There Are Bucket Seats with Armrests for Two Front Passengers, Bucket
Total Page:16
File Type:pdf, Size:1020Kb
03/07/14 21:59:53 31S0X650 0091 Seats Passenger Seating Convertible Second Row Bucket Seats There are bucket seats with armrests for two front passengers, bucket seats with armrests for two passengers in the second row, and a bench seat for three passengers in the third row. For greater cargo capacity, the seats in the second row can be removed, andthebenchseatinthethirdrow can be folded into the floor. 88 Instruments and Controls 03/07/14 22:00:02 31S0X650 0092 Seats The EX and EX-L models have a Manual Seat Adjustments To adjust the bucket seats in the power adjustable driver’s seat. All second row, pull up the lever on the other models have manual driver’s front of the seat bottom. seat adjustments. The front passenger’s seat, and the seats in the second and third rows adjust manually. Make all seat adjustments before you start driving. See pages11- 13 for important safety information and warnings about how to properly position the seats and seat- backs. To adjust the seat forward and backward, pull up on the lever under the seat cushion’s front edge. Move the seat to the desired position, and releasethelever.Trytomovethe seat to make sure it is locked in position. CONTINUED Instruments and Controls 89 03/07/15 11:11:55 31S0X650 0093 Seats Driver’s Seat Manual Height Adjustment HANDLE To change the seat-back angle of the To adjust the seat-back angle of the front seat, pull up on the lever on the third seat, open the tailgate. Pull the On LX model outside of the seat bottom. handle on the back of the seat-back, The height of your driver’s seat is move the seat-back to the desired adjustable. Turn the front dial on the To change the seat-back angle of the position, and release the handle. Let outside of the seat cushion to raise bucket seats in the second row, pull the seat-back latch in the new the front of the seat bottom, and turn forwardontheleverontheoutside position. the rear dial to raise the rear. of the seat-back. Make all adjustments before you start driving. 90 Instruments and Controls 03/07/14 22:00:23 31S0X650 0094 Seats Power Seat Adjustments Raises or lowers the On EX and EX-L models seat. See pages11- 13 for important safety information and warnings about how to properly position the seats and seat- backs. Adjusts the seat- back angle forward The controls for the power or backward. adjustable driver’s seat are on the outside edge of the seat bottom. You can adjust the power seat with the ignition switch in any position. Make all seat adjustments before you start driving. Moves the seat forward and Moving the long horizontal switch backward. adjusts the seat bottom in several directions. The seat bottom adjusts in the direction you move the switch. Moves the front of The short vertical switch adjusts the the seat up or down seat back angle. and the rear of the seat up or down. Instruments and Controls 91 03/07/14 22:00:33 31S0X650 0095 Seats Driver’s Lumbar Support Armrests Head Restraints See page 13 for important safety information and a warning about how to properly position the head restraints. Your vehicle is equipped with head restraints in all seating positions to help protect you and your passengers from whiplash and other injuries. They are most effective when you adjust them so the back of the occupant’s head rests against the On EX and EX-L models An armrest is located on each of the center of the restraint. To change the lumbar support, move frontseatsandoneachsideofthe the lever on the right side of the second row seats. Pivot it down to seat-back forward or backward. use it. When you remove the bucket Keep moving the lever forward or seats in the second row, pivot the backward until you find a suitable armrests up out of the way. position. 