Part Names - Main Unit
Total Page:16
File Type:pdf, Size:1020Kb
Quick Start Guide Part Names - Main Unit ■ The number shown in each is the page number where the part’s function and/or use are explained either in English or Japanese. Front view Bottom Speaker Type Side Speaker Type Speaker Speaker section section Stand…………29 Stand……… 29 電源 予約 明るさセンサー ヘッドホン Remote sensor window…………… 214・25 Headphones jack………22 • When using the remote control, point its head toward this window. Ambient illumination Ambient illumination sensor indicator…………166 sensor window……………………… 166 Timer program indicator…103 Power indicator ……………………… 215 Top view Bottom Speaker Type Side Speaker Type B-CAS card slot 64 •Open the cover and insert the B-CAS card in the direction shown below IC chip Adjusting the LCD panel angle Adjusting the LCD panel angle LCThe LCD panel can be rotated LCThe LCD panel can be rotated horizontally up to 10° clockwise horizontally up to 10° clockwise - 45and counter-clockwise. - 45and counter-clockwise. The LCD panel cannot be tilted The LCD panel cannot be tilted verically. verically. LCThe LCD panel can be tilted up LCThe LCD panel can be tilted up to 2° forward, up to 6° 音量 選局 入力切換 電源(押・入-切) to 2° forward, up to 6° - 37backward and rotated - 37backward and rotated horizontally up to 10° clockwise horizontally up to 10° clockwise and counter-clockwise. and counter-clockwise. Volume up (+) /down (–) buttons………216 Main power on/off switch… 215 Channel up (∧) /down (∨) buttons………216 Input select button……… 217 210 The illustrations below are those of 45-inch type. 37-inch type has the same layout of jacks and terminals Rear view as 45-inch type. Digital module reset button 195 TV module reset button195 RS-232C terminal 156 Terminal cover VCR controller connector 128 for Factory Adjustment Digital audio output jack (optical) 148 i.LINK (TS) jacks 136 AV in 6 (audio) 122・150 Telephone line jack 74 LAN jack 184 Power cable connector (AC 100V) 35 AV in 5(HDMI)120 LC-45 LC-37 AV in 6(DVI-I) 122・150 AV in 1·2 114 ▼Inside the terminal cover Digital out/ Monitor out/AV in 4 132 Quick Start Guide Terrestrial digital antenna input terminal 33 AV in 3 116・124 Part Names - Main Unit VHF/UHF antenna Opening the terminal cover input terminal 33 VHF/UHF antenna output terminal 33 Holding the lock at the top of the cover downward, pull the cover off the back of the main unit. BS/CS 110 antenna input terminal 34 211 Quick Start Guide Part Names - Remote Control Unit Cover closed Display……………………… 39 Sleep timer…………………… 176 Press to display or turn off the channel Press to select the desired remaining call, etc. time period after which the TV set is automatically turned off and enters the Active/Standby………………36 standby mode. Press to engage the TV set in the i.LINK……………………………140 active or standby mode. Press to select the i.LINK mode. Press to CATV…………………………217・83 display or turn off the D-VHS VCR, AV-HDD recorder, Blu-ray Disc recorder When selecting a CATV channel by or Hi-Vision Video camera control panel. entering the channel number, press this button first, then enter the 2-digit Favorite channel select/register……83・174 number with the TV channel select Press to select a user-registered channel buttons (1-10/0). and to turn on/off the favorite channel register/registered channel table screen. Terrestrial digital select……213・216 Press to select the terrestrial digital network. Digital channel number input 83 * Use this button after the TV set is When selecting a digital channel by tuned to receive terrestrial digital entering the 3-digit channel number, broadcasts. press this button first, then enter the channel number with the channel select Terrestrial analog select……213・216 buttons (1-10/0). Press to select the terrestrial analog network. Channel select…………………213・82 (linked data broadcast)……90 • Press to select a channel after selecting the desired network (terrestrial analog Press to call the data broadcast linked [地上A], terrestrial digital [地上D], BS, with the current digital TV program. CS) and media (TV, radio, or data). Volume up (+)/down (-)……216 • Use to input a number for various settings. Press to adjust the volume. CS select………………………213・82 Mute………………………… 216 Press to select the CS digital networks. Press to temporarily turn off the sound. Press again to return the sound volume BS select………………………213・82 to the previous level. Press to select the BS digital network. EPG…………………………221・92 Media select…………………219・82 Press to display or turn off the Electronic Press to select the desired media (TV, Program Guide (EPG: 番組表) when radio, or data). receiving a digital broadcast. Channel up (∧)/down (∨)……219・82 Program info…………………221・90 Press to select channels in the current Press to display detailed information (e.g. network, media and CATV channels in