Throat Activated Microphone with Earphone Unit

THROAT ACTIVATED MICROPHONE WITH EARPHONE UNIT MLE

This product uses an "indirect air borne vibrations" technique to receive vibrational energy (single side only), which is generated on the skin near vocal cords of a human being. It features high isolating capability, not only for environmental noise, but also from frictional vibrating sound generated by the microphone-head. And it is water, dust and corrosion proof.

OPERATION

1) Better transmission will result if the microphone-head is about 5cm away from the throat or vocal cords on the neck. 2) The microphone surface must be firmly attached on your skin or it will not receive the vibrational energy effectively. 3) The neck ring is made from high flexibility stainless steel, you can adjust the curve level to fit your neck. 4) Press PTT key on the PTT box for transmission. 5) Use the PTT output jack on PTT box for connecting the finger PTT switch. 6) When you use the accessory : finger PTT switch. First the magic tape will be rounded on your index finger, then sticks the finger PTT switch on magic tape. 7) Use the multi-directional clamp on the rear of PTT box to attach the PTT box to your belt, collar or the other suitable places. 8) The neck ring can be folded when it is not be used.

1 CAUTIONS

1) The PTT box, finger PTT switch and earphone part are not waterproof.

2) The microphone surface is of thinner construction. Never apply force to it with fingers or pointed objects.

3) If the microphone unit is performing improperly, make sure it is properly connected to the neck. You can adjust it by moving the microphone head until you have a good connection.

4) Tightening or loosing the level of the neck ring will affect the microphone measurement for approximately +/- 20%.

5) Unit X-07, X-07K, X-07M applies to walkie-talkie without voice control circuit or amplifying circuit.

6) Please adjust neck ring which you need before use. Do not adjust it on your neck directly. It can be used to STANDARD, ICOM, YAESU, ALINCO and ADI.

 When you use the X-07M, please make sure the power of MOTOROLA radios is at "OFF" position. After X-07M and MOTOROLA radios connect. Then turn on the power of MOTOROLA radios.