Multimedia New Style
Total Page:16
File Type:pdf, Size:1020Kb
MULTIMEDIA SOLUTIONS DVB/MPEG-2 & GRAPHIC CONTROLLER PRODUCTS PRODUCT OVERVIEW MULTIMEDIA CONTENTS Introducing Business Unit Multimedia 2 Business Unit Multimedia at Fujitsu Microelectronics 3 Front-End for Digital Satellite Television 4-5 MPEG-2 Decoder for Digital Television 6-8 MPEG-2 Encoder 9 Introduction to Graphic Display Controllers 10 MB86290A ‘Cremson’ 11-12 MB86291 ‘Scarlet’ 13 MB86292 ‘Orchid’ 14 MB87P2020 ‘Jasmine’ 15 MB86293 ‘Coral Q’ 16 MB86294 ‘Coral B’ 17 MB86295 ‘Coral P’ & MB86296 ‘Coral PA’ 18 MB86275 ‘Olive’ 19 MB862xx ‘Lime’ 20 Product Roadmap 21 Evaluation Boards 22 Graphic Controller Comparison Tables 23 European Distributors & Representatives 24-25 European Sales Offices Back Cover Copyright © 2004 Fujitsu Limited Tokyo, Japan, Fujitsu Microelectronics Europe GmbH and Fujitsu Microelectronics America, Inc., USA. All Rights Reserved. The information contained in this document has been carefully checked and is believed to be entirely reliable. However Fujitsu and its subsidiaries assume no responsibility for inaccuracies. The information contained in this document does not convey any licence under the copyrights, patent OpenTV is a trademark of OpenTV, Inc., rights or trademarks claimed and owned by Fujitsu. Fujitsu Limited and its subsidiaries reserve the NDS is trademark or registered trademark of NDS Limited right to change products or specifications without notice. 2 I C is a registered trademark of Philips No part of this publication may be copied or reproduced in any form or by any means or transferred Macrovision is a registered trademark of Macrovision Corporation to any third party without the prior consent of Fujitsu. All Trademarks acknowledged Designed and produced in the UK. Printed on environmentally-friendly paper. 01 MULTIMEDIA INTRODUCING BUSINESS UNIT MULTIMEDIA Fujitsu Microelectronics Europe’s headquarters in Dreieich-Buchschlag near Frankfurt, Germany. The company has offices in Munich, Paris, Milan and Maidenhead Fujitsu Microelectronics Europe’s In addition to the range of products Fujitsu offers a broad range of Business Unit Multimedia, based at offered by the Business Unit semiconductor devices, including the company’s headquarters in Multimedia, an experienced support telecommunications ICs, RF devices, Frankfurt, Germany, offers customers & development team is in place to MPEG encoders & decoders, advanced multimedia products for work closely with customers on their microcontrollers, graphic display digital TV and set-top boxes as well multimedia systems projects. controllers, microprocessors and as graphic display controllers for Fujitsu Microelectronics Europe is FCRAMTM. The company is also a such applications as car navigation, a major supplier of semiconductor leader in colour plasma display and mobile terminals and industrial products to the European and global LCD panels. applications. market. The company’s main business focus is on providing systems solutions to the networking/telecommunications, mobile communications, automotive and multimedia markets. 02 BUSINESS UNIT MULTIMEDIA AT FME At the heart of Fujitsu’s Business Unit Multimedia is its development centre in Frankfurt, which designs and supports semiconductor multimedia solutions, calling on the skills and expertise located in other Fujitsu design centres in Europe. The MPEG-2 decoder for digital television, SmartMPEG, was designed here, a complete API library was created, reference designs are available and customers are using it successfully in their digital TV products, such as set-top boxes. The SmartMPEG is the third generation MPEG-2 decoder for A corner of Fujitsu’s multimedia development centre where DVB products are evaluated set-top box applications and is The following components are For complex components, the especially designed to reduce system offered from the Business Unit Business Unit Multimedia can also cost of the end-product. Multimedia: supply development kits to A Fujitsu API software library is customers. These kits include an available, which enables the ● Single-package front-end evaluation board, software and customers a fast and easy solutions for digital satellite documentation. implementation of the SmartMPEG television into their products. The Centre has a ● MPEG-2 decoders for set-top box set of resources on call, for both applications hardware and software development. ● Single-chip MPEG-2 encoders The support group assists customers including audio encoders, video to design-in multimedia components encoders & system multiplexers into their end-products. ● Graphic display controllers for embedded solutions 03 MULTIMEDIA FRONT-END FOR DIGITAL SATELLITE TELEVISION LNB Control: SCL, SDA 14/18V and 22kHz & ADR(2:0) DiSEqC 1.X QPSK Silicon