92 Instruments and Controls 03/07/14 22:00:41 31S0X650 0096 Seats Third Seat Access RELEASE BUTTON The head restraints adjust for height. You need both hands to adjust the To get into or out of the third row When the seat on the passenger’s restraint. Do not attempt to adjust it seat, walk between the second row side is moved to the center, walk while driving. To raise it, pull upward. seats. through the passenger’s side to get To lower the restraint, push the into or out of the third row seat. release button sideways, and push the restraint down. Instruments and Controls 93 03/07/14 22:00:52 31S0X650 0097 Seats Moving the Second Row Bucket Install the floor covers over the outer Seat floor hooks on the passenger’s side as shown. LOCK RELEASE LEVER The second row bucket seat on the Unlock the seat from the floor by passenger’s side can be moved to the pulling the lock release lever under Make sure the seat is securely center to provide access to the third the seat cushion’s front edge and locked in place before driving. A seat row seat. lifting the rear of the seat. thatisnotlockedinplacecouldfly around and cause injury in a sudden Remove the two floor covers Slide the seat toward the center of stop or crash. between the bucket seats in the the vehicle. second row by carefully prying on Reverse this procedure to move the the back edge of the covers with a Push the back of the seat down over seat back to the outside. flat-tipped screwdriver. the floor hooks. Make sure the seat is securely locked in place. 94 Instruments and Controls 03/07/14 22:01:02 31S0X650 0098 Seats Removing the Bucket Seats in the the seat cushion’s front edge and To reinstall the seat, hook the front Second Row lifting the rear of the seat. of the seat to the floor, then push the back into the locks. Make sure both the front and the back of the seat are securely latched before driving. LOCK RELEASE LEVER Both seats can be removed to give Unhook the front of the seat from more cargo capacity. the floor by pulling it back slightly, then pivoting it upward. To remove a seat: Always remove an unsecured seat Pull up the seat-back angle from the vehicle before driving. A adjustment lever, and fold the seat- seat that is not locked in place could back forward. be thrown about and cause injury in a sudden stop or crash. Unlock the seat from the floor by pulling the lock release lever under Instruments and Controls 95 03/07/14 22:01:13 31S0X650 0099 Seats Folding the Third Row ‘‘Magic Seat’’ RELEASE BUTTON HANDLE To create more cargo space, you can 2.Store the head restraints in the 3. Unlock the seat-back by pulling fold the third row ‘‘Magic Seat’’ into sidecargonet.Toinstalltheside the handle. Push the seat-back the floor recess. cargo net, hook the four loops on forward. To fold the seat: the net to the tabs on the left side panel. 1. Remove the head restraints by pushing the release buttons and Make sure the head restraint legs pulling the restraints out. areinsidethecargonetsotheydo not damage the seat as you fold it. 96 Instruments and Controls 03/07/14 22:01:23 31S0X650 0100 Seats 4. Pull the handle on the back of the Make sure all items in the cargo area seat cushion while you pull the are secured. Loose items can fly entire seat towards you with the forward and cause injury if you have strap. Pivot the seat into the floor to brake hard. See Carrying Cargo recess. Make sure the strap is on page176 . above the seat. HANDLE HANDLE 2. Pull up on the handle on the seat- back, and pull the seat-back upright with the strap. Make sure To return the seat to the upright the seat is securely locked in place. Make sure the center shoulder belt position: is stored in the holder and the outer 3. Reinstall the head restraints. shoulder belts are positioned on each 1. Pull the seat out of the recess by hook whenever the third seat is pulling on the handle and the strap. folded. Pivot the seat forward all the way. Instruments and Controls 97 03/07/14 22:01:34 31S0X650 0101 Seat Heaters In HI, the heater turns off when the Follow these precautions when using seat gets warm, and turns back on the seat heaters: after the seat’s temperature drops. Use the HI setting only to heat the In LO, the heater does not cycle with seats quickly, because it draws temperature change. large amounts of current from the battery. If the engine is left idling for an extended period, do not use the seat heaters, even on the LO setting. It can weaken the battery, causing hard starting. On EX-L model Both front seats are equipped with Because of the sensors for the side seat heaters. The ignition switch airbag system, there is no heater in must be in the ON (II) position to the passenger’s seat-back. use them. The seat heater switch is located on each front door. Push the front of the switch, HI, to rapidly heat up the seat. After the seat reaches a comfortable temperature, select LO by pushing the back of the switch. This will keep the seat warm. 98 Instruments and Controls.