S03869 - BAND-IT Center Punch Tool Manual

Operating S03869 - BAND-IT Center Punch Tool Manual

1. Tool is designed specifically for 3/8” and 5/8” 2. Start “pumping” ratchet wrench forward until proper center punch clamps only . Insert clamp in tool and tension has been applied. then insert wrench assembly. If you prefer, install wrench assembly before clamp is inserted. Slot must be aligned with clamp tail.

3. Place punch on clamp and while holding 4. While holding tension with wrench, pivot tool up tension with ratchet wrench, lock clamp by striking against buckle, then backward several times to punch once or more with hammer, depending on break off clamp tail. object being clamped.

5. To loosen clamp tail, wind ratchet wrench until tail is free. Remove ratchet wrench assembly and clamp tail. Caution: Clamp tail may spring back once released from tool nose.

BAND-IT-IDEX, Inc. Document # PO6788 rev. D A Unit of IDEX Corporation www.BAND-IT-IDEX.com © Copyright 4799 Dahlia Street BAND-IT-IDEX, Inc. 2006 Denver, CO 80216-3070 USA All rights reserved P: 1-800-525-0758 Page 1 of 2 F: 1-800-624-3925 Repair Parts List & S03869 - BAND-IT Warranty Center Punch Tool

1 2

REPAIR PARTS LIST – S038 CENTER PUNCH TOOL

ITEM PART DESCRIPTION NUMBER NUMBER 1 J02786* WINDING MANDREL ASSEMBLY

2 S20288 PUNCH HOLDER ASSEMBLY

*REPAIR PARTS MAY APPEAR DIFFERENT THAN ILLUSTRATED .

Refer to website for warranty information: http://www.band-it-idex.com/warranty.html