Infralite 1 Light System Rr01203
Total Page:16
File Type:pdf, Size:1020Kb
lighting since 1895 Specification Sheet ® INFRALITE 1 LIGHT SYSTEM RR01203 Patented Remote Controlled Motorized Adjustable Recessed Patient Lighting System ICU • CCU • ED OR PREP/RECOVERY PATIENT ROOM • NICU CATH LAB • PICU 150 Watt Low Voltage System Design: Inconspicuous, fully recessed lensed motorized luminaire with smooth white BioGard™ anti-microbial finish. Use: Fast, single-hand adjustability using either infrared remote or wall control. Function: Precise adjustability of direction and brightness. Performance: Cool stable beam of ideal 100 CRI light provides proper color rendition of tissue. This lighting system features one fully recessed luminaire plus a wall control and a remote control: Luminaire Offers: • Lightweight construction for Wall Control also features: THIS FIXTURE IS NO • Full 360° rotation with tilt up to 35° easy installation in any ceiling • Permanent magnet for remote THISeither side of nadir FIXTURE (28 pounds) IS NOcontrol storage. LONGER AVAILABLE • Exclusive cold mirrored reflector • Complete serviceability through • Less than 1 microamp current toLONGER remove heat from the beam for aperture;AVAILABLE plug-in components for leakage from front of wall control patient comfort easy installation and service panel • BioGard™ anti-microbial white Each Control Module Offers: Remote Control also features: regressed smooth flare trim with • Tactile-membrane controls for • Exclusive loss-deterring beeper tempered clear flat glass lens power, fixture selection, intensity FOR AN ALTERNATIVE • 150 watt, 22 volt 100 CRI tungsten and direction halogenFOR lamp for accurate AN • ALTERNATIVESmooth surfaces for convenient PLEASE SEE MRR-12622 visualization and color rendering cleaning with isopropyl alcohol UL, PLEASEC-UL (Canada) Listed • Exclusive SEE Three Year Warranty MRR-12622 • Designed and Produced in U.S.A. Options The following Options are available for RR01203. Add Option as suffix to catalog number. Example: RR01203-32-BI. -81 15° bottom pan achieves 50° high angle -BI Beeper (remote control) inactivated by factory. -10 Tinted lens instead; for color temperature above illumination in one direction. Maximum recessed -LX Extra lamps. Specify in multiples of 12. Note: 3800oK. CRI and lumen output are reduced. depth 15-1/8". One extra lamp shipped per luminaire. -32 Trim extender. Broadens trim flange O.D. by 1" -87 Low voltage plenum rated cable length greater -RC Extra remote control. to cover larger ceiling opening. than 35 feet. Consult factory. -RS Remote sensor. Consult factory. -58 277/22 volt stepdown isolation transformer for -94 Custom color self-flanged flare trim instead. -SE Fixture modified to accept seismic anchorage 277 volt line input, prewired into each fixture; Consult factory. (by others). Meets California OSHPD and with 277 volt thermal protector. -97 For other input supply voltages, consult factory. International Building Codes. Consult factory. -99 Special modification. Consult factory. THE KIRLIN COMPANY 3401 EAST JEFFERSON AVENUE • DETROIT, MICHIGAN 48207-4232 (313) 259-6400 • Fax: (313) 259-3121 or (313) 259-9409 • www.kirlinlighting.com DUE TO OUR CONTINUING EFFORT TO IMPROVE PRODUCTS, ® MOTORIZED REV JUNE 2015 TECHNICAL INFORMATION IS SUBJECT TO CHANGE WITHOUT NOTICE INFRALITE is a registered trademark of The Kirlin Company. PATENT PROTECTED lighting since 1895 Features and Specifications INFRALITE® INFRARED REMOTE CONTROLLED RR01203 1 LIGHT SYSTEM ADJUSTABLE LIGHTING SYSTEM DRAWING NOT TO SCALE 1 Lamp and Socket from other infrared emitting equipment. • Two 27" (69cm) galvanized channel bar • 150 watt 22 volt 100 CRI DCB base • Less than 1 microamp current leakage hangers supplied. 11 tungsten halogen lamp (included). from front of wall control panel. • Four Kirlin fully adjustable universal • Extra lamp provided. • UL listed back box provided 7 must mounting brackets supplied. 12 • DCB socket with Teflon® leads. be used for proper fit of electronics. Junction Box (luminaire) 13 Reflector 2 1/2" and 3/4" trade size knockouts. • Prewired 14 GA (NEC) galvanized steel, • ColdTHIS mirrored glass reflector removesFIXTURE heat IS NO Low Voltage Plenum Rated Cable 8 UL listed. Contains fuse and holder. from light beam. • Each luminaire provided with 35' low • Removable insulated cover. MotorsLONGER / Gimbal Assembly 3 voltage AVAILABLE (12 volt) plenum rated cable with • 1/2" and 3/4" knockouts. • Two 12 volt permanently lubricated motors single plug-in connection (RJ45 connector) 14 control motion. Quiet operation. to wall control module. Optional cable Housing • Acrylic enameled aluminum. • Plug-in modular electronics designed for length available, see Option -87. • Cool: Dissipates heat across entire easy maintenance. Electronics with Power Supply 9 surface area. • Visible and easily serviced through • All electronics located in aluminum box • Rustproof: Exceeds 1000 hour ASTM removable trim assembly. (easily accessed and serviced). 