and detailed information presented in a report. Following (CF=closed file, RF=restricted me, OF~open file). computerisation, the DOMINFO data base will enable initial literature surveys without the need to search through BiblWgraphic Section numerous reports. AUTHOR(S) The format and application of the data sheet. and standard lists of recommended keywords, is presented. The name(s) of author(s) as listed in the report. The authors.' surname is listed fIrst; initials second. Co-authors are separated by a semi-colon. Where the name of the author is INTRODUCTION not listed anywhere in the report, 'anon' is used. As part of the Mt Read Volcanics Project, all Department of DATE Mines reports are being indexed for input into acomputerised data base. The month and year as on the title page. Fonnat: Month,Year. This explanatory report has been prepared as a guide to data TITLE formats and indexing conventions for compilers of data sheets. The title of the report. exactly as shown on the title page. DIVISIONIBRANCH THE DOMINFO DATA SHEET The name of the Division or Branch that produced the report. The data sheet is illustrated in Figure 1. The fonnat of information recorded on the data sheet, category defInitions CLIENT and compilation methodology. where applicable, are outlined below. The name of the company or institution which commissioned the investigation is listed (if any). Where the investigation is Report Number perfonned on a mineral tenement, the licensee/lessee is indicated by an asterisk. A semi-colon is used to separate Each report is assigned a unique number, prefixed by an names. abbreviation which indicates the publication series. Standard fonnats are detailed in Table 1. FORMAT The number of volumes comprising a report, and the content, Table l.List ofstandard abbreviations/or publicalionseries. e.g. pp, appx, fig, tables, plates, plans (recorded in that order). Abbreviation Publication Type OTHER REF. GSBXXX Geological Survey Bulletin The licence or lease number. job number. company reference, GSMRXX Geological Survey Mineral Resources etc. Standard formats for mineral tenements are shown in GSPXX Geological Survey Paper Table 2. GSRECXX Geological Survey Record GSREPXX Geological Survey Report Table 2. Standard/ormats/or mineral tenements. UGWSPXX Underground Water Supply Paper TRXX/XX Technical Report URYYYYrxxx Unpublished Report EL XXX/YY ML XXXXP/M MISCXXX Miscellaneous Publication AP XX/YY ML XXXXX/M ERSK55IX Geological Atlas 1:250 000 Series SPL XXX ML XXXXJYYM Explanatory Report SL XX ML XXXM/YY XXAP/AM ML ERXXXXN Geological Atlas 1 Mile and AM XXXM/YYYY XXXX ERXXXXS ) 1:50 000 Series Explanatory RelX'rt ETA XXXX GL XXXX/G CONSR YYYyrxxx Consultant Report RL YYXX GL GL Xxxx/yyG DOMAR YYYY/YYY Director of Mines Annual Report ML XXXX DOMARYYYY ) Or Secretaty of Mines Annual Report ML XXXXM UNPUBUSHED REPORT 1989107 REPOAT DEPARTMENT OF MINES-TASMANIA NUMBER DOMINFO OCF ORF OOF DATA SHEET AUTHOR(S): DATE: TITLE: DIVISION/BRANCH: CLIENT: FORMAT; No. of Volumes; ___ Structure: OTHER REF. (if any): LOCALITY: SK55- 01 02 03 04 05 06 07 o B MAP SHEET: GEOGRAPHIC: Defined area: AMG CO<lADS: Centroid: ______ mE 5 ______ mN 1. mE5 mN 2. mE5 mN 3. mE5 mN 4. mE5 mN 1000 GEOLOGY 200 0 GEOPHYSICS <CO 0 GEOCHEMISTRY 600 [J M•. PROCJMET AlLURGY 9000 MINING 1_ Regional "NO AIR I ~ S"';'"",,,,, """ 1_ EqU_1 2 _ Economic I' , Soil 2 Sample preparation 2I§~- Fttasibility 3 _ Petrologylmill8l'aJogy ,r- ,r- Rock-chip , 'a4 Electromag.Mag"". ,r- Size Classification 3 Production Slats. 4r- StraligJsed"lmentol. 5r- 6 Radiometric Minerai' n/ore ,_ Gravity separation 4 Rehabilitation 5 r- Structure ,r- S.P./A.P.IE.P. 5- Whole rocil: major 5_ Maptic separation 850 0 MINING ENGINEERING 6 r- Palaeontology 8r-r- HP./M.I.P. ,- Whole rock: trace 6 Electrostatic separation 7 r- Qre/Pelrogenesis 9 Resistivity ,- Mineral analysis FIctltioo , Safety ,- '- Pyrome4aHurgy '== Geochronology lOr- "...my 3 Hoisting & Shafts 11r- Seismic-Refraction W,,,, '-9 Hydrometallurgy .~- ENGINEERING GEOL. ,- • Equipment & Transptn. 1200 ,= B"logeochemistry 10- 12 ~ Seismic-Rellection 10 _ - S Ventilation II_ Sam~;",_ 11 Plant"""- optimisation 2 Site Investigations 13r- "",,",_ 8 Blasting 14 WeI-logging 3 Geomechatlics "- 700 0 COMMODITIES 0000 MISCEllANEOUS , SoiIo XlO 0 ANAlYTICAL CHEM & 500 0 DAllLiNG r-5 Wastes MATERIALS TESTS 2 Industrial Minerals 2 OccupatiOnal Health 140 0 HYDROGEOLOGY 2.~.- IndUS!. products , 3.~- Construction Materials .~--3 Research & 0eveI0pmt I Grdwtr surveys 3 IndUS!. wastes 3.