Quick Guide Laser Retro Blaster CDBB-166
Total Page:16
File Type:pdf, Size:1020Kb
Quick Guide Laser Retro Blaster CDBB-166 (optional) TIP Unplug power cable if using batteries Power ON/STANDBY TIMER (works in any mode) 4 Equalizer 2 Switch function: Radio, CD, USB, BLUETOOTH, AUX 1 SETTING CLOCK While device in STANDBY tap to select CLOCK OK after adjusting 2 Switch between 24/12HR, HOURS Use to adjust value and MINUTES on screen After adjusting MINUTES press again to SAVE CLOCK 2 CD PLAYER 2 insert CD TIP Supports Data CD Tap here Tap to select CD 2 Change between: Stop Play/Pause - Repeat 1 - Repeat All CD - Random - OFF CONTROLS 4 Skip Volume +/- For Data CD (only) Forward/Backwards - Change folder HOLD to Fast Forward/Rewind USB PLAYBACK Insert USB 3 FAT32 Tap to 32GB select USB exFAT NTFS USB CONTROLS 2 Change between: Stop Play/Pause - Repeat 1 - Repeat All - Random - OFF 4 Skip Volume +/- Change folder Forward/Backwards HOLD to Fast Forward/Rewind 4 BLUETOOTH Tap to select Bluetooth BLUETOOTH CONTROLS 1 Play/Pause TIP Adjust volume on your smartphone/connected device also 2 3 Skip Volume +/- Forward/Backwards 5 AUX 3.5mm AUX cable required (not included) TIP All controls Tap to (except volume) select AUX via connected device only 6 RADIO Tap to select RADIO TIP Only FM stations available Tap to advance station by 0.05Mhz or HOLD to skip to next available 1 3 Tap to select Tap to SAVE station to MEMORY selected MEMORY position SAVING RADIO STATIONS 2 4 Tap to select MEMORY Tap to switch between position (20 available) SAVED stations TIMER 7 SLEEP TIMER 2 After selecting 1 desired time Tap to leave approx set timer in 3 seconds to SAVE 10min increments ON/OFF TIMER (Alarm) Press and HOLD while device in STANDBY 1 2 Use to adjust OK after adjusting Switch between value on screen HOURS and MINUTES 1 Adjust VOLUME 2 OK after adjusting continued on next page... 2 OK after adjusting 1 OK after adjusting Use to adjust 1 value on screen Tap to set desired ALARM source Switch between HOURS and MINUTES e.g. CD, FM or USB 2 3 Save OFF TIMER RECORD TO USB Insert USB 2 Tap to start 8 RECORDING 1 Tap to select function to RECORD from CD, FM, BT or AUX FAT32 32GB When recording from CD tap REC to swap between RECORD 1 TRACK Tap to STOP anytime or RECORD ALL to FINISH or let CD exFAT playthrough ALL to NTFS STOP automatically TROUBLESHOOTING USB drive not working or No Power: Radio not clear: files not playing from USB: 1. Check power cable is connected properly and 1. Change speaker location 1. Check USB drive is formatted tap power button to turn on. If there is rd light 2. Isolate from other devices as this may be to FAT32 file system next to power button then it means device is caused by interference from other devices 2. Make sure only using MP3 files still in STANDBY copied to the USB drive 2. If using batteries make sure power cable is not connected For more LASER helpful guides www.youtube.com/LasercoAu visit us at WARRANTY Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. www.laserco.com.au.