100% Compatible with TESAS Electromechanical Products, and 100% Compatible with TESAS Armoured Doors in Order to Ensure Active and Passive Security and Safety
Total Page:16
File Type:pdf, Size:1020Kb
AUTOPROGRAMMABLE ACCESS CONTROL LOCKS ACCESS CONTROL FOR EACH AND EVERYONE TESA is launching its new access control, which employs neither software nor management systems. Its product range is simple, wireless and completely autonomous. A CUSTOMIZED SOLUTION TESA is launching its new access control, which employs neither software nor management systems. Its product range is simple, wireless and completely autonomous. WE CAN LOCK EVERYTHING From a gate with a TITANIUM security padlock to a glass door with a knob from the ACCESS range. Plus ironwork doors, firebreak doors, etc. SIMPLICITY ABOVE ALL As long as you have a programming key/card and user 1 2 credentials, you can start the system. In a few minutes you will have an access control installed in your door. 3 TOTAL COMPATIBILITY 100% compatible with TESAs electromechanical products, and 100% compatible with TESAs armoured doors in order to ensure active and passive security and safety. GUARANTEED BY TESA To buy TESA is to buy quality. The use of the most advanced technology, our experienced staff and a management system certified by the ISO 9001 quality standard, the ISO 14001 environmental standard and the security and hazard prevention standard are proof of our commitment with constant innovation and growth. PROXIMITY LOCK PROXIMITY READER PAG.5 PAG.12 ELECTRONIC CYLINDER ELECTRONIC KEY PAG.18 PAG.20 TITANIUM PADLOCK ACCESS KNOB PAG.21 PAG.22 IDENTIFICATION TECHNOLOGY 13.56 MHz RFID contactless CHIP technology » Higher capacity and data protection » The absence of contact between the CHIP and » High transmission speed the reader allows for a higher durability and a low maintenance cost. » Security: information is encrypted. » Multiple applications: POS, vending, consumer loyalty schemes, etc. Credentials » The identification item can be a card, a key ring, a bracelet, a watch, etc. » It can integrate with other technologies support formats: magnetic stripe cards, 125 kHz proximity, contact CHIP, etc. » Highly resistant to outdoors conditions, tampering, water, dust, extreme temperatures. Design for technology: no SOFTWARE required » No software required. » The AutoProgrammable management kit, which includes a programming kit and 25 user cards, is enough to have the program started. » A battery KIT allows to supply the lock with power every time it runs out of batteries. 1 2 3 IDENTIFICATION TECHNOLOGY Design and functionality » Its narrow design allows for installation in all kinds of doors. » Optional integration of a variety of handles and mortise locks. » Two lock models: long plate, and a model with a separate reader and a handle. SecurityDiseño y andfuncionalidad comfort » Wireless installation. Power supply: standard batteries. » All control elements (except the reader module) are located in the inside, for a higher anti-tampering security. » In case the lock doesnt open, the external handle spins free in order to avoid the risk of being forced open. » It can integrate an European profile-type mechanical cylinder for mechanical openings. 6 TECHNICAL FEATURES Models Long plate models. Short plate models. External side. External side. Long plate Visible cylinder Hidden cylinder Short plate Functions Models with electronic privacy: (the Models without electronic privacy: (the internal side is always the same in both internal side is always the same in both the long plate and short plate models). the long plate and short plate models). Internal deadbolt Neither cylinder nor External cylinder internal deadbolt Internal deadbolt and external Cylinder with an Cylinder with an internal cylinder internal button button and an external key Handles Vector Sena Xara Zafira Pomo 7 TECHNICAL FEATURES Resistance Finishes Standard: for internal doors. Iron clutch. No sealing joints. Extreme: for external doors subject to extreme conditions. Stainless steel clutch. Sealing joints. Stainless Matt brass PVD Polished brass PVD Black paint Operation conditions Packaging Up to 85% without condensation » Supplied in one1/1 single box including Humidity and External side -20ºC - 70ºC handles, screws, batteries and the template temperature for installation. Internal side -0ºC - 50ºC » The mortise lock and the cylinder are not Fireproof certificate: 30', 60' y 90' included. Fire UNE - EN 2634: 2000 Factory settings » Locks are supplied in their factory settings, with factory cards, for an easy installation. » Before the system is programmed, these cards will open every lock. 8 TECHNICAL FEATURES Mechanical and Electronic LONG PLATE SHORT PLATE NUECA DE 8 CON GIRO MAX DE 42º SIN PREGIRO External cover side 40,5 X 281 X 10 mm 40,5 X 281 X 10 mm Covers Internal cover side 40,5 X 281 X 21 mm Internal cover side Stainless steel Compatible with standard European mortise locks with a distance between Mortise shafts from 70mm to 105mm, as long as the size of the locks follower rod Locks 70/72/85/92/105 MAX 140 is 8 or 9mm, with a maximum turning capacity of 42º and no previous spin. Width of the For doors with a thickness between 33m and 110 mm. The locks squares door (telescopic) have different sizes depending on their thickness. X and Y sizes must be supplied. 