5% salt spray test. • Rotates 360o and tilts up to 35o from either FOR AN• All controlALTERNATIVE wiring supplied by Kirlin is 12 volt • Entire luminaire serviced through side of nadir. maximum. removable trim assembly. Thermal Protection 4 • Pre-connected plug-in modular electronics • Built-in plaster frame. • Per current NEC. designed for easy maintenance. PLEASE SEE MRR-12622Trim Assembly 15 Infrared Remote Control 5 Isolation Transformer 10 • White regressed self-flanged flare with (one per lighting system) • WhisperPackTM fully encapsulated 120 Kirlin BioGard™ anti-microbial finish. • Controls power, direction and brightness. to 22 volt step-down Class H isolation • Regressed tempered clear flat glass • Emits unique frequency to avoid interferring transformer. Fused (in J-box). lens. with other infrared emitting equipment. • Cool, quiet, long life. Silicone leads. UL, C-UL (Canada) Listings • Loss-deterring beeper reminds user to • Visible and easily serviced in all ceilings, • Damp or dry locations, covered ceilings. store remote on wall control module. including dry wall. • Through branch circuit conductors. • For 277 volt, see Option -58. Wall Control Module 6 (6 #12) Installation (one per lighting system) State of California OSHPD Seismic • Includes all tactile-membrane function • Lightweight 28 pound fixture recesses in all Anchorage Pre-Approved. controls (power, direction, brightness) and ceilings including suspended ceilings. electronics. Also contains infrared receiver • For seismic anchorage, see Option -SE. Warranty and magnetic storage strip for the remote • May be installed (per NEC, mandatory) • Complete standard fixture and wall control. (Detail on following page.) by any qualified electrician. Factory control, three years. (Lamps excluded) • Designed to avoid potential interference representative need not be present. • Remote control, one year. PER SINGLE LUMINAIRE OPERATING CURRENT AT 120V 1.75A MAXIMUM DRAW 1.85A Teflon® is a registered trademark of Dupont. PATENT PROTECTED lighting since 1895 Remote and Wall Control Features INFRARED REMOTE CONTROLLED INFRALITE® ADJUSTABLE LIGHTING SYSTEM 1 LIGHT SYSTEM RR01203 Typical Side View Typical Top View LUMINAIRE LOW VOLTAGE CABLE 35’ [1067cm] 23° WALL CONTROL (35° Max) & BACK BOX SITE 8’ [244cm] 3.5’ 3’ [107cm] [91cm] INFRALITE® 8' CEILING HEIGHT 8'6" CEILING HEIGHT 9' CEILING HEIGHT Footcandle Performance 11,800 fc 9,600 fc 7,900 fc Footcandle performance calculations are based on lamp manufacturer's published initial lumen ratings. Individual lamps may vary significantly, particularly with age. Footcandle Distribution Data Ceiling Height: 8' Ceiling Height: 8'6" Ceiling Height: 9' THISWork Plane: 3'6" FIXTUREWork Plane: 3'6" IS NOWork Plane: 3'6" LONGER AVAILABLE FOR AN ALTERNATIVE PLEASE SEE MRR-12622 Photometric testing by I.T.L. (Boulder, CO) Performance at a Glance I.T.L. Test No. 53922 90˚ Cone of Light* 75˚ 85000 0o S/MH 0.1 60˚ Ft. FC Dia. 90o S/MH 0.1 4.5 11854.0 0.3 170000 5.0 9602.0 0.4 180o S/MH 0.1 45˚ 5.5 7935.5 0.4 Cone of Light Key 6.0 6668.1 0.4 Ft. Distance from fixture FC 6.5 5681.7 0.5 Footcandles (average) Dia. EFFICIENCY = 70.6% 255000 7.0 4899.0 0.5 Circle of light at 50% of FC 0˚ 15˚ 30˚ * Dia. (in ft.) shown is where FC value is half the FC at nadir. INFRALITE® is a registered trademark of The Kirlin Company. PATENT PROTECTED lighting since 1895 Photometric Performance INFRALITE® 1 LIGHT / 150 WATT INFRARED REMOTE CONTROLLED RR01203 LOW VOLTAGE SYSTEM ADJUSTABLE LIGHTING SYSTEM The lighting system includes both an WALL CONTROL PANEL (INSTALLED IN ROOM WALL) infrared remote control and a flush wall control panel. Either may be conveniently used to accurately adjust direction and light intensity of the single luminaire (one light system). A designated magnetic strip on the wall control panel has been provided for storage of the remote control when not in use. Remote and Wall Control Features: • Redundant full function controls for: - Power - Intensity (dimmer or brighter) - Direction (rotates 360o with tilt up to 35o from either side of nadir. • Convenient one hand operation. • Tactile-membranes and smooth surfaces for easy cleaning. Remote Control (only) Features: • Invisible indrared signal will not interfere with other equipment in the room. • Durable construction to withstand common mishaps (dropped on floor). • Includes loss deterring beeper to REMOTE CONTROL FRONT REMOTE CONTROL BACK remind user to return remote to storage area on wall control panel. Beeper is activated if remote control is not used for, nor returned to wall control panel within 1