Scholars' Mine Masters Theses Student Theses and Dissertations Spring 2018 The role of flexural slip in the development of chevron folds Yuxing Wu Follow this and additional works at: https://scholarsmine.mst.edu/masters_theses Part of the Petroleum Engineering Commons Department: Recommended Citation Wu, Yuxing, "The role of flexural slip in the development of chevron folds" (2018). Masters Theses. 7788. https://scholarsmine.mst.edu/masters_theses/7788 This thesis is brought to you by Scholars' Mine, a service of the Missouri S&T Library and Learning Resources. This work is protected by U. S. Copyright Law. Unauthorized use including reproduction for redistribution requires the permission of the copyright holder. For more information, please contact
[email protected]. i THE ROLE OF FLEXURAL SLIP IN THE DEVELOPMENT OF CHEVRON FOLDS by YUXING WU A THESIS Presented to the Faculty of the Graduate School of the MISSOURI UNIVERSITY OF SCIENCE AND TECHNOLOGY In Partial Fulfillment of the Requirements for the Degree MASTER OF SCIENCE IN PETROLEUM ENGINEERING 2018 Approved by Andreas Eckert, Advisor John Patrick Hogan Jonathan Obrist Farner ii 2018 Yuxing Wu All Rights Reserved iii ABSTRACT Chevron folds are characterized by straight limbs and narrow hinge zones. One of the conceptual models to initiate and develop chevron folds involves flexural slip during folding. While some kinematical models show the necessity for slip to initiate during chevron folding, recent numerical modeling studies of visco-elastic effective single layer buckle folding have shown that flexural slip does not result in chevron folds. In this study, several 2D finite element analysis models are run, distinguished by 1) geometry of the initial perturbation (sinusoidal and white noise), 2) varying thewavelength of the initial perturbation (10%, 50%, and 100% of the dominant wavelength) and 3) variation of the friction coefficient (high and low friction coefficient between interlayers).