CD Player / Cassette Deck
Total Page:16
File Type:pdf, Size:1020Kb
D01310420B CD-A580 CD Player / Cassette Deck OWNER’S MANUAL IMPORTANT SAFETY INSTRUCTIONS 10) Protect the power cord from being walked on or pinched par- ticularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 12) Use only with the cart, stand, tripod, bracket, DO NOT REMOVE COVER (OR BACK). NO USER- or table specified by the manufacturer, or SERVICEABLE PARTS INSIDE. REFER SERVICING TO sold with the apparatus. When a cart is QUALIFIED SERVICE PERSONNEL. used, use caution when moving the cart/ apparatus combination to avoid injury from The lightning flash with arrowhead symbol, within an tip-over. < equilateral triangle, is intended to alert the user to the 13) Unplug this apparatus during lightning storms or when unused presence of uninsulated “dangerous voltage” within the for long periods of time. product’s enclosure that may be of sufficient magnitude 14) Refer all servicing to qualified service personnel. Servicing is to constitute a risk of electric shock to persons. required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been The exclamation point within an equilateral triangle is spilled or objects have fallen into the apparatus, the apparatus intended to alert the user to the presence of important B has been exposed to rain or moisture, does not operate normally, operating and maintenance (servicing) instructions in or has been dropped. the literature accompanying the appliance. o The apparatus draws nominal non-operating power from the WARNING: TO PREVENT FIRE OR SHOCK HAZARD, AC outlet with its POWER or STANDBY/ON switch not in the ON DO NOT EXPOSE THIS APPLIANCE TO RAIN OR position. MOISTURE. o The mains plug is used as the disconnect device; the disconnect device shall remain readily operable. o Caution should be taken when using earphones or headphones CAUTION with the product because excessive sound pressure (volume) from earphones or headphones can cause hearing loss. o DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE INSIDE. o IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CAUTION CONTACT THE STORE WHERE YOU PURCHASED THE UNIT FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN o Do not expose this apparatus to drips or splashes. REPAIRED. o Do not place any objects filled with liquids, such as vases, on o USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF the apparatus. PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT o Do not install this apparatus in a confined space such as a book IN HAZARDOUS RADIATION EXPOSURE. case or similar unit. o The apparatus should be located close enough to the AC outlet IN USA/CANADA, USE ONLY ON 120 V SUPPLY. so that you can easily reach the power cord plug at any time. o If the product uses batteries (including a battery pack or installed batteries), they should not be exposed to sunshine, fire 1) Read these instructions. or excessive heat. 2) Keep these instructions. o CAUTION for products that use replaceable lithium batteries: 3) Heed all warnings. there is danger of explosion if a battery is replaced with an 4) Follow all instructions. incorrect type of battery. Replace only with the same or equiva- lent type. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with Laser information the manufacturer’s instructions. 8) Do not install near any heat sources such as radiators, heat This product contains a semiconductor laser system inside the cabinet registers, stoves, or other apparatus (including amplifiers) that and is classified as a “CLASS 1 LASER PRODUCT”. produce heat. To prevent being exposed to the laser beam, do not try to open the enclosure. 9) Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than Laser: the other. A grounding type plug has two blades and a third Type: EP-C101 grounding prong. The wide blade or the third prong are provided Manufacturer: GUANGDONG EVER BRIGHT GROUP CO.,LTD for your safety. If the provided plug does not fit into your outlet, Laser output: Less than 1 mW on the objective lens consult an electrician for replacement of the obsolete outlet. Wavelength: 790 ±25 nm 2 Model for USA Model for USA This product has been designed and manufactured according to This equipment has been tested and found to comply with the lim- FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the its for a Class B digital device, pursuant to Part 15 of the FCC Rules. Radiation Control for Health and Safety Act of 1968”, and is classified These limits are designed to provide reasonable protection against as class ! laser product. There is not hazardous invisible laser radiation harmful interference in a residential installation. This equipment during operation because invisible laser radiation emitted inside of generates, uses, and can radiate radio frequency energy and, if not this product is completely confined in the protective housings. installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no The label required in this regulation is as follows: guarantee that interference will not occur in a particular installation. For U.S.A. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the equipment and/or the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Model for Europe This product complies with the European Directives request, and the other Commission Regulations. RACK-MOUNTING THE UNIT Use the supplied rackmount screw kit to mount the unit in a standard CAUTION 19-inch rack, as shown in the illustration below. Changes or modifications not expressly approved by the party Remove the feet of the unit before mounting. responsible for compliance could void the user’s authority to oper- ate the equipment. V Precautions concerning batteries Misuse of batteries could cause them to rupture or leak leading to fire, injury or the staining of nearby things. Please read and observe the following precautions carefully. o Be sure to insert the batteries with correct positive (¥) and nega- tive (^) orientations. o Use batteries of the same type. Never use different types of batter- ATTENTION ies together. o Leave 1U of space above the unit for ventilation. o If the remote control is not used for a long time (more than a month), remove the batteries to prevent them from leaking. o Allow at least 10 cm (4 in) at the rear of the unit for ventilation. o If the batteries leak, wipe away the leakage inside the battery com- partment and replace the batteries with new ones. o Do not use batteries of types other than those specified. Do not mix new batteries with old ones or use different types of batteries together. Model for Canada o Do not heat or disassemble batteries. Never throw batteries into Industry Canada’s Compliance Statement: fire or water. This Class B digital apparatus complies with Canadian ICES-003. o Do not carry or store batteries with other metallic objects. The bat- CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA teries could short circuit, leak or explode. NORME NMB-003 DU CANADA o Never recharge a battery unless it is confirmed to be a recharge- able type. 3 Trademarks and copyrights For European Customers Disposal of electrical and electronic equipment and TASCAM is a trademark of TEAC Corporation, registered in the U.S. and batteries and/or accumulators other countries. a) All electrical/electronic equipment and waste batteries/accu- mulators should be disposed of separately from the municipal Supply of this product does not convey a license nor imply any right waste stream via collection facilities designated by the govern- to distribute MPEG Layer-3 compliant content created with this prod- ment or local authorities. uct in revenue-generating broadcast systems (terrestrial, satellite, cable and/or other distribution channels), streaming applications (via b) By disposing of electrical/electronic equipment and waste Internet, intranets and/or other networks), other content distribution batteries/accumulators correctly, you will help save valuable systems (pay-audio or audio-on-demand applications and the like) or resources and prevent any potential negative effects on human on physical media (compact discs, digital versatile discs, semiconduc- health and the environment. tor chips, hard drives, memory cards and the like). c) Improper disposal of waste electrical/electronic equipment An independent license for such use is required. For details, please and batteries/accumulators can have serious effects on the visit http://mp3licensing.com. environment and human health because of the presence of hazardous substances in the equipment. MPEG Layer-3 audio coding technology is licensed from Fraunhofer IIS d) The Waste Electrical and Electronic Equipment (WEEE) and Thomson. symbols, which show wheeled bins that have been crossed out, indicate that electrical/electronic equip- ment and batteries/accumulators must be collected Other company names, product names and logos in this document and disposed of separately from household waste. are the trademarks or registered trademarks of their respective owners.