sign in sign up
<<
Home , Digital clock

Digital

Model: AAABLK100008726

PRODUCT GUIDE

January 16, 2020_V1

We’d love to hear from you. Scan with you Walmart app and let us know what you think. Information and Safety Instructions Overview

Need help? is encouraged to try to correct the interference by one or We’re here for you every more of the following measures: from 7 a.m. – 9 p.m. CST. Speaker (side) • Reorient or relocate the receiving antenna. AC In (side) Give us a call at 1-888-516-2630 • Increase the separation between the equipment and receiver. Clock/Mem Important Safety Instructions • Connect the equipment into an outlet on a circuit In Off mode, press Power/Source/ • Read these Instructions. different from that to which the receiver is connected. AL Off • Keep these Instructions. and hold to begin • Consult the dealer or an experienced radio/TV Press to turn the • Heed all Warnings. technician for help. setting the . • Follow all instructions. In Radio Mode, unit on. • Do not use this apparatus near water. Additional Warnings and Precautions press Tuning/Min/ Dimmer Snooze/ Volume/ Press and hold to • Clean only with a dry cloth. • CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE to cycle through Press to dim Sleep AL1/AL2 turn off the radio. BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. • Do not block any ventilation openings. Install in preset stations. Press to tune the display. Press to Press to Press to turn • Mains plug is used as disconnect device and it should accordance with the manufacturer’s instructions. the radio. snooze the adjust off the alarm. • Do not install near any heat sources such as radiators, remain readily operable during intended use. In Press to adjust alarm after the volume. Press repeatedly to heat registers, stoves, or other apparatus (including order to disconnect the apparatus from the mains the it sounds. select AM, FM. amplifiers) that produce heat. completely, the mains plug should be disconnected Press to • Do not defeat the safety purpose of the polarized form the mains socket outlet completely. or hour when Press begin or grounding - type plug. A polarized plug has two • Caution marking is located at the rear or bottom of the setting the repeatedly setting blades with one wider than the other. A grounding apparatus. clock or alarm. to set Alarm 1 or type plug has two blades and a third grounding • WARNING: To reduce the risk of fire or electric shock, the sleep Alarm 2. prong. The wide blade or the third prong are provided do not expose this apparatus to rain, moisture, timer. dripping, or splashing. for your safety. When the provided plug does not fit PM Indicator • CAUTION: Use of controls or adjustments or LED Display into your outlet, consult an electrician for replacement Lights when of the obsolete outlet. performance of procedures other than those specified the time is in • Protect the power cord from being walked on may result in hazardous radiation exposure. or pinched particularly at plugs, convenience • WARNING: Changes or modifications to this unit the PM. Alarm 2: Buzzer/ receptacles, and the point where they exit from the not expressly approved by the party responsible for Radio Indicator apparatus. compliance could void the user’s authority to operate Alarm 1: Buzzer/ Lights when the • Only use attachments/accessories specified by the the equipment. Radio Indicator alarm 2 is on and • WARNING: Do not place this unit directly onto furniture manufacturer. Lights when the set to buzzer or surfaces with any type of soft, porous, or sensitive • Unplug this apparatus during lightning storms or when alarm 1 is on and radio. unused for long periods of time. finish. As with any rubber compound made with oils, set to buzzer or • Refer all servicing to qualified service personnel. the feet could cause marks or staining where the feet Servicing is required when the apparatus has been reside. We recommend using a protective barrier such radio. damaged in any way, such as power-supply cord or as a cloth or a piece of glass between the unit and the plug is damaged, liquid has been spilled or objects surface to reduce the risk of damage and/or staining. have fallen into the apparatus, the apparatus has • CAUTION: Danger of explosion if battery is incorrectly Power & Batteries been exposed to rain or moisture, does not operate replaced. Replace only with the same or equivalent normally, or has been dropped. type. To power the unit, plug the AC adaptor on the To power the unit using battery power, insert 2 • WARNING: Shock hazard - Do Not Open. back of the unit into a standard power outlet. AAA batteries (not Included). The battery backup FCC Warnings • Battery shall not be exposed to excessive heat such as is intended for short power outages only. The clock Warning: Changes or modifications to this unit not expressly sunshine, fire or the like. radio’s primary functions cannot run on battery approved by the party responsible for compliance could • Keep new and used batteries away from children. If the backup alone. void the user’s authority to operate the equipment. battery compartment does not close securely, stop using the product and keep it away from children. NOTE: This equipment has been tested and found to • WARNING: DO NOT INGEST BATTERY, CHEMICAL comply with the limits for a Class B digital device, pursuant BURN HAZARD. If you think batteries might have been to Part 15 of the FCC Rules. These limits are designed to swallowed or placed inside any part of the body, seek provide reasonable protection against harmful interference immediate medical attention. in a residential installation. This equipment generates, uses, • If the coin/button cell battery supplied with this and can radiate radio frequency energy and, if not installed product is swallowed, it can cause severe internal and used in accordance with the instructions, may cause burns in just 2 and can lead to death. harmful interference to radio communications. However, • Completely replace all old batteries with new ones. there is no guarantee that interference will not occur in a • Batteries should be recycled or disposed of as per particular installation. If this equipment does cause harmful state and local guidelines. interference to radio or reception, which can be determined by turning the equipment off and on, the user Note: Do not mix old and new batteries and Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.

