WORKS WITH ALL YOUR SHOES BE COMFORTABLE Simply BE CREATIVE ! LOREM Transform your IPSUM favorite shoes into a pair of Boots with D3Riffs Chaps Then BLING them up with D3RiffsCurabitur Custom leo Jewelry

D3Riffs Chaps are designed to fit like a Fashio Chaps glove right over most shoes. Each pair is individually cut, sewn, and hand crafted by seasoned leather craftsmen right here in the USA! PATENTS PENDING We take pride in our quality COPYRIGHT © 2014 DIAMOND and workmanship. We are DUST DESIGN LLC. ALL RIGHTS confident you will be RESERVED. ALL TEXT, GRAPHICS thrilled with your new AND PHOTOS ARE OWNED BY D3Riffs Chaps DIAMOND DUST DESIGN LLC. . REPRODUCTION, IN PART OR IN WHOLE, IN ANY Try them on once and you FORM WITHOUT EXPRESS won’t want to wear WRITTEN PERMISSION IS anything else! PROHIBITED.

www.D3RIFFS.com www.D3RIFFS.com www.D3RIFFS.com www.D3RIFFS.com FOR THE “RIDER” IN ALL OF US! INSTRUCTIONS Your new chaps are made and designed to fit snugly around the ankle area. You may need to do some adjusting while zipping them up at first. Bringing the chap up your ankle a bit to start zipping then pulling them back down over your shoe helps. There are 3 size shoe straps, in time as your chaps break in and conform to your body, you may not need to wear the straps. If you are wearing jeans, fold your jeans over a bit, this will help prevent your jeans from sticking out or bunching up under the chaps.

INSTALLING YOUR JEWELRY IS EASY

Lay your D3RIFFS Chaps flat. Decide which Jewels you want to wear then determine which grommet holes you need to place

the Jewelry Studs. The “Rifters” attach to 2 studs, placement at

the top front of chap (shown) OR at the bottom front of chap.

The “Side Winders” and “Satisfy Sassy” attach to 3 studs as Common 2 point layout Common 3 point layout shown INSTALLING THE JEWELRY STUD

With our Custom “Side Install the Custom Designed Jewelry Stud in the Winders” line of Jewelry, you corresponding grommet holes desired. Pop the stud can remove just one side of anchor through the back of a grommet hole. Screw the the jewels. Whether you are top of the stud in through the front of the grommet hole. use small hex wrenches (included ) to tighten securely riding a motorcycle or a horse, ** Do not over tighten. Stud will still spin in grommet Install Jewelry Stud in Attach the Lobster claw you can temporarily detach the grommet hole. in it's corresponding jewels on the “inside” of your leg ~Patents Pending~ Jewelry Stud and leave on the “outside” where ATTACHING YOUR JEWELRY it still shows off your “Bling”. We recommend you attach your jewels BEFORE you put When done riding, just simply your Chap on. Lay your jewels out flat on chap , attach it to and easily re-attach your “inside” Jewelry Studs using the Lobster claws located on the jewels and your all ready to go. attachment points of jewels. Make sure Lobster claws are properly closed.

* Side Winders have a middle Concho as attachment Conchos are sometimes Make sure Lobster Claws www.D3RIFFS.com used as center anchor are securely closed. Your point. (shown ) point. D3Riffs Chap is ready!