Windchill 11.2 Software Matrices
Total Page:16
File Type:pdf, Size:1020Kb
11.2.0.0 Software Matrices Document revision 1.04 Document published 19 February 2020 Table of Contents To view the table of contents pane of a PDF document, click the Bookmarks tab. Introduction This matrix represents the combinations of platforms, operating systems, and third party products that have been tested a nd verified by PTC. These recommended product combinations are based on compatibility, testing, performance, and reliability. Other software combinations not shown here may perform properly, but are not qualified through PTC’s testing and validation process. This ma trix is a combined matrix for a ll Windchill 11.2.0.0 solutions with some exceptions. CAD integra tions information is contained in the Windchill CAD Integrations Matrix a nd the Creo View Adapters Software Matrix. Some options a re not a vailable with the initia l release of Windchill 11.2.0.0. For future support plans, see the PTC product calendar: https://www.ptc.com/en/support/refdoc. Definitions Bundled Products identified as bundled are included with the Windchill solution that you have purchased. Products that are not bundled are either a separately priced optional add-on or products that you would acquire from a company other than PTC. Windchill 11.2.0.0 Software Matrices rev. 1.04 2020 PTC Inc. Page 2 of 38 Deprecated A software component that is shown as deprecated is still supported in this Windchill release. Deprecation is an announcement that support for the component will be removed in a future Windchill relea se. Except in unusual circumstances, the a ctual removal of support will occur in a Windchill ma jor or point release, not in a maintenance release. Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 3 of 38 Post-FCS Testing and Support Plans Some products will be verified a fter the initial relea se (FCS) of Windchill 11.2.0.0 solutions. These products are listed in the matrix in gray italics to provide you with information that can be used for planning purposes. Actual version numbers a nd target maintenance releases might change prior to PTC supporting the combination. Pla nned future platform support can be found in the Windchill Future Support Summary: http://www.ptc.com/view?im_dbkey=69784. For information on when Windchill 11.2.0.0 maintenance releases will be available, see the PTC product calendar: https://www.ptc.com/en/support/refdoc. Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 4 of 38 Windchill CAD Integrations and Visualization For information on Creo see the Windchill Workgroup Manager for PTC Creo Product Compatibility Matrix for 11.x: https://www.ptc.com/support/go/WWGMCPSupport For information on CAD Integrations, see the Windchill CAD Integrations 11.2 Product Compatibility Matrix. For information on Creo View Client and Adapter platform support (both MCAD a nd ECAD) see the following URLs: Clients Creo View 6.0 Clients and Toolkit Software Matrix Adapters Creo View 6.0 Adapters Software Matrix Pro/INTRALINK 11.2.0.0 For Pro/INTRALINK 11.2.0.0 , PTC offers a bundled Oracle database that can be installed using its PTC Solution Installer. See the Database section for the pla tforms supported. Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 5 of 38 Technical Publications & Technical Illustrations Arbortext Integration Arbortext integration is not supported with Pro/INTRALINK 11.2.0.0 . For information on Arbortext, see the Arbortext Software Compatibility Matrices in the Reference Documents site. Creo Illustrate Creo Illustra te is not supported with Pro/INTRALINK 11.2.0.0 . For information on Creo Illustrate, see the Technical Gra phics Compendium which contains the current state of compatibility of the technical illustra tion authoring and viewing products (like Creo Illustrate, Arbortext IsoDraw, Creo View). Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 6 of 38 Production Server Systems Support Support for the HP-UX and AIX operating systems was discontinued as of the Windchill 11.1 F000 release. This support was deprecated as of the Windchill 11.0 M020 release. Support for the Solaris and Windows Server 2008R2 operating systems has been discontinued as of the Windchill 11.2.0.0 release. This support was deprecated as of the Windchill 11.1 F000 release. Support for Windows Server 2012R2 and Red Hat Enterprise Linux 6.x is deprecated as of the Windchill 11.2.0.0 release, and is expected to be discontinued in the Windchill 12.0.0.0 release. Linux and newer versions of Windows Server will continue to be supported operating systems for Windchill. For upgrading customers who have been running Windchill on any of these operating systems, the migration is to supported versions of either Linux or Windows Server. The following platforms are supported for Windchill enterprise server production deployment. Additional details a re in the matrices included in this document: • Windows Server 2012 R2 (64-bit) [Deprecated] • Windows Server 2016 (64-bit) • Windows Server 2019 (64-bit) • Red Hat Enterprise Linux 6 (AMD & Intel) (64-bit) [Deprecated] • Red Hat Enterprise Linux 7.4 (or higher in the RHEL 7.x series) (AMD & Intel) (64-bit) Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 7 of 38 Development and Test Systems Support The following additional platforms are supported for Windchill development and test only. PTC strongly recommends that customers use the same platform for their test and production environments. • Windows 7 (64-bit) [Deprecated] • Windows 8.1 (64-bit) (1) [Deprecated] • Windows 10 (64-bit) (2) Notes: 1) Windchill Business Reporting is not supported on Windows 8.1 platform. 