HOW TO CONNECT YOUR UNIT TO YOUR RS110 OR RS130 AS WELL AS TO YOUR .

Connect the Bluetooth module to the RS110 or RS130 by fastening it with two screws. Switch on the RS110 and check whether the green LED on the Bluetooth module is blinking slowly.

Press the sunken in button with a pen and wait till the green LED starts blinking rapidly. The Bluetooth module of the RS110 or RS130 is now ready for pairing.

The next step is to prepare your mobile phone for the Bluetooth mode, so that the two units can work with each other.

If you have a do the following: Go to Menu, Connectivity, Bluetooth, switch on

Go to the Bluetooth menu to My devices and choose New device. Press OK. After a few seconds you will see a new device called You/Com. When you select this, the mobile phone will ask for a passkey: 0000.

If you now make a call using the mobile telephone it will automatically use the Bluetooth module. During a telephone call you can switch over to another bluetooth headset/ or telephone. Use MENU, Transfer sound and then select the required device. The next call will automatically use the BT device last used.

If you have a Nokia 6310(i) do the following: Go to Menu, Bluetooth, switch on

Go to Menu, Bluetooth and choose Search for Audio Accessories. After a few seconds you will see a new device called You/Com. When you select this, the mobile phone will ask for a passcode: 0000.

If you now make a call using the mobile telephone it will automatically use the Bluetooth module.

General information: When switching off the RS110 or RS130, the Bluetooth connection will automatically be disconnected. After a few seconds the mobile telephone can be used normally. When switching on the RS110 or RS130 again, the Bluetooth connection will be established automatically. You do not have to repeat above procedure.

The Bluetooth module can only be used with one mobile telephone at a time. If you wish to connect it to another mobile telephone, then first disconnect the current mobile phone from the RS110 or RS130 before pairing with the new one by repeating above procedure.

IMPORTANT NOTE: Older RS110 units and RS130 units require a slight amendment which you can do as follows. See enclosed instructions or look at our website under www.youcom.nl

AA/Datasheets/GSM Bluetooth Delft, February 2004