Spriggan.Pdf

SPRIGGAN

Start with a square coloured side up.

1 2 3

Fold and unfold the square in half Fold and unfold the edges to the Fold and unfold between the lengthwise. middle crease. Then turn over left to creases made previously. Then right. turn over left to right.

4 5 6

(2-3)

Repeat steps 2 to 3 on the Fold and unfold diagonally along Fold and unfold diagonal folds on other axis. the middle. Then turn the model either side. over left to right.

© 2010 - 2017 SQUARE ENIX CO., LTD. All Rights Reserved. NOT FOR SALE. STORMBLOOD, HEAVENSWARD and A REALM REBORN are registered trademarks or trademarks of Square Enix Co., Ltd. FINAL FANTASY, FINAL FANTASY XIV, FFXIV, SQUARE ENIX and the SQUARE ENIX logo are registered trademarks or trademarks of Square Enix Holdings Co., Ltd. Diagrams © 2017 Creaselightning Limited www.creaselightning.co.uk 7 8 9

Fold the lower edge up and at the Fold the upper layer over to the left. Fold and unfold the outer edge same time fold in the sides. in along the third vertical crease.

10 11 12 (b)

(a)

Fold the upper layer down causing Fold the layers in the upper section Fold the section over along the the right side to fold in. back. At the same time reverse fold diagonal at (a) and fold the triangle up the lower corner. to the left. This will cause the outer edge (b) to fold in.

13 14 15

(8-14)

(a)

Fold the lower corner up at (a), Fold the corner back. Repeat steps 8 to 14 on the separate the layers and open the other side. Make sure the point. corner reversed in step 11 is folded correctly 16 17 18

Fold and unfold along the third Fold out all layers above the edge Fold in progress, showing the upper crease. of the lower triangle. This will open section folding down and opening the section and cause the upper out. edge to fold down.

Fold the lower section back up Fold the upper edge down and open Fold the points up. and open out the sides. out the paper on either side.

22 23 24

Fold the lower corners up. Fold the lower corner up. The corner should lie above the crease Fold the corners down again. about 2/5ths of the corner.

25 26 27

Fold and unfold the corner Fold the outer corner over, at the Fold the corner in. If the adjacent same time reverse fold the edge layers prevent this check the corner inside. reversed in step 11. 28 29 30

(25-27)

Repeat steps 25 to 27 on the other Fold the upper layer over to the Fold the upper edge back over and side. right. open the point. © 2010 - 2017 SQUARE ENIX CO., LTD. All Rights Reserved. NOT FOR SALE. STORMBLOOD, HEAVENSWARD and A REALM REBORN are registered trademarks or trademarks of Square Enix Co., Ltd. FINAL FANTASY, FINAL FANTASY XIV, FFXIV, SQUARE ENIX and the SQUARE ENIX logo are registered trademarks or trademarks of Square Enix Holdings Co., Ltd. Diagrams © 2017 Creaselightning Limited www.creaselightning.co.uk 31 32 33

(29-32)

Fold and unfold the outer edge to Fold and unfold diagonally. Repeat steps 29 to 32 on the other the middle. side. 34 35 36

Fold the point up to the right, this Fold the lower point up to the Fold the point back again will cause the edge of the lower left. This will cause the edge to point to open out. fold in narrowing the point. 37 38 39

(34 -37)

Hold the lower point and slide it to Repeat steps 34 to 37 on the other Reverse fold the tip of the point. the right. side.

40 41 42

Reverse fold the tip again. Repeat on the Fold the sides in to shape the head Complete. other point then turnover. and ears. © 2010 - 2017 SQUARE ENIX CO., LTD. All Rights Reserved. NOT FOR SALE. STORMBLOOD, HEAVENSWARD and A REALM REBORN are registered trademarks or trademarks of Square Enix Co., Ltd. FINAL FANTASY, FINAL FANTASY XIV, FFXIV, SQUARE ENIX and the SQUARE ENIX logo are registered trademarks or trademarks of Square Enix Holdings Co., Ltd. Diagrams © 2017 Creaselightning Limited www.creaselightning.co.uk SPRIGGAN’S ROCK

1 2 3 4

Fold a rectangle in half. Fold the upper Fold the lower section Fold in the lower section down. back up again. corners.

5 6 5 6

Fold the upper edge Fold in the upper Crease the model along Complete. over. corners. the middle then turn the model over. ASSEMBLY

Insert Spriggan’s arm Fold the Rock along the middle Complete. in between the layers and fold the feet to face forward of the rock. to enable the model to stand.