title, genre, on-air time, cast, writer, etc.) the ascending or descending order. on the current digital program. * CATV channels are factory set to be skipped. Cursor Input select………… 217・114・135 (up, down, left, right)……… 44 Press to select the desired input. Use to select a menu item, column, etc. Other on-air programs…………98 Enter/Confirm……………… 44 Press to display the EPG for currently Press to confirm a selected setting or on-air programs only (裏番組). menu item. Menu……………………………44・48 Finish……………………… 44 Press to display or turn off the menu Press to end the picture freeze mode, screen. turn off the EPG display, or finish menu The menus can be displayed in English. operation, etc. See page 218 for instructions on how to Note switch the display language. This button can be conveniently used Return………………………… 44 when you are at a loss during menu or Press to go back to the previous screen. EPG operation, etc. Press this button instead of the Color (blue, red, green, yellow) Enter/Confirm (決定) button when you …………… have selected the wrong item or input 219・90・92・186 the wrong number, etc. Use to operate EPGs and data program screens. 212 Cover open GR……………………………84 Press to activate or deactivate the GR (ghost reduction) function. Digital channel register…… 86 AV mode select………………165 Press to display or turn off the channel Press to select the picture/sound setting register/registered channel table (dynamic [locked], dynamic, standard, screen. cinema, game, or AV memory) that best matches the current program. Freeze……………………… 173 Caption………………………221・179 Press to freeze the picture. Press to display, select, or turn off captions when watching a digital program with captions. Screen mode…………………152・161 Audio select…………221・89・170 Press to select the desired screen mode. Press to select the desired audio (e.g. Japanese or English in bilingual Picture select………………221・89 broadcast, the main sound or a sub sound in digital multi-sound broadcast, Press to select the desired picture etc.). when watching a digital multi-picture program. Operable screen……………173 Press to switch the operable screen Split screen (screen with the mark) when the TV ………………… 172 set is in the split screen mode. Press to switch between the split screen mode and the normal screen mode. To open the cover Hold the cover by the projections on both sides and lift upwards. Basic operation for channel selection Selecting terrestrial analog (VHF/ UHF) channels ① Press to select terrestrial analog broadcast. Quick Start Guide Favorite channel select/register button ② Press - to select the desired channel. Selecting digital channels Channel select ① Press , or to select the desired buttons digital broadcast network. – ② Press - to select the desired channel. Types of broadcast Network select Part Names - Remote Control buttons (terrestrial • Terrestrial analog: Conventional VHF/UHF broadcast analog, terrestrial • Terrestrial digital: Terrestrial digital broadcast digital, BS, CS) • BS: BS digital broadcast • CS: CS 110 digital broadcast ■ For details about channel selection, see pages 216 and 219. Selecting favorite channels ① Press to display the registered channel screen. Unit ② Press - to select the desired channel. 213 Quick Start Guide Part Names - Remote Control Unit Inserting batteries in the Remote control operating range When operating the remote control, direct its head toward remote control the remote sensor window located at the bottom right corner of the main unit, as shown below. The maximum operating range is approximately 5 meters in distance, and Open the battery cover. 30 degrees in angle against the straight line normal to the 1 remote sensor window, as shown below. Gently holding down the -marked area, 30° 5m slide the cover in the direction of the arrow. 30° Remote sensor window Insert the supplied two AAA Note: • The remote control may not work when there is an 2 batteries, and close the cover. obstacle between the remote control and the main unit's remote sensor window. • As the batteries are depleted, the operating distance will become shorter. Replace them with new ones. • The remote control may not work properly when there is a fluorescent light near the main unit's remote sensor window. Make sure that the terminals match the and indications in the battery compartment. Cautions regarding the remote control • Do not expose the remote control to shock, water, or high humidity. • The remote sensor window on the main unit may not properly receive remote control signals when it is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or the main unit. Cautions regarding batteries Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below. • Do not mix batteries of different types. • Do not mix old and new batteries. CAUTION • Do not try to charge or disassemble batteries.