Bandsaw Jointer

• Adjust height first • Check cutter guard first • Use push sticks near blade • Must be 1 0" or longer • Make slow, quiet cuts • Use concave side down ∩ • You must use a spotter • You must use a spotter

Planer Table Saw

• Must be 1 2" or longer • Adjust blade height first • Clean/concave side down - ∩ • Use fence OR mitre gauge • Wide: 1 /4, narrow: 1 /2 turn • <3" near blade: push sticks • You must use a spotter • You must use a spotter

Mitre Saw Router

• <6" near blade: use clamp • Adjust bit height/fences first • Hold tightly against fence • Feed against the bit rotation • Full speed – drop – stop – lift • Let bit stop before cleaning • You must use a spotter • You must use a spotter Stationary Sander Scroll Saw

• Turn on dust collection first • Secure hair/clothing/jewelry • Secure hair/clothing/jewelry • Check for knots, staples, etc. • Hold workpiece firmly • Hold down firmly onto table • Sand at bottom of rotation • Fingers on either side of blade

Drill Press Biscuit Joiner

• Secure hair/clothing/jewelry • Secure hair/clothing/jewelry • Use a vise or clamp to table • Clamp work to workbench • Set table height & depth stop • Unfold fence & check height • Remove chuck key • Check biscuit setting

Circular Saw Wood Lathe

• Clamp wood to workbench • Secure hair/clothing/jewelry • Adjust blade height • Rough cut first on bandsaw • Watch out underneath! • Examine for cracks and flaws • You must use a spotter • Secure FIRMLY to lathe