January 16, 2020_V1 January 16, 2020_V1 Clock & Sleep Timer Setting the Clock Snooze and Alarm Reset 1. If in Radio Mode, press and hold the After the alarm sounds: Power/Source/Al Off button to • Press the Snooze/Sleep button to delay the turn the unit off. alarm for several . 2. Press and hold the Clock/Mem button until • Press the Power/Source/Al Off button to the display begins to blink, then release turn the alarm off until the set alarm time is the button. reached again. 3. Press the Hour button to adjust the hour. The PM indicator will light when the hour is set in the PM. Radio 4. Press the Min button to adjust the minute. 5. Press the Clock/Mem button to finish Tuning the AM or FM Radio setting the time. 1. Press the Power/Source/Al Off button to Setting the Sleep Timer turn the clock radio on. 2. Press the Power/Source/Al Off button Note: There may be up to a 1 minute deviation in again to switch between AM and FM Radio the sleep timer. Mode. 1. Press the Snooze/Sleep button repeatedly 3. Press the Tun+/- buttons to adjust the radio to set the sleep timer ( 90, 80, 70, 60, 50, 40, to the desired frequency. 30, 20, 10 or OFF ). 4. Press and hold the Tun+/- buttons to 2. Once the set sleep time has expired the search for the next available frequency. clock radio will automatically power off. 5. Press the Vol+/- buttons to adjust the volume. Alarm 6. Press and hold the Power/Source/Al Off to turn the radio off. Setting the Alarm Saving and Tuning to a Station as 1. If in Radio Mode, press and hold the Power/ a Preset Source/Al Off button to turn the unit off. 1. Tune to the desired station. 2. Press the AL1 or AL2 button until the display begins to blink. 2. Press the Clock/Mem button to cycle through preset radio stations. 3. Press the Hour button to adjust the hour. The PM indicator will light when the hour is 3. Press Tun+/Tun- to select which preset set in the PM. you want to save the station to. Up to 10 stations can be saved. 4. Press the Min button to adjust the minute. 4. Press the Clock/Mem to save selected 5. Press the AL1 or AL2 buttons repeatedly to station. switch between Radio and Buzzer. 5. To cycle through presets press the Clock/ 6. Once the set alarm time is reached, the Mem button and press the Tun+/Tun- to alarm will sound. select which preset you want to listen to. 7. To set the other alarm, follow the above steps and choose the alarm not currently Radio Reception set. A wired FM antenna is built into the clock radio and exits from the rear of the unit. To improve radio Disabling the Alarm reception, adjust the position of the antenna, or if need be, adjust the position of the clock radio. • Press the AL1 or AL2 buttons repeatedly until the indicator is no longer lit.

January 16, 2020_V1