Adolfo Matamoros, Phd., FACI
Total Page:16
File Type:pdf, Size:1020Kb
Adolfo Matamoros, PhD., FACI University of Kansas Department of Civil, Environmental, and Architectural Engineering 2150 Learned Hall Lawrence, KS 66045-2225 Phone: (785) 864-3761 Fax: (785) 864-5631 e-mail: [email protected] Education: Posdoctoral research associate, Purdue University, 1999 Ph.D , Civil Engineering, University of Illinois at Urbana, 1999 M.S., Civil Engineering, University of Illinois at Urbana, 1994 Lic., Civil Engineering, University of Costa Rica, 1989 Research Interests: design and behavior of reinforced concrete members fatigue repair in structural steel bridges earthquake engineering Work Experience: University of Kansas, Department of Civil and Environmental Engineering, Lawrence, Kansas, Professor 2013-present. Associate Chair 2013-present. Director of Laboratories 2013-present. Associate Professor 2005-2013. Assistant Professor 1999-2005 (tenure track 2000-2005). Purdue University, School of Civil Engineering, West Lafayette, Indiana, Posdoctoral Research Associate. 1999, Research Associate. 1998-1999. University of Illinois, Department of Civil and Environmental Engineering, Urbana, Illinois, Graduate Research and Teaching Assistant, 1992-1998. University of Costa Rica, Earthquake Engineering Laboratory, Civil Engineer. Field reconnaissance of earthquake damage, strong motion instrumentation program, and structural design. 1989-1992. HERIEL S. A., San José, Costa Rica. Structural Design Firm, Engineering Assistant. 1988- 1989. 1 Consulting: Burns and McDonnell, Nuclear Power Division, Overland Park, KS, 2012. Parsons Brinckerhoff, Wichita, KS. Analysis of curved boxed girder bridge in Wichita, KS, 2012. Bucher Willis & Ratliff Corporation, Kansas City, MO, 2000. Seismic analysis and design of an 11-span bridge in Cape Girardeau, Missouri. 2000-2001. HNTB Corporation, Kansas City, MO. Instrumentation of 18th Street Expressway Bridge in Kansas City. 2000. Mete A. Sozen. Analysis of the reasons for the failure of a ten-story reinforced concrete building in an earthquake. 1997. Gómez Caijo y Asociados, Bogota, Colombia. Dynamic Analysis of the Urra I Dam, Montería, Colombia. 1996. Professional Service outside the University of Kansas Member, Board of Directors of the Consortium of Universities for Earthquake Engineering Research, 2012-present. Member, Board of Directors of the Kansas Chapter of the American Concrete Institute, 2012-present. Organized and moderated technical sessions in multiple Conventions of the American Concrete Institute and ASCE Structures Congress from 2003 to 2012. Member of Ad-Hoc Committee on Supplement Revisions to Chapter 6 of ASCE 41: Seismic Rehabilitation of Existing Buildings, 2005-2007. Member of the Information Technology Committee of the American Institute of Steel Construction 2000-2005. Member NEES Site Operations Committee, 2008-2010. Member of NEES Committee Data Repository Use Case, 2006. Co-organizer for the technical program of two educator sessions on electronic data interchange during the 2004 North American Steel Construction Conference, Long Beach, California. March 24-25, 2004. Organized in collaboration with AISC a workshop for educators about the use of the Internet to improve learning in steel design courses. Lawrence, Kansas, March 28, 2002. Data-Sharing Working Group, NEES consortium development task group on collaboratory research. 2002. Organized in collaboration with AISC a one-day workshop for educators about the use of the Internet to improve learning in steel design courses. Lawrence, Kansas, November 12, 2001. 2 Professional Organizations American Concrete Institute o Committee on Awards for Papers, Chester Siess Award, Chair (2013). o Committee on Awards for Papers (2012-2013). o Committee 314, Simplified Design of Concrete Buildings, (2004-present). o Committee 408, Bond and Development of Reinforcement, Member (2000 – present), Secretary (2000 – 2006), Chair (2006-2012). o Committee 445, Shear and Torsion, Member (2003 – present) o Committee 439, Steel Reinforcement, Member (2004-2008), Chair Subcommittee 439-C 2007-2008. o TAC Technology Transfer Committee, ITG-4: High-Strength Concrete for Seismic Applications, member and co-author. (2003 – 2007) o Ad hoc Committee on Shear on Prestressed Concrete Members, Chair (2003 – present). o Committee 341, Earthquake Resistant Concrete Bridges, Member (2004 - present). Consortium of Universities for Research in Earthquake Engineering, University of Kansas Representative and Board Member, 2012-present. Kansas Chapter of the American Concrete Institute, Board Member, 2012-present Honors and Awards Miller Professional Development Award for Distinguished Service to the Engineering Profession, University of Kansas, 2013. Fellow of the