13.56 Mhz (Smartair) reading and writing Identification technology contactless chip. ISO 14443A Phillips Mifare Classic 1K, 4K Reader module Reading distance 10 mm with standard credentials The jack that connects with the emergency power supply is located in the reader module YX Non-volatile memory INTERNAL EXTERNAL Control Number of users limited to 500 Unit Warning LED red and green Type of batteries 3 1,5 V alkaline batteries (LR03 AAA type) Battery module Estimated duration 20,000 operations, or 2-3 years Standby consumption 40 µA 9 COMPATIBILITY OF TESAS PRODUCTS Mortise Locks The Smartair electronic lock is compatible with a wide range of TESAs mortise locks here are a few examples: Standards doors: Wood 2UB0 Series (to be used with a cylinder) and 2UB0 (to be used with a deadbolt) » Silent, reversible latch with 17mm projection. » Exit panic function. » Distance between shafts: 85 mm. » 50, 60 and 70 mm backsets » Ask for other options. 2UB4 2UB0 Standards doors: Ironwork Serie 2215 » Just the latch, for passage doors. » Stainless steel fronts. » Distance between shafts: 85 mm. » 30mm and 35mm backsets. » Ask for other options. 2215 10 Security doors: Wood TPB3 Series (locking point by bolts)/ TPG3 (high and low locking point by hooks) » When spinning the handles upwards, the locking points are projected. » Exit panic function. » Anticard device. » 60mm backset. 25 149 20 149 120 120 73 73 280 20 TPB3 596 120 73 12 12 196 238 238 26 26 20 20 60 60 246 20 120 646 73 280 20 25 120 120 TPG3 73 73 161 161 11 WALL READER The reader activates the locking element with a relay: electric strike, electromagnetic/motorized lock, etc. 12Vac/Vdc external power supply required. CN1 12Vac/Vdc power supply Standby consumption 80 uA CN2 Connectors Consumption with operating relay: 150 mA Relay backset: NO, NC and C. CN3 Cut capacity: 5A 250Vac/5A 30Vdc CLR RESET button for the erasing of the readers memory Humidity Up to 85% without condensation Operation Temperature -10ºC - 80ºC conditions Noises of the electric strike: we recommend installing the VARISTOR (which is included in the package) in the electric strike in order to absorb the noises it may produce. ALTERNATING CURRENT ONLY PackagingDiseño y funcionalidad Supplied in one 1/1 single box with screws, the Varistor, the transformer and the installation templates. Factory Settings Once it has been connected to the power supply, and before it has been programmed with the programming card, the reader will remain in its factory settings and will be open with factory cards. Installation Typical diagram of the connection to an electric strike: POWER SUPPLY 12V AC/DC + - CLR BUTTON 12 - 24 DC/AC A B NC NO C 12 MOUNTINGCOMPATIBILIDAD DIAGRAM DE PRODUCTOS TESA 1. The readers holding plate. 2. Screws for the holding plate. 3. Wall reader. 4. TORX security screws for fixing the reader to the holding plate. 5. Cable connecting the reader to the relay plate. 6. Relay plate. 7. Built-in electric case (not supplied) 2 2 1 1 J1 7 R terminal ~15 ~17 6 5 1 2 3 1-ROSA-PINK-ROSE 2-GRIS-GREY-GRIS 3-AMARILLO-YELLOW-JEUNE 4-VERDE-GREEN-VERD 4 5-MARRON-BROWN-MARRON 6-BLANCO-WHITE-BLANC 13 COMPATIBILITY WITH TESA PRODUCTS Standard doors TESAs wall readers can activate/deactivate any electromechanical device by means of a relay. TESA brings you a wide variety of solutions. Electric Strike Applications: main doors, offices, corridors, small warehouses in which a low security level is required. Fail secure (access is blocked in case of powercut). Alternating current12V/0,6A CERNORCIN NORMAL - opens with thrust AUTOMATIC it stays open when receiving the CERAUTCIN electric thrust CERNODCIN NORMAL + unblocking lever CERAUDCIN AUTOMATIC + unblocking lever Electromagnetic Strikes Applications: archive rooms, labs, CCTV monitor rooms, distributors of electric and telephonic installations, exit ways, etc., demanding high security levels. Power supply: 12Vcc/500 mA, or 24Vcc/250mA Fail safe (free access in case of powercut) CEM300SS0F Rim model holding force: 300 kg CEM600SS0F Rim model holding force: 600 kg CEM750SS0F Mortise model holding force: 750 kg CEM150SS0F Mortise model holding force: 1500 kg Security doors Applications requiring a high security level Electromechanical locks SOLENOIDE TEL500 SERIES The electric signal activates the external handle and allows the opening. Aplicaciones: internal doors of public buildings, companies, panic exit ways, indoors premises, staircases, lifts, garages, warehouses, etc. Models available for wooden doors and ironwork profiles. Security: both fail safe and secure (optional). 14 COMPATIBILITY WITH TESA PRODUCTS Security Doors Security doors: TEL600 Series An engine removes the lever from the lock and the latch is unblocked. Applications: doors with a high turnover, high security accesses (without an external handle).