Electrical Technology Tool List Hays Campus 2019-2020
Total Page:16
File Type:pdf, Size:1020Kb
Electrical Technology Tool List Hays Campus 2019-2020 Following are the required tools for the Electrical Technology program. These tools can be purchased from the vendor of your choice. All tools are to be of the finest quality. Tools will be inspected prior to being used in the department. The department reserves the right to refuse the use of worn or defective tools or tools which do not conform to the specifications of this list and the department chairperson. Required Tools and Equipment High Leverage Diagonal Cutting Pliers – Angled Head Wire Striper 10-18 AWG Solid & 12-20 AWG Stranded Utility knife Cable splicer kit 120’ Fish Tape Safety Glasses High Leverage cable cutter Conduit-fitting and Reaming screwdriver 12 piece Hex-Key Set Standard Long nose pliers Heavy duty long nose pliers – side-cutting & stripping 8” adjustable wrench 12” adjustable wrench ¼” stubby screwdriver –flat ¼” – 4”square shank screwdriver – flat 3/16” – 3” round shank screwdriver – flat 3/16” – 6” round shank screwdriver – flat 5/16” – 6” round shank screwdriver – flat #2 Phillip’s screwdriver – stubby #1 Phillip’s – 3” round shank #2 Phillip’s – wire bending 4” round shank 1/4” 6” round shank screwdriver – flat 7 piece nut driver set (3/16”, ¼”, 5/16”, 11/32”, 3/8”, 7/16”, ½”) Scratch awl No.2 square-recess tip screwdriver – round shank 3/16” rapi-drive screwdriver 25’ tape measure Crimping tool Dual NM cable stripper/cutter High leverage side-cutting pliers – fish tape pulling 18 oz hammer Fuse puller Tap tool Electrician’s knife Hacksaw Revised 4-9-19 3/8” – 1” flat bore bits Lockout Hasp/tag Electrical tape Hard hat ½” EMT bender Non-contact Volt sensor Auto ranging DMM – True RMS Clamp Meter Tool pouch or bag Fuse for DMM (2) BX & AC cutter with extra blades 49/60 rosin core solder Drill bit set Flashlight Pad lock Small file Pocket Phillip’s Soldering pencil Wallboard saw Cordless tool set (optional) Receptacle tester Estimated Cost: $1200.00 - $1300.00 Note: Estimated costs reflect current market value and are subject to change. Vendor Information: Tool vendors will be available during Orientation and Tool Days on campus. Tools may be purchased from Boettcher Supply, Stanion Wholesale Electric, Western Extralite or the supplier of student choice. Please contact the Department Chair with questions or for further information. Revised 4-9-19 .