Tuner (MB86A15) DiSEqC I2C Zero IF QPSK Foward RF Input TS Output Tuner Demodulator Error Correction (950 to 2150MHz) Parallel and Serial Transport Stream Output QPSK silicon tuner (MB86A15) evaluation board Lock Signal Fujitsu Microelectronics Europe QPSK silicon tuner (MB86A15) block diagram continues the success story with one of the most advanced, highly SDRAM Flash integrated single-chip solutions for 64Mbit 8Mbit digital satellite broadcasting, which SM1 UPI combines a tuner, a QPSK Video RGB DAC 1-5 & YC demodulator and a Forward Error I2C QPSK Silicon Tuner SmartMPEG Correction Unit into one 120-pin TS2 L I2S Audio package. DAC R From Satellite Dish (950 to 2150MHz) Many set-top box manufacturers IR Rx XTAL XTAL around the world already use the well IR known MB86A15. It offers a series of benefits over previous- S/P-DIF generation discrete QPSK NIMs, Typical configuration using the QPSK silicon tuner (MB86A15): Simple set-top box for satellite reception including much smaller size, for a set-top box are the F-connector, performance and reducing the significantly reduced power a 4MHz crystal, and some resistors amount of software needed. consumption and lower cost. and simple capacitors. Much lower power consumption The chip integrates a Zero IF In addition, the MB86A15 is an attractive feature of the Tuner, a QPSK Demodulator and internally generates the control signal MB86A15, which operates from Forward Error Correction (FEC) for DiSEqC 1.x, the standard for supply voltages of just 2.5, 3.3 and circuitry, making it ideal for DVB-S interfacing between the satellite dish 5V. This contrasts with previous and DSS transmissions, without the and receiver, which makes it possible generation designs in which the use of tuning-diodes, expensive to switch between an array of dishes. tuning diode required a 30V supply. capacitance and inductive elements. The DiSEqC 1.x standard requires Maximum power dissipation of the This means that the only external a protocol involving very strict timing, new device is 1.5W (at 45Mbaud), components needed to design and and this is supported by the new chip and thanks to this it is available in a build a complete working front-end directly in hardware, optimising compact LQFP 120-pin package. 04 FRONT-END FOR DIGITAL SATELLITE TELEVISION The low power consumption will help to further reduce costs and make design and implementation easier. Key Features ● Multi-Chip-Package (MCP), using Fujitsu’s advanced MCP technology ● For logic module: CMOS 0.25µm technology ● For RF module: BiCMOS technology ● Includes Zero IF Tuner, QPSK Demodulator and Forward Error Monitor software for PC for the QPSK silicon tuner (MB86A15) Correction ● DVB-S (SCPC, MCPC)) and DSS ● C/N Monitoring function ● Evaluation board including compatible (via I2C bus interface) monitor software for PC is ● No external inductors or variable ● Total power consumption: less available. This software offers capacitance diodes required than 1.5W (at 45Mbaud, graphical BER display, bar graphs ● Supply voltages: +5, +3.3 and decreases at lower baud rates) for signal strength/quality and +2.5V, (30V for tuning is not ● Package: 120-pin plastic LQFP transponder administration required) (FPT-120P-M21) including DiSEqC control. ● Input frequency range: ● Ambient temperature: 950 to 2150MHz 0 to 70°C Key Applications ● Input signal level per channel: typ. -75 to -10dBm Development Kit available which ● Digital set-top boxes for satellite ● Symbol rates: 1 to 45Mbaud includes: reception ● Carrier capture range: ±5MHz ● Television Set incorporating a ● Automatic IQ detection ● Evaluation Board with RF input digital satellite reception (IDTV) ● Automatic detection of Viterbi and transport stream output ● Network Interface Module (NIM) code rates (DVB: 1/2, 2/3, 3/4, ● Application Programming for Satellite reception 5/6, 7/8) Interface software (API) in source ● PC Cards, which use the DVB-S ● I2C® bus interface code will be provided by Fujitsu Standard for Data Broadcasting ● DiSEqC® 1.x compatible ● Head-end stations ● Built-in carrier frequency offset monitor (via I2C bus interface) 05 MULTIMEDIA MPEG-2 DECODER FOR DIGITAL TELEVISION SmartMPEG ideally suited for medium and low-end generation and the system processor. set-top box applications. The Performance of the embedded ARC SmartMPEG includes nearly all of the Tangent-A4 CPU running with required features for these set-top box 130MHz is very high and after applications, requiring only a single initialisation it is completely available SDRAM and a FLASH memory for for other tasks like OSD processing operation. or SI data analysis. This high The SmartMPEG is the first Fujitsu performance increase is achieved MPEG device to use a shared memory through an increased clock frequency, SmartMPEG evaluation