2) IBM Ra tional ClearCase integration is not supported on Windows 10 Hardware Sizing Guidelines For more information on client and server sizing, see Platform & Hardware Information located on the Windchill Installation and Configuration Resource Page: http://www.ptc.com/go/install-windchill Internet Protocols Windchill supports both IPv4 and IPv6, though there are caveats to the IPv6 support. Some 3rd party a pplications do not yet support IPv6. Therefore, IPv6 support is currently limited to the communication between the Windchill client a nd the Windchill Server. Sites implementing IPv6 must have a dual-stack Windchill Server (IPv4/IPv6). See the Windchill Installation and Configuration Guide for more information: https://www.ptc.com/en/support/refdoc/Windchill_PDMLink/11.2/WCInstallConfigGuide Virtual Systems Windchill running on virtual systems is supported. Specifically tested are VMWare images of Windows a nd RedHat Enterprise Linux. Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 8 of 38 Windchill Compatibility with Cloud Environments Windchill ha s been tested and found to be compatible with Microsoft Azure and Amazon Web Services (AWS) cloud environments. The general Windchill constraints on versions of 3rd party software a pplications, modules a nd libra ries apply to Cloud deployments. In addition, the following Cloud-specific components are compatible with Windchill: Azure • Azure Blob Storage (for Windchill external file vaults, including remote file servers) AWS • S3 storage (for Windchill external file va ults, including remote file servers) • Ora cle RDS (a s the DBMS for Windchill) Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 9 of 38 Java Server Side Support This table describes the Java versions that are supported for use with the Windchill server. Java is a required component for the Windchill server. Red Hat Enterprise Windows Windows Windows Linux Server Windchill Dependent Bundled Server 2012 Server 2016 Server 2019 Version 6/7.4 11.2.0 Product R2 (64-bit) (64-bit) (64-bit) (or higher in the 7.x series) (64- bit) Java™ SE Developer Kit 8 update 202 8 update 202 8 update 202 8 update 202 No (JDK)(1)(2) – from Oracle from Oracle from Oracle from Oracle server side only Amazon Corretto Java No 8.222.10.3 8.222.10.3 8.222.10.3 8.222.10.3 8(1)(3) Notes: 1) JDK versions shown are the JDK versions that were tested. Higher versions in the 8.0 series are also expected to work. 2) 64-bit ca pable pla tforms can run Windchill on a 64-bit JVM. The 64-bit JVM is required on Windows servers a nd used by default on the other pla tforms. 3) La test version certified is Ora cle Ja vaSE Ja va JDK 8 update 221 a nd Amazon Corretto 8.222.10-1 Windchill 11.2.0.0 Software Matrices rev. 1.04 19 February 2020 2020 PTC Inc. Page 10 of 38 Web Servers and Servlet Engines This table describes the web server and servlet engine combinations that are supported for 11.2.0.0 Windchill solutions. All web server and servlet engines are supported with both HTTPS and HTTP protocols. A web server/servlet engine combination, or a web server/application server combination, is a required component. Red Hat Enterprise Windows Windows Windows Linux Server Windchill Dependent Bundled Server 2012 R2 Server 2016 Server 2019 Version 6/7.4 11.2.0 Product (64-bit) (64-bit) (64-bit) (or higher in the 7.x series) (64- bit) Web Server/ Servlet Server Server Server Server Engine Software PTC HTTP Server PTC HTTP Server PTC HTTP Server PTC HTTP Server Apache-based web Server with 2.4.41 or higher 2.4.41 or higher 2.4.41 or higher 2.4.41 or higher within the 2.4.x within the 2.4.x within the 2.4.x within the 2.4.x PTC embedded Yes Servlet engine series with PTC series with PTC series with PTC series with PTC Embedded Servlet Embedded Servlet Embedded Servlet Embedded Servlet based on Tomcat Engine 8.5.43 Engine 8.5.43 Engine 8.5.43 Engine 8.5.43 Microsoft Internet Information Server (IIS) IIS 8.5 with PTC IIS 10.0 with PTC IIS 10.0 with PTC with PTC No Embedded Servlet Embedded Servlet Embedded Servlet N/A Embedded Engine 8.5.43 Engine 8.5.43 Engine 8.5.43 Servlet Engine based on Tomcat(1) Notes: 1) Microsoft’s Internet Information Server (IIS) does not have a direct link to standard LDAP servers.