ETP-EL12/24 LED Blue Light

ETP-EL12/24 LED Blue Light Architectural & Engineering Specification

1. GENERAL DESCRIPTION

1.1. The unit shall be a highly visible, outdoor-rated LED Blue Light, model ETP-EL, no substitutions, with built-in flash activation relay.

1.2. Unit shall have a low power mode consuming less than 2 watts.

1.3. Unit shall operate from -40ºF to 150ºF.

2. CONSTRUCTION

1.4. Unit shall be housed in a vandal resistant, blue polycarbonate refractor housing measuring approximately 6.9" H x 5" Diameter (6.6” diameter base)

1.5. Gasket shall be made from UV-resistant EPDM foam rubber

1.6. Unit shall weigh approximately 4 lbs.

1.7. Refractor housing shall have a prismatic pattern to increase visibility at greater distances.

3. LIGHTING

1.8. Unit shall have ultra-bright LEDs that produce a peak of 209 lumens (exceeds 1,000,000 candle power).

1.9. Unit shall flash approximately 78 times per minute.

1.10.Unit shall continue to produce 70% of the iniital lumens after 50,000 hours of operation

4. ELECTRICAL

1.11.Unit shall operate on 10-30VDC or 20-28VAC. 120VAC version is also available.

1.12.Unit shall have two 18GA pairs, approximately 15 feet in length: one for power and one for activation of the built-in relay.

1.13.Light shall consume 7.5 watts in normal mode or 1.5 watts in low power mode.

5. MOUNTING

1.14.Unit shall use Mounting Bracket, model ETP-MBKT, to mount to 4" square box.

6. OPTIONS

1.15.Low voltage version, model ETP-EL 12/24, shall accept 12VDC or 24VAC/DC. This version shall have a low-power mode.

of 2 Rev. 2/2/12 Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com. All specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved. ETP-EL12/24 LED Blue Light Architectural & Engineering Specification

7. COMPLIANCE

1.16.Unit shall be Certified to UL Standard 1598.

8. WARRANTY

1.17.Equipment shall be warrantied against any defects in material and workmanship, under normal use, for a period of two years from date of installation. In the event system is found by manufacturer to be defective within the warranty period, manufacturer shall repair and/or replace any defective parts, provided the equipment is returned to manufacturer.

9. MANUFACTURER

1.18.The Manufacturer shall be Talk-A-Phone Co. (773) 539-1100, 7530 N. Natchez Ave, Niles, Illinois 60714-3804, www.talkaphone.com. THERE ARE NO EQUIVALENTS.

of 2 Rev. 2/2/12 Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com. All specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.