Flexible Bumper Paint Stripper
Total Page:16
File Type:pdf, Size:1020Kb
Bulldog® Page 1 of 2 Spot refinishing Plastic Bumper Metal Fender View Label (English/Español) View MSDS Flexible Bumper Paint Stripper A fast acting remover designed to strip paint from flexible automotive parts such as urethane bumpers. It removes the toughest factory finishes, even two-part epoxies. When used according to directions, Bulldog Stripper will not attack urethanes. This heavy bodied formula clings to vertical surfaces without running or dripping. Product Number / Size EUP367 - 18 oz. Aerosol Directions for use PREPARATION: Carefully read all cautions and instructions before use. Protect hands with solvent-resistant gloves and eyes with safety glasses. Apply this product to a small area (up to 3’ X 3’) because the fire and health safety risks will increase dramatically when used over larger areas. For best results, apply when both surface and air temperatures are between 65°F–90°F and avoid direct sunlight and strong breezes. Mask off areas not to be stripped and crevices where residual paint stripper may enter and be difficult to wash away. Protect surrounding area from overspray with polyethylene drop cloth. For faster paint removal abrade the painted surface slightly with an abrasive pad or fine sand paper. IMPORTANT: This product is not intended to remove color mixed into plastic prior to molding. Repeated applications of this product in an attempt to remove the OEM baked finish can cause swelling and distortion of the urethane part. Test a inconspicuous area before proceeding with the entire job. Do not use this product on rigid plastics. APPLICATION: http://www.wmbarr.com/product.aspx?catid=1&prodid=45 5/21/2008 Bulldog® Page 2 of 2 squeegee, stripping tool or rags. Stripper left on urethane surface for an extended period of time can cause damage to some types of urethanes. Immediately after removing paint, neutralize area by flushing with water. Dry surface with a clean, oil free cloth and let the surface dry thoroughly (at least 12 hours) before applying new finish. NOTE: Some older urethane parts may swell during application, but will return to original contour within 24 hours.Do not apply new finish until swelling has gone down. Related Items Adhesion Promoter Aerosol Promotes paint adhesion Abrasive Cleaner Cleans and scuffs bumpers and other plastics. © Copyright 2007 W.M. Barr & Co., Memphis TN | P.O. Box 1879 Memphis, TN 38103 | 1-800-238-2672 http://www.wmbarr.com/product.aspx?catid=1&prodid=45 5/21/2008.