Submittal Checklist for Patio/ Covers and

The purpose of this guide is to assist you in the permit process for most attached patio/deck covers and carports. It does not cover all circumstances. Depending on the scope and complexity of your project, additional detailed plans may be required.

This checklist is to be completed by the permit applicant to assure a complete submittal. The permit technician will also use the checklist to confirm a complete submittal. If the submittal is incomplete, it will not be accepted and the permit applicant will be asked to retain all documentation until their submittal is complete.

NECESSARY DRAWINGS: provide 2 copies of the proper documents. A survey - A Survey is a drawing document prepared by a land surveyor. The survey that is submitted with your application must accurately depict the conditions of the property existing at the time of application submission, including the location of the proposed patio/deck cover or clearly marked on it. plans - Show an enlarged floor area, with dimensions and measurements, of the new patio cover. Framing Plan – If applicable, show how the new roof ties into the old. The new roof shall not attach to or non-masonry veneers. Show attachment/connection details (bolts, etc...) Exterior Elevation - Show what each side of the patio cover will look like after adding the patio cover. Include dimensions and measurements for overall length, height, and width. Construction Details - Include all framing, spans, spacing and section. Patio cover shall not be anchored or attached to brick or siding (non-masonry veneers). Plans - Show how posts or supporting patio cover will be anchored to the ground. When applicable, show footing depths, foundation slab changes, etc... Electrical Plans - Show any electrical work to be installed under the patio cover. For example: Fans and switches or additional outlets.

CONSTRUCTION MATERIALS NOTES 1. All lumber, plywood, 058, etc. must conform to applicable standard under which it was graded and must be so identified by grade mark (stamp). All lumber must be graded at SPF #2 or better. Plywood must be structural or C-D grade minimum, with exterior grade glue with grade stamp. Structural members shall not be cut, notched or bored in any manner. 2. All beams, headers, rafters, joists, etc. (see Patio Cover diagram for explanation of terms) must be set with the warped side of the board (crown side) up. 3. Posts/columns must be supported by piers or metal pedestals that project at least 6-inches above exposed ground and at least 1-inch above concrete slab that entirely surrounds and adjoins the post . 4. All bolts must be a minimum 6-inch diameter, unless noted otherwise, each bolt must have a nut and a standard cut washer, both the head and nut, holes for bolts must be bored/drilled 1/32-inch to 1/16-inch larger than the diameter of the bolt. Lag screws must have a standard cut washer under the head and must be installed in holes you have pre-drilled approximately 75% as thick as the lag screws being inserted. 5. All framing hardware and connectors (straps, joist hangers, post caps, column bases, etc.) must be Simpson Strong-Tie (brand name example) or equal. 6. All bolts, screws, hardware, etc. must be corrosion-resistant such as hot dipped or galvanized. 7. All lumber exposed to the exterior shall be weather protected with an approved exterior paint, equivalent sealant, or treated lumber. 8. Roofing must be installed according to the manufacturer's installation instructions, including which materials are used and how to install those materials in a low slope application.