DIY Edger Installation Edger Project Material Calculators
Total Page:16
File Type:pdf, Size:1020Kb
DIY Edger Installation Call 811, Common Ground Alliance, to have utilities marked before starting your project. Installation materials and tools needed Read all instructions prior to installation. (reference images on last page): Gloves Fig. 1 1. Stake Out Project and Excavate. Begin by laying out the project using stakes and a string line (or a garden hose for curves). Dig Stakes a trench 1 to 2 inches wider than the edger. A minimum of 2 String line inches of edger should be buried below grade (Fig. 1). Garden hose 2. Create Leveling Pad. Firmly compact the soil in the bottom of Tape measure the trench with a tamper. Place 1 inch of paver base in the Shovel bottom of the trench and firmly compact (Fig. 2). Base Fig. 2 3 Tamper material can be paver base or an equivalent to /4 -inch minus 3 (with fines) aggregate. Paver base or an equivalent to /4 -inch minus (with fines) aggregate 3. Lay Edgers. Position edger units end to end in the trench. Rubber mallet Using a rubber mallet, tamp the edgers firmly into place. Use a Carpenter’s level or straightedge carpenter’s level or straightedge to ensure the edger units have a uniform height (Fig. 3). Continue to place the units until the Circular saw or tub saw Fig. 3 desired length of the project is reached. Diamond blade designed for cutting concrete pavers Safety glasses 4. Cut and Backfill. If necessary, edger units may be cut using a Hammer circular saw or tub saw with a diamond blade designed for cutting concrete pavers, or be split with a hammer and chisel Chisel (Fig. 4). Finish project by backfilling and firmly compacting dirt in front and back of edger. Fig. 4 Radius reference for Anchor Edger™ Bullet Edger: Always wear eye protection when sawing blocks. Read and understand the operating manual before using a saw. Minimum Minimum Outside Radius: Diameter: 36 inches 72 inches (3 feet) (6 feet) Edger Project Material Calculators 1. Plan the dimensions of the finished project, accurate to nearest inch. 2. Select edger, then calculate number of edgers needed for project. project length in inches edger length in inches estimated # of edgers = X 1.05* = _: length of project (in.) length of edger (in.) minimum # of edgers* * It is recommended that you purchase 5 percent more product than estimated to account for cutting and breakage. 3 3. Calculate base material (paver base or /4 -inch minus [with fines] aggregate) needed for project. calculate the volume of base compensation cubic inches of base material for compaction = ______ X 6 = length of trench width _ 1,728 project (in.) x base depth : (sq. in.) = X 1.25 volume of base (cu. in.) compensation for compaction total cubic feet of base material Complete installation materials and tools reference images: Safety glasses Rubber Gloves mallet Hammer and Chisel Level Carpenter's pencil Circular saw Rake String Shovel Tamper Paver Stakes base Adhesive Drainage aggregate Paver sand Garden hose Tub saw Spikes 1" Pipes Edge 2x4 restraint Plate board compactor Tape Diamond measure blade Trowel.