~- Auger 4 Fuels: CoaUPeaI 4 Minetal Economics , -logs 2a Grdwtr quality 4 XAD 5 Fuels: oI08Ig (onshore) 5' Environmenlallmpact 3 Grdwtr management 5 Physical properties 5 Analysis , F,ol, ~g 1-'1 8 Infonnatkm Systems OTHER KEYWORDS: MINERALS: MINE/DEPOSIT NAME(S): ANNOTATION/ABSTRACT: K 7213 I C. C~~TE~, Acllng Govemm",nl Ponl"". Tasmania Figure 1. The DOMINFO data sheet. UNPUBLISHED REPORT 1989/07 2 Topographic Section 104 Stratigraphy/Sedimenlology 105 Structurel06 Palaeonlology LOCALITY: SKSS- 107 Ore/Petrogenesis 108 Geochronology The relevant 1:250 000 scale map sheet(s) (I to 8) should be indicated. Note that 1 :250 000 sheet boundaries bisect These keywords should be used sparingly and limited to I: 100 000 sheets (see fig. 2). reports which deal with the particular topic in detail. Specific descriptors are placed in the Other Keywords field where MAP SHEET applicable. The numbers of the relevant 1:50 000 map sheet(s), and the 120 Engineering Geology map sheet name(s) are recorded (e.g. 8014-3 Rosebery). Where a regional or general report covers a wide area, the This category is indexed whenever a sub-category is 1: 1 000 000 sheet numbers and names should be recorded if indicated. It may also be indexed in its own right when the possible. topic covered is not applicable to any coded sub-category, in which case a specific descriptor should appear in the Other Note: The 1:50 000 sheets are numbered 1-4, clockwise from Keywords field. the north-east quadrant (see fig. 2 and Appendix I). 121 Slope Stability GEOGRAPHIC This field is used for landslide and general stability The names of nearby town(s), mountain(s}, river(s) etc. are investigations. It also includes rock slope stability of various recorded to aid rapid visualisation of the area concerned. The types, including quarries and open-cut mines. geographic features should be named in accordance with the nomenclature used on the Tasmap 1:100 000 topographic 122 Site Investigations map series. The site investigations category is used for foundation Standard abbreviations in use include: investigations of dams, buildings, bridges, roads. railway~ R=River, Ck=Creek, Rvt=Rivulet, Rd=Road, Pk=Peak, and pipelines etc. Mt=Mountain or Mount, Pt=Point. 123 Geomechanics AMGCO-ORDS This category includes rock and soil mechanics. It includes Used for reports on specific areas (smaller than 1:50 000 map material properties. testing and stability analysis. sheet areas). 124 Soils Exploration Section Soil mapping and properties are included here. Geodata projects and erosion studies are also included in this category. CODED KEYWORDS 125 Wastes Each category in this section has a unique identifiable number for computer input purposes. The subjects indicated form the This category is used for investigations into the engineering basis for indexing the report. It is imperative that all relevant geological aspects of the disposal of urban, toxic and subjects are recorded. radioactive wastes. 100 Geology 140 Hydrogeology This category is indexed whenever a sub-category is indexed. The comments provided for 120 Engineering Geology are It may also be indicated in its own right when the topic applicable here. covered is not applicable to any coded sub-category, in which case a specific descriptor should appear in the Other 141 Groundwater Surveys Keywords field. This category is used for groundwater prospecting. It includes 101 Regional regional scale investigations as well as individual bore siting. All forms of surface geological mapping (factual and 142 Groundwater Quality interpretive) and any cross-sections. Remote sensing is also indexed here, in conjunction with a specific descriptor (e.g. This includes chemical analysis of groundwater and photogeology, satellite imagery) in the Other Keywords field. suitability for use. 102 Economic 143 Groundwater Management Any form of geology of a mineral deposit, surface/open-cut Groundwater recharge, pollution, depletion, extraction and mine mapping, underground level plans or sections, and safe yield are included in this category. Also included is interpretive drill sections. groundwater legislation. 103 Petrology/Mineralogy 200 Geophysics Includes petrology, mineralogy, crystallography etc. of hand This category is indexed whenever a sub-category is indicated specimens, thin and polished sections, heavy mineral or when a general description or interpretation of previous concentrates etc. geophysical surveys in the exploration area is presented. UNPUBLISHED REPORT 1989/07 3 TASMANIA - NATIONAL MAP INDEX 1 , 250000 SHEET 1, 100 000 SHEET SK55 - 1 1 dO 000 SHEET SK55 - 2 " GEOLOGICAL ATLAS QUADRANGLE NUMBER ~ I " - GOOSEI IS - KING ISLAND FLINDERS Is~4.lklJ • STRAIT " I • -+-----t----+-Nl.llSi_+'Olll 8318 I I I SK55 - 1 ~ST P!11KlS - h.- FOIESTII _ y- 8315 I 8415 LAUNCESTDN " I I I 41 SOUTH1 W 4& Sf JUts .. OEAr IO' DAY 8314 8414 8514 I I I n " lYE!'" 8212 or - " " or I 1 : 50 000 ShHts u - HUONI -- I 8211 N! I I ---+I --- I I I I ill I 1I I U . CNf. 8210 TASIMIM 1ItI'.t.mIIfJfI OF ~ " L • ~ • l! Figure 2. Diagram showing 1 :250000,1:100 000, and 1:50000 map sheel boundaries.