American Concrete Institute, 2012. Miller Scholar, School of Engineering, University of Kansas, 2012. Outstanding Paper Award, Earthquake Engineering Research Institute, 2007. Certificate of Merit Award by Structural Engineering Association of Northern California (SEAONC) for ACE 41 Supplement No.1, 2007. Certificate of Merit Award by Structural Engineering Association of California (SEAOC) for ACE 41 Supplement No.1, 2007. Bellows Scholar, School of Engineering, University of Kansas, 2003. Phi Kappa Phi Honor Society Papers and Committee Reports Alemdar, F., Gangel, R., Matamoros, A., Bennett, C., Barrett-Gonzalez, R., and Rolfe, S., “Use of CFRP Overlays to Repair Fatigue Damage in Steel Plates under Tension Loading,” Accepted for publication, Journal of Composites for Construction, ASCE. 3 Alemdar, F., Overman, T., Matamoros, A., Bennett, C., and Rolfe, S., “Repairing Distortion- Induced Fatigue Cracks in Steel Bridge Girders using Angles-with Plate Retrofit Technique, Part I: Computer Simulations,” Accepted for publication, Journal of Structural Engineering, ASCE. Alemdar, F., Nagati, D., Matamoros, A., Bennett, C., and Rolfe, S., “Repairing Distortion- Induced Fatigue Cracks in Steel Bridge Girders using Angles-with Plate Retrofit Technique, Part II: Physical Simulations,” Accepted for publication, Journal of Structural Engineering, ASCE. Simpson, B., and Matamoros, A., “Criteria for Evaluating the Effect of Displacement History and Span-to-Depth Ratio on the Risk of Collapse of R/C Columns,” Proceedings of the 15th World Conference on Earthquake Engineering, Lisbon, Portugal, 24-28 September, 2012, 8 pp. Alemdar, Z., Matamoros, A., and Browning, J., “Modeling Surface Deformations and Hinging Regions in Reinforced Concrete Bridge Columns,” Proceedings of the 15th World Conference on Earthquake Engineering, Lisbon, Portugal, 24-28 September, 2012, 8 pp. Alemdar, Z., Matamoros, A., and Browning, J., “High-Resolution Modeling of RC Bridge Columns Under Seismic Loading,” Accepted for publication in the ACI Structural Journal. Hassel, H., Bennett, C., Matamoros, A., and Rolfe, S., “Parametric Analysis of Cross-Frame Layout on Distortion-Induced Fatigue in Skewed Steel Bridges,” Accepted for publication in the Journal of Bridge Engineering, ASCE. Richardson, T., Alemdar, F., Bennett, C., Matamoros, A., and Rolfe, S., “Evaluation of the Performance of Retrofit Measures for Distortion-Induced Fatigue Using Finite Element Analysis, Proceedings of the 2012 World Steel Bridge Symposium, April 18-20, 2012, Dallas, TX. 19 pp. Alemdar, F., Matamoros, A., Bennett, C., Barrett-Gonzalez, R., and Rolfe, S. “Use of CFRP Overlays to Strengthen Welded Connections under Fatigue Loading,” Journal of Bridge Engineering, ASCE, V. 17, No. 3, May/June 2012, pp. 420-431. Kaan, B., Alemdar, F., Bennett, C., Matamoros, A., Barrett-Gonzalez, R., and Rolfe, S., “Fatigue Enhancement of Welded Details in Steel Bridges Using CFRP Overlay Elements,” Journal of Composites for Construction, ASCE, V. 16, No. 2, March/April 2012, pp. 138- 149. Richardson, T., Alemdar, F., Bennett, C., Matamoros, A., and Rolfe, S., “Retrofit Measures for Distortion-Induced Fatigue,” Modern Steel Construction, V. 52, No. 4, April 2012, pp. 32-35. Alemdar, F., Matamoros, A., Bennett, C., Barrett-Gonzalez, R., and Rolfe, S. “Improved Method for Bonding CFRP Overlays to Steel for Fatigue Repair,” Proceedings of the ASCE/SEI Structures Congress, Las Vegas, NV, April 14-16, 2011. 4 Vilhauer, B., Bennett, C., Matamoros, A., Rolfe, S., “Fatigue Behavior of Welded Coverplates Treated With Ultrasonic Impact Treatment and Bolting,” Engineering Structures, Elsevier, 34 (2012), 163-172. ACI Committee 369, “Guide for Seismic Rehabilitation of Existing Concrete Frame Buildings and Commentary, ACI 369R-11,” American Concrete Institute, Farmington Hills, MI, 2011. Hartman, A., Hassel, H., Adams, C., Bennett, C., Matamoros, A., and Rolfe, S. “Effects of lateral bracing placement and skew on distortion-induced fatigue in steel bridges,” Transportation Research Record: The Journal of the Transportation Research Board, No. 2200, 62-68. Crain, J., Simmons, G., Bennett, C., Barrett-Gonzalez, R., Matamoros, A., and Rolfe, S. (2010). “Development of a technique to improve fatigue lives of crack-stop holes in steel bridges,” Transportation Research Record: The Journal of the Transportation Research Board, No. 2200, 69-77. Woods, C., and Matamoros, A., “Effect of Longitudinal Reinforcement Ratio on The Failure Mechanism of R/C Columns Most Vulnerable to Collapse”, 9th Us National and 10th Canadian Conference on Earthquake Engineering, Toronto, July 2010. Sammarco, E., and Matamoros, A., “Plasticity-Based Nonlinear Finite Element Analysis of Reinforced Concrete Columns with Inadequate Seismic Detailing”,