“BULB” SHAPED ASTRAGAL Tools Needed: Two
Total Page:16
File Type:pdf, Size:1020Kb
INSTALLATION INSTRUCTIONS Install the New Weather Seal FOR “BULB” SHAPED ASTRAGAL Step 3 Make a bulb shape from the flat strip of weather seal by curling Tools Needed: the ends together. The top of the bulb will resemble a “T”. See Fig 2 Two “C” Clamps or Vise Grips Finished Bulb Shape *Since garage doors are manufactured with varying types of weather seal retainer designs, please contact Clopay for the proper FLAT STRIP OF WEATHER SEAL Hold type of replacement weather seal. ends together. T-shape The weather seal provides a seal at the bottom of your garage door. This weather seal will fit on bulb-shaped (“O”) retainers. See below. End End Curl up ends to form a bulb shape STEEL PAN DOOR Inside Door Fig 2 Outside Weather Seal Weather seal retainer Driveway Floor Step 4 Insert “T” shape into retainer slot. See Fig 3. Slide the weather seal across the length of the door. NOTE: The weather seal will slide through the retainer slot easier if soapy water is applied. WARNING If your door is connected to an automatic opener, be sure to disengage the opener Door before beginning work. Step 1 Raise door to open Weather seal position. Place “C” clamps in both tracks directly below the Weather seal door and tighten. See Fig 1. Retainer Step 2 Remove old weather seal from bottom of the door “C” Clamp Step 5 Cut off excess weather seal flush leaving two extra inches from section. It may be necessary to remove screws holding the edge of door. Tuck extra weather seal into itself to allow for future Fig 1 weather seal to retainer . shrinkage. If any screws were removed, replace now. INSTRUCTIONS FOR P/N 0620131 BULB ASTRAGAL INSTALLATION INSTRUCTIONS WARNING FOR “U” SHAPED ASTRAGAL If your door is connected to an automatic opener, be sure to disengage the opener Tools Needed: before beginning work. Two “C” Clamps or Vise Grips *Since garage doors are manufactured with varying types of Step 1 Raise door to open weather seal retainer designs, please contact Clopay for the proper position. Place “C” clamps in type of replacement weather seal. both tracks directly below the door and tighten. See Fig 1. This weather seal will fit on U-shaped retainers. See below. The weather seal provides a seal at the bottom of your garage door. Step 2 Remove old weather Note: For non level floor surfaces, special weather seal may be “C” Clamp seal from bottom of the door available. For additional information, contact Clopay Consumer section. It may be necessary to Services at 800-225-6729. remove screws holding Fig 1 weather seal to retainer . STEEL SANDWICH DOOR Inside Outside Door Step 3 Install new weather seal by inserting the “T” shaped edges into their respective slots in the retainer. (See Fig 2) Now slide the weather Weather Seal Retainer seal across the length of the door. (If screws were removed, replace at this time) Weather Seal Floor Driveway Door STEEL PAN DOOR Inside Weather Seal Door Outside Weather Seal Retainer Weather Seal Retainer Weather Seal Driveway Floor Step 4 Cut off excess weather seal flush leaving two extra inches from the edge of door. Tuck extra weather seal into itself to allow for future shrinkage. If any screws were removed, replace now. INSTRUCTIONS FOR P/N 0620100 ”U” ASTRAGAL .