Conservation of Matter/Mass

Total Page:16

File Type:pdf, Size:1020Kb

Conservation of Matter/Mass

Conservation of Matter/Mass

Matter cannot be created or destroyed by a chemical change. This very important principle is known as the Law of Conservation of matter. This law applies to ordinary chemical reactions (as opposed to nuclear reactions, where matter may be changed to energy). During a chemical change, the atoms of one or more substances simply undergo some rearrangements. The result of these rearrangements is the formation of new, different substances. All of the original atoms are still present. It is because of the Law of Conservation of Matter that we are able to write balanced chemical equations. Such equations make it possible to predict the masses of reactants and products that will be involved in a chemical reaction. In this experiment, aqueous solutions of three different compounds will be used to produces two separated and distinct chemical reactions. The fact that change occurs during each reaction will be readily observable. The combined masses of the three solutions (and their containers will be measured before and after each reaction has occurred. This experiment should give you a better understanding of the Law of Conservation of Matter and its importance in chemistry.

Purpose: to determine experimentally if mass is conserved in a particular set of chemical reactions.

Procedure:

1. In a graduated cylinder measure exactly 10.0mL of sodium carbonate(Na2CO3) solution. Pour into a clean dry 250 mL Erlenmeyer flask. Stopper the flask. Rinse and dry the graduated cylinder. 2. Measure exactly 3.0mL of calcium chloride(CaCl2) solution and pour into a clean, dry test tube. Stopper and label the tube. 3. Rinse and dry the graduated cylinder. 4. Repeat step 2 with 3.0 mL of sulfuric acid (H2SO4)solution. 5. Place the stoppered flask and the test tubes together on the balance. Record the combined mass of these containers, stoppers, and solutions. This will be mass A. in your data table. 6. Remove the flask and the test tube containing calcium chloride. Pour the calcium chloride into the sodium carbonate in the Erlenmeyer flask. Swirl the flask to thoroughly mix the two solutions. 7. Replace the stoppers in their containers and remass all three containers, even the empty one. Record as mass B in data table. 8. Remove the flask and test tube containing sulfuric acid and carefully pour into the flask. Leave the flask unstoppered. Feel the bottom of the flask while you are swirling. Once all the bubbling stops, add the stopper 9. remass all three containers, even the empty ones..record as mass C in your data table. 10. Thoroughly clean and rinse the flask Use your test tube brush and plenty of water. Clean both test tubes and rinse with plenty of water. Questions: 1. What indications that a chemical reaction was taking place did you observe in procedure 5? Procedure 8? 2. Why were you instructed to leave the stopper off in step 8? What might have happened if you did not? 3. Compare masses a, b, and c. Account for any differences. 4. In your opinion, does this experiment verify the Law of Conservation of Matter? How might the experiment be improved?

Recommended publications