Installation of Apuniswc Into Ford Falcon, Ba-Bf
Total Page:16
File Type:pdf, Size:1020Kb
INSTALLATION OF APUNISWC INTO FORD FALCON, BA-BF We recommend disconnecting the vehicles negative terminal from the battery before commencing work. Step 1: Remove and disconnect the original head unit. Step 2: Remove the casing from the APUNISWC and set the dip switches on the APUNISWC Switch Number 1 2 3 4 5 6 7 8 ON X X OFF X X X X X X NOTE: Switch 8 should be set to “ON” when installing a Pioneer headunit. Step 3: Wire the APUNISWC to accessory power (12V) RED and earth BLACK. Step 4: Tap the BROWN wire (analogue 1 ) from the APUNISWC into the RED / WHITE wire under the vehicles steering wheel column. NOTE: Car manufacturers can change wiring specifications without notice. Ensure that the correct wires are located before commencing installation. ( DO NOT CUT THE RED / WHITE WIRE ) We recommend soldering and using insulation tape on this connection. Step 5: Set up the patch lead from the APUNISWC (see next page) and connect it from the APUNISWC to the back of the aftermarket headunit. Step 6: Complete headunit wiring and fit the new aftermarket headunit into the vehicle and proceed with any steering wheel control programming the headunit may require. Disclaimer: All the information on this installation guide is published in good faith and for general information purpose only. Aerpro / TDJ Australia do not make any warranties about the completeness, reliability and accuracy of this information. Any action you take upon the information on our installation guide is strictly at your own risk. and we will not be liable for any losses and damages in connection with the use of our installation guide. SETTING UP APUNISWC PATCH LEAD TO SUIT YOUR AFTERMARKET HEADUNIT Disclaimer: All the information on this installation guide is published in good faith and for general information purpose only. Aerpro / TDJ Australia do not make any warranties about the completeness, reliability and accuracy of this information. Any action you take upon the information on our installation guide is strictly at your own risk. and we will not be liable for any losses and damages in connection with the use of our installation guide..