For your ease and convenience, this guide is intended to find the most essential functions you will need to start experiencing your Infiniti Q30.
It is important to note that this guide does not replace the full Owner's Manual, which should be referred to for complete details, security items and warnings.
Ignition switch Multi-function control touch screen/Rear view monitor display/ Around view monitor display Audio system Centre console switches - Seat Heating (where fitted) - Hazard light switch - Engine Stop/Start system ON/OFF switch - Electronic Parking Sensor OFF switch Climate control panel - Heater & Air conditioning - Front/Rear window defogger Drive mode selection INFINITI multi-function controller
7 Doors Unlocking & Locking Anti-theft Alarm System An audible and visible alarm is triggered when a door, the tailgate or bonnet is opened when the system is armed.
The system will automatically be armed after the vehicle is locked. Indicator lamp will flash, indicating thet the alarm system is armed. The alarm system is operational after approx. 15 seconds. The alarm is disarmed when the vehicle is unlocked. You can lock and unlock the doors and tailgate by pressing the lock or unlock button on the Intelligent Key. For emergency purposes, a Optionally, your vehicle may be equipped with tow-away protection which mechanical key is integrated in the Intelligent Key. To release the mechanical additionally triggers the alarm when the system is armed and the vehicle’s key, shift the knob and pull out the key. inclination angle changes. Also, an interior motion sensor may be fitted to your vehicle that triggers the alarm when motion is detected within the passenger compartment. Intelligent Key System The tow-away protection and interior motion sensors can be switched off using the switches above the interior rear-view mirror. To exclude the tow away or interior motion sensors from the alarm system:
1. Switch off the engine. 2. Press switch (deactivation of interior motion sensor) or (deactivation of tow-away sensor). The Intelligent Key System is a keyless entry system that allows you to lock The indicator light will flash/illuminate to confirm deactivation of the and unlock the doors and tailgate without using the key when the Intelligent respective function(s). Key is within the system’s operating range . To open a door, touch the 3. Lock the vehicle. inside of the door handle and pull the handle to open the door. To lock the doors, touch the sensor on the door handle.
8 HEAD RESTRAINT ADJUSTMENT Front Seat and Head Restraint Adjustment Push knob and raise/lower the head FRONT SEAT MANUAL SEAT ADJUSTMENT restraint until it reaches the desired position. After adjustment, make sure the lock knob is engaged in one of the notches.
Automatic Drive Positioner System Pull handle to adjust seat in horizontal direction You can store up to three different seat and outside mirror positions using the automatic Turn knob to adjust angle of front of seat drive positioner system. Pull/Push lever to raise/lower the seat To store a setting: Turn knob to adjust seatback angle 1. Adjust the seat Push buttons to adjust seatback contour 2. Adjust the outside mirrors 3. Briefly press the memory button , then press and hold preset position 1, 2 or 3 within three seconds. A tone sounds when the FRONT SEAT POWER SEAT ADJUSTMENT setting is stored in the memory. Move switch to adjust seat in horizontal To call up a stored setting, press the desired preset button. direction
Move either front or rear side of switch to Steering Wheel Adjustment adjust angle of seat or raise/lower the seat Push down the lock lever and adjust the steering Push buttons to adjust seatback contour wheel as desired.
After adjustment, make sure to firmly push the lock lever back into position to lock the steering wheel in place.
9 Automatic Front Passenger Front Air Bag Headlight Switch Deactivation The automatic front passenger front air bag deactivation system analyses the weight of the person seated on the front passenger seat. Depending on the analysis, the front-passenger front air bag is either enabled or disabled. If a rearward-facing child restraint system is fitted to the front passenger seat, the indicator light must illuminate after the system self-test and remains illuminated. The front passenger front air bag then is deactivated. The system does not deactivate front passenger side and curtain air bags.
Left hand parking lights switched on.
10 Combination Switch The combination switch is located above the cruise control switch and WINDSHIELD WIPERS AND WASHER provides multiple functions as described below. Push the combination Press to operate windshield washer & wipers. switch away from you Turn switch to select: while the headlight switch Automatic wipe, low rain is in the or sensor sensitivity. position to select high beam. Automatic wipe, high rain sensor sensitivity. Pull the switch towards you to flash the high beam headlights. Continuous wipe, slow. Push the switch up or down to activate the right/left turn signal light. Continuous wipe, fast.
High Beam Assist (where fitted) REAR WINDOW WIPER AND WASHER The High Beam Assist system automatically switches from high beam to low beam when the headlight Turn switch to select: switch is in the position while high beam Wipes with washer is selected and an oncoming or leading vehicle is fluid, then returns detected. When the vehicle is no longer detected, low to intermittent beam will be switched back to high beam. The high wiping. beam assist indicator light in the instrument panel illuminates when the system is active. Intermittent wiping
The high beam assist system will not function at speeds below approximately Off 40 km/h. Wipes with washer fluid
11 Ignition Switch Positions Instrument Brightness Control The ignition switch has following A light sensor in the instrument cluster automatically controls the brightness positions: of the instrument panel illumination. In daylight, the instrument panel is not illuminated. OFF position. After opening the door, the steering wheel will The brightness of the instrument panel be locked. No power supply to illumination can be adjusted using the consumers. instrument brightness control knob .
ACC position - power supply to several consumers like window wipers.
ON position - power supply to all consumers. For diesel models: glow plugs start pre-heating the engine at low engine temperatures.
START position: operates the starter motor to start the engine. Clock Settings Clock settings can be changed as